I am reporting a recurring steering safety concern involving my 2023 Acura Integra. My vehicle underwent the steering gearbox safety recall repair (the federal safety agency 24V‑744 / Acura Campaign VJV) in January 2025 under dealership repair order 344890. Despite the completed recall, I continue to experience steering resistance and binding at highway speeds, generally 50 mph and above. When navigating gradual curves, the steering wheel sometimes feels as though it sticks or remains held in position. When attempting to return the wheel toward center or make a small correction in the opposite direction, additional force is required before the steering suddenly releases and moves smoothly again. This makes precise steering corrections unpredictable and presents a potential safety hazard at highway speeds. I initially suspected the lane-keeping assistance system; however, the problem occurs with lane-keeping assistance disabled, while remaining centered in my lane. I do not typically experience the condition at lower speeds. I recall noticing this steering behavior around the time of the January 2025 recall repair. The symptoms closely match the defect addressed by Recall 24V‑744, raising concern that the original remedy did not fully correct the underlying condition or that the defect has recurred. I request that the federal safety agency investigate the possibility of an ineffective or recurring recall remedy and evaluate this complaint alongside similar post-repair steering complaints involving Honda and Acura vehicles covered by Recall 24V‑744.
2023 Acura Integra steering problems
190 complaints (91% of all complaints for this car). 3 crashes reported.
- owner complaints
- 190
- of this car's complaints
- 91%
- crashes
- 3
- recalls
- 1
Which part fails
Owners did not name a specific part.
At what mileage
Complaints by mileage at the time of the problem.
Acura Integra steering problems in other years
Specific symptoms reported on the 2023 Acura Integra steering
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
Steering
- What is wrong
- Honda (American Honda Motor Co.) is recalling certain 2023-2025 Acura Integra, Civic Type R, CR-V Hybrid, CR-V, HR-V, 2022-2025 Civic, Civic Hatchback, 2024-2025 Acura Integra Type S, 2025 CR-V Fuel Cell EV, Civic Hybrid, and Civic Hatchback Hybrid vehicles. The steering gearbox assembly may have been manufactured incorrectly, which can cause excessive internal friction and lead to difficulty steering the vehicle.
- Risk
- Difficulty steering can increase the risk of a crash.
- Remedy
- Dealers will replace the worm gear spring and redistribute or add grease as necessary, free of charge. Owner notification letters were mailed November 18, 2024. Owners may contact Honda Customer Service at 1‑888‑234‑2138. Honda's numbers for this recall are SJS, MJU, QJT and VJV.
Recall number 24V744000 · Recall details
Related investigations
Momentary Increased Steering Effort
On November 29, 2023, the Oï¬ce of Defects Investigation (ODI) opened this Engineering Analysis (EA23003) to assess allegations of momentary increase in steering eï¬ort in model years (MY) 2022-2023 Honda Civic, 2023MY Honda CR-V, and 2023MY Acura Integra vehicles (subject vehicles). The complaints received by ODI alleged that the subject vehicles experienced a momentary increase in required steering eï¬ort (described as âsticky steeringâ) occurring mostly at highway speeds after driving for an extended amount of time; these complaints could not be duplicated during dealer service techniciansâ quick test drives. The complaints had been received over the previous two years with most occurring with low vehicle mileage. The steering gear of these vehicles is aided by an electrical power assist unit. This power assist unit inputs force on the steering rack via a worm gear and worm wheel assembly. During PE23005, Honda stated this condition of momentary increase in steering eï¬ort occurs due to two factors within this power assist unit. First, during manufacturing, the steering worm wheel goes through annealing and component conditioning processes. These processes cause internal stress and strain within the steering worm wheel. This strain is slowly released over the ï¬rst few months of the vehicle life. Over time, the released strain causes deformation of the teeth on the worm wheel, causing the worm gear to catch on the worm wheel. This catching results in the driverâs momentary increased steering eï¬ort. Second, the manufacturing process did not guarantee consistent grease application and, therefore, some subject vehicles received insufficient grease which contributed to the momentary increase in steering eï¬ort. During