2017 Acura MDX engine problems

Filed Oct 15, 2026 · Body, Driver assistance · NY · crash

As I was driving in a stop and go traffic jam, the vehicle would not go forward although I was pressing on the gas pedal, the engine stall and when it finally reacted after pressing it for the second time it went too fast that I couldn’t stop in time to avoid rear ending the other vehicle, the emergency braking system did not function properly either. This has happened multiple times even when I driven on highways and there’s incoming traffic and the engine goes on stall. But this time it led to an unavoidable accident. I have been concerned for a long time about this issue but I have never received a recall to remedy this problem.

Filed Aug 24, 2026 · Engine, Lights · CO

On my 2017 Acura MDX SH-AWD with approximately 112,000 miles, the engine experienced a sudden catastrophic failure while I was traveling at highway speed. The vehicle abruptly lost power, the accelerator became unresponsive, smoke came from the vehicle hood and exhaust area, and multiple warning lights illuminated. The failure occurred with no advance warning and created a serious safety risk because I suddenly lost propulsion while traveling approximately 75 mph in highway traffic. An independent repair facility inspected the vehicle and reported that connecting rod/bearing failure resulted in catastrophic engine damage. I was advised that two connecting rods/bearings failed and caused holes in the engine block, with a rod/component also damaging the A/C compressor. Oil subsequently leaked from the damaged engine. Prior to the sudden failure, I did not have warning lights or other indications suggesting an imminent engine failure. The warning lights appeared during or immediately after the loss of power. The vehicle has been inspected by a repair facility and the engine requires replacement. The vehicle/failed components can be made available for inspection upon request. I am particularly concerned because Acura has previously recalled certain vehicles for connecting rod bearing failures that can result in engine damage, stalling, or loss of motive power. My vehicle is the same model year and has experienced an apparently similar catastrophic connecting rod/bearing failure, but my VIN is not currently included in the recall 23V‑751. I am submitting this complaint so the federal safety agency can evaluate whether the affected population may extend beyond the VINs currently covered in that recall. This is also linked to the federal safety agency’s new investigation PE25008.

Filed Aug 6, 2026 · Engine · MD · fire

I was driving home late at night with my family in the car. The car suddenly loss power and the check engine light came on and began flashing. I pulled over and turned the car off and back on. The light went away. I began driving again and after a short while, a bunch of lights popped up on the dashboard and the car began to loose power again and started making weird rattling noises from the engine. Just moments before pulling over again I realized the car was on fire and evasively pulled over and frantically got my sleeping children out of the car and we created distance from the vehicle since it was on fire underneath. We called the fire department and they responded very quickly and put out the fire. We secured a few belongings and the children’s car seats and my brother in law picked us up. The car was towed from the scene. I called the incident into the insurance the next day and filed a claim. After a few days once the adjuster came out, it was determined that the insurance company would not be covering the claim because the cause of the fire was internal engine failure. It had shot a bearing cap through the oil pan and that is what caused the fire. I contacted Honda about the issue and have yet to hear back from them. This was over a month ago. I am now stuck repairing the vehicle on my own since I cannot afford to take the car to the dealer and I am mechanically inclined as it is what I do for a living. The car is currently in my garage and after taking the engine apart, I found that the main bearing for cylinder #6 had failed and in turn fell apart and broken the piston for that cylinder and the broken debris destroyed the engine block and even bent the valves on the from head for that cylinder. I now have to rebuild my entire engine with no warning whatsoever that this was going to happened. The car was maintained on schedule and nothing was ever overlooked or not performed. It was a great car until the engine decided to grandad itself out of nowhere.

Filed Aug 3, 2026 · Engine · IL

I was merging onto the highway and when I attempted to accelerate, the engine warning light began to flash and the car could not accelerate. The engine began to make a rattling noise. I called the dealer and they asked if I could make it there (it was about 25 miles away). I said I would try. As I got about 10 miles away the noise grew louder and the oil light came on. I immediately pulled over. The dealer said the engine blew the connecting rod and destroyed the engine and the engine would need to be replaced. The car just had all the fluids replaced by the dealer 3 weeks prior. All service work over the 10 years was done by the dealer.

Filed Jun 29, 2026 · Engine, Transmission · 97,000 miles · AZ

The contact owns a 2017 Acura MDX. The contact stated that while driving approximately 50 MPH, the vehicle lost power and stalled in the middle of the roadway. The vehicle was towed to a dealer to be diagnosed, and it was determined that the engine needed to be replaced. Additionally, the transmission failed to shift out of park(P). The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 97,000.

Filed Jun 6, 2026 · Engine · MI

My 2017 Acura MDX had a complete engine failure because of know critical rod bearing issue which hasn’t been extended to all 2017 models of the MDX. My engine completely failed when I was entering a roundabout and nearly caused the car behind me to rear end me then left me dangerously stranded in the roundabout. Even though this is a known issue for this year, make and model of my vehicle Acura said it was my fault without asking for detailed maintenance records and said this recall only applies to certain vehicles produced. I had to pay $7995.71 for a new engine and this issue needs to be addressed before someone is killed. Thank you

Filed Jun 4, 2026 · Engine · 180,000 miles · MA

The contact stated that while driving, the engine made clunking noise, sudden loss of power and the check engine light illuminated. The vehicle was taken to the dealer where it was diagnosed with a connecting rod bearing failure and engine replacement is necessary. The vehicle was not repaired. The manufacturer was notified of the issue. The approximate failure mileage was 180,000.

Filed May 4, 2026 · Engine · 122,220 miles · CA

The contact owns a 2017 Acura MDX. The contact stated that while driving at 40 MPH the engine seized. All the warning lights illuminated. The contact stated that the failure was due to the federal safety agency Campaign Number: 23V751000 (Engine and Engine Cooling). The vehicle was towed to an independent mechanic who determined there was an internal engine failure. The local dealer was contacted, where it was diagnosed that there was rod bearing and engine failure. The vehicle was not repaired. The manufacturer was contacted and opened a case. The claim was denied. The failure mileage was approximately 122,220.

Filed Apr 21, 2026 · Electrical, Engine · CA

The main issue is engine knocking and ticking also winding noise. There has been an issue with electrical with rear passengers getting burnt due to heat coming out of rear when rear system is off.

Filed Apr 17, 2026 · Engine · VA

A rod bearing inside the engine failed and created metal shavings inside the engine. The vehicle has not been fixed yet, so it is available for inspection currently, but I will be having the engine replaced in the next 2 weeks. With the metal shavings inside the engine it could cause a catastrophic failure of the engine while driving at any point The dealer has inspected and diagnose it as a rod bearing failure I reached out to Acura customer service to make them aware and ask for assistance in reviewing for coverage in the ongoing recall, but since my vehicle was not manufactured in the plant covered under the recall, they are unable to help. I asked for a good will credit and after they conferred with the dealer they stated the failure was not due to a manufacturing defect, therefore they cannot help. There were no warning lamps or messages from the vehicle. The only symptom was a ticking sound, that got louder at higher RPMs, coming from the front of the engine on the passenger side. I’ll also add that based on CARFAX report and our service records since we bought the vehicle, all recommended maintenance has been performed as recommended by the manufacturer.