EA23003, ODI further analyzed the potential safety related consequences of the momentary increase in steering eï¬ort. the federal safety agencyâs Vehicle Research and Test Center (VRTC) duplicated the allegations of increased steering eï¬ort. In addition, VRTC discovered the steering worm wheel and worm gear tended to push grease out of the meshing area, resulting in large amounts of grease resting on top of the worm wheel. Information Request responses collected and reviewed by ODI showed Honda had also discovered this additional root cause during the federal safety agencyâs EA. In addition, Honda discovered the preload of the worm wheel gear spring was set too high, increasing the gear slide load and resulting in higher friction and increased torque ï¬uctuation when steering. The number of consumer complaints made to ODI continued to increase with the expansion of scope from the PE to the EA. Additionally, during EA23003, ODI received ten complaints alleging a crash, in addition to the 13 complaints ODI had received as of the time it opened EA23003. In total, 23 crashes have been reported to ODI due to this alleged defect. On October 3, 2024, Honda ï¬led the federal safety agency Recall No. 24V‑744 to address this defect. The recall will provide consumers with a new steering worm wheel gear spring with a decreased load. Additionally, dealerships will add additional grease and relocate any grease sitting on top of the worm wheel back into the meshing area. The scope of this recall includes all Honda vehicles that were manufactured with this speciï¬c improperly produced steering worm wheel and spring. In view of the recall action being taken by Honda, ODI is closing EA23003. the federal safety agency reserves the right to take additional action if warranted by future circumstances. To review the ODI reports cited in the Closing Resume ODI Report Identiï¬cation Number document, go to
EA23003
What 2023 Acura Integra owners say
Most recent owner complaints, unedited.
Failed Recall Remedy / Recurring Safety Defect: Electronic Power Steering BindingMy vehicle previously underwent the official manufacturer remedy for the federal safety agency Safety Recall Campaign 24V744 (Acura steering gearbox defect). The recall is marked as "Completed" on my VIN.Despite the remedy being performed, the dangerous safety defect has fully returned. While driving at highway speeds, the electronic power steering (EPS) exhibits a severe "sticky" and "notchy" sensation. The steering wheel momentarily catches, binds, and resists minor steering inputs, requiring excessive physical force to break the steering free, which results in sudden, dangerous overcorrections.When I returned the vehicle to an authorized Acura dealership (Team Gillman Acura, Houston, TX) to report the failed remedy, the dealership refused to diagnose or repair the vehicle. The service department stated that because the initial recall campaign had already been marked completed on my VIN, and because the vehicle is outside its standard factory warranty mileage, they have no obligation to address the recurring steering failure.The manufacturer's grease-and-spring recall remedy has failed to resolve the underlying mechanical defect (swelling worm gear/housing friction). The vehicle remains inherently unsafe to drive, and the manufacturer is refusing to provide a permanent remedy (steering gearbox replacement) for this active, federally recognized safety hazard.
Steering was sticky, shifty and driver could not recover resulting in loss of control and impact into an electrical pole and total loss of vehicle. Manufacturer and insurance are set to inspect vehicle. Police reported driver at fault as they did not have the mechanical / technical expertise / evidence to determine cause of accident when the recall notice was brought to their attention.
The sticky steering issue has returned even after the initial recall repair. Instead of replacing the entire steering rack, they only applied a temporary fix with grease the first time. The steering wheel stickiness comes and goes, which makes it even more frustrating and unpredictable. At times, the steering wheel even locks up during turns at speeds of 45+ mph, especially on highways and ramps, which is extremely concerning and unsafe. I brought the car back to the dealership, but they were unable to replicate the issue, so no repairs were made leaving me stuck without a solution. I’ve continued driving like this, and now at nearly 65,000 miles, the problem is worse than ever. Overall, this has been a completely horrible experience. Looking back, I wish I had done more research before buying this car. Save yourself the headache.
The Intermittent sticky steering wheel is back once again! So what was the whole-point of getting it fixed the first time under the recall when it’s going to happen again later on along the line. Now the car is approaching 50k and back to the dealer we go to see if they can replicate the problem to get it fix under the warranty. If not just going to have to wait and see if other integras is having the same issues.
In December 2024, I brought my 2023 Acura Integra to the local Acura dealership to address a recall related to a steering gear manufacturing defect, as well as to perform an oil change. The service department at Acura efficiently completed the work on my vehicle in one hour. On December 24, 2024, while operating the vehicle, the dashboard lights illuminated, and the steering wheel abruptly veered to the left, leading to a collision with large stationary rocks (boulders) alongside the road. The vehicle was required to be towed to a collision repair facility. The insurance claim has been submitted, and a police report has been filed. The collision shop performed a thorough inspection of the damage, and their analysis indicated that the cause of the accident is related to the steering system. The Acura Dealership has been informed of this information, and a claim has been submitted to Honda/Acura Manufacturer. No one from Acura has yet to send some one to inspect or investigate this matter.
The contact owns a 2023 Acura Integra. The contact stated that while driving on a ramp at approximately 30-35 MPH, while turning to the right, the steering wheel continued turning a complete 360 degrees, causing the contact to lose control of the vehicle and crash into a nearby wall. The air bags did not deploy. The vehicle was towed to the dealer where the cause of the failure was not determined. The vehicle received structural body repairs and the worm gear spring was replaced. The contact learned that the VIN was included in the federal safety agency Campaign Number: 24V744000 (Steering) after the repair. The contact mentioned that the vehicle prior to the crash experienced a sticky steering wheel. There were no injuries sustained and no medical attention was needed. A Police report was filed. The manufacturer was made aware of the failure. The failure mileage was 16,700.
Driving straight and want to turn slightly but the steering wheel HEAVILY resists which produces a sticky steering feeling at highway speeds. This is a steering rack defect which is commonly experienced among 2023+ Integra owners.
The contact owns a 2023 Acura Integra. The contact stated while driving at 55 MPH, the steering wheel seized, and the brake pedal was depressed to stop the vehicle. The vehicle was turned off and restarted and the steering failure message was displayed; however, the power steering functionality had not returned. The vehicle was driven to a local dealer to be diagnosed. The dealer had confirmed that the steering wheel had seized. The manufacturer was notified of the failure and informed the contact that there was no recall on the VIN for the failure. The approximate failure mileage was 53,000.
I recently purchased a this vehicle approximately two weeks ago and have since noticed a recurring problem with the steering. Specifically, the steering feels like it "sticks" when driving on a straightaway, making it difficult to maintain a smooth, consistent path. Initially, I thought the steering was simply stiffer compared to my previous vehicle, but after driving it for a couple of weeks, it has become clear that this is an ongoing issue. The steering tends to become jerky when I try to make small corrections to keep the car centered in its lane, which compromises the smoothness and control of the vehicle.
Questions about the 2023 Acura Integra steering
Does the 2023 Acura Integra have steering problems?
Owners have filed 190 complaints about the steering of the 2023 Acura Integra, 91% of all its complaints, more than any other problem.
At what mileage do 2023 Acura Integra steering problems start?
Not enough complaints include the mileage to tell.
Was there a recall on the 2023 Acura Integra steering?
Yes, 1 recall: 24V744000. Check your VIN to see if your car still needs the free repair.
What year does the Acura Integra have bad steering?
The Acura Integra model years with the most steering complaints are 2023 (190 complaints) and 2024 (52 complaints).
Other 2023 Acura Integra problems
Driver assistance 13Engine 5Electrical 4Brakes 3Seat belts 3Transmission 3Airbags 2Body 1Wheels 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 2023 Acura Integra?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history