Altec AT200A recalls

There are 8 safety recalls on record for the Altec AT200A, covering 3,441 vehicles in total across all the models in each campaign. Newest first.

Altec AT200A recalls by model year

2024 1 2023 1 2022 2 2021 2 2020 2 2019 2 2018 3 2017 3 2016 2 2013 1 2012 3 2011 2 2010 2 2007 2 2006 2

All recalls

Equipment: other: labelsReported December 20, 2024 · 82 vehicles affected

What is wrong: Altec Industries, Inc. (Altec) is recalling certain 2017-2024 Ford E350 van chassis equipped with a AT200A devices. The units mounted on certain Ford E350 van chassis with Gross Axle Weight Rating (GAWR) of 4050 and 4200 pounds, may fail at high loads due to a defect in the front axle.
Risk: Overload of the front axle capacity could cause it to fail and instability, increasing the risk of injury.
Remedy: Ford dealers will install front springs, insulators, and nuts, free of charge. Additionally, a new label will be provided to indicate the upgraded gross axle weight rating. Owner notification letters were mailed February 14, 2025. Owners may contact Altec customer service at 1‑877‑462‑5832. Altec's number for this recall is CSN-3206.

Recall number 24V952000 · Recall details

Electrical systemReported June 30, 2022 · 430 vehicles affected

What is wrong: Altec Industries Inc. (Altec) is recalling certain 2016-2022 van mounted AT200A and AT30G vehicles. The ground-fault circuit interrupter (GFCI) outlet may not provide adequate circuit protection against an electrical overload condition.
Risk: An overloaded electrical circuit can increase the risk of a fire.
Remedy: Altec will install a new GFCI outlet with a circuit-breaker and new wiring, free of charge. Owner notification letters are expected to be mailed August 29, 2022. Owners may contact Altec's customer service at 205‑991‑7733. Altec's number for this recall is CSN 3008.

Recall number 22V469000 · Recall details

Tires: markingsReported March 30, 2020 · 16 vehicles affected

What is wrong: Altec Industries Inc. (Altec) is recalling certain 2016-2018 AT200A vehicles built on Ford E-350 Cutaway chassis. The rear tire size and load rating may be incorrect, possibly resulting in the vehicle being overloaded.
Risk: An overload condition may reduce the vehicle's stability or result in tire failure, increasing the risk of a crash.
Remedy: Altec will notify owners, and dealers will inspect the tires and replace any that are not the correct size and load rating, free of charge. The recall began May 22, 2020. Owners may contact Altec customer service at 1‑877‑462‑5832.

Recall number 20V187000 · Recall details

EquipmentReported September 26, 2013 · 1,145 vehicles affected

What is wrong: Altec Industries, Inc. (Altec) is recalling certain model year 2010-2013 AT200A, AT235, AT235P, AT30-G, AT35-G, AT37-G, AT40-G and AT237 Aerial Devices mounted on Ford Super Duty Chassis' equipped with 6.8L gas engines and Muncie FR67 power take offs (PTO). In the affected vehicles, oil may leak from the PTO pressure switch onto a thermal blanket covering the exhaust.
Risk: Oil leaking onto the thermal blanket combined with heat from exhaust may result in an increased risk of fire.
Remedy: Altec will notify owners, and dealers will replace the affected pressure switch and thermal blanket with the kit identified by Muncie, free of charge. The recall began on December 9, 2013. Consumerr's may contact Altec at 1‑877‑462‑5832. Altec's recall number is CSN 583.

Recall number 13V458000 · Recall details

Electrical system: 12v/24v/48v battery: cablesReported May 29, 2013 · 761 vehicles affected

What is wrong: Altec Industries, Inc. is recalling certain model year 2010-2012 AT200A, AT235/235P, AT237, AT248F, AT35/37-G, and AT40-G aerial devices built on Ford F550 chassis with a gross vehicle weight rating of 19,500lbs. The battery cable going to the unit auxiliary functions could be damaged and possibly short to ground.
Risk: If the battery cable shorts to ground, it may overheat, resulting in a fire.
Remedy: Altec began notifying affected owners on April 24, 2013. Dealers will re-route the auxiliary function battery cables. Owners may contact Altec at 1‑800‑860‑0183. Altec's recall number is CSN 565.

Recall number 13V224000 · Recall details

Suspension: front: springs: torsion barReported August 8, 2012 · 141 vehicles affected

What is wrong: Altec Industries, Inc. is recalling certain model year 2012 Aerial Device vehicles built on a Navistar Terrastar chassis because the Altec-installed torsion bar increases the ride height of the front suspension, which when the vehicle hits bumps, may cause the vehicle to alter its steering direction.
Risk: As the vehicle hits bumps, it may deviate from the intended line of travel, increasing the risk of a crash.
Remedy: Altec will notify owners, and will install an updated bracket and spring kit, free of charge. The safety recall began on August 27, 2012. Owners may contact Altec Industries at 1‑877‑462‑5832.

Recall number 12V390000 · Recall details

EquipmentReported March 28, 2011 · 832 vehicles affected

What is wrong: Altec is recalling certain at35-g, at37-g, at235, and at237 aerial devices manufactured from january 2005 through october 2008. These units are equipped with billet steel counterweight that is welded in place. In the event of weld failure, the counterweight may fall out while travelling.
Risk: If these steel pieces fall in the path of the vehicle or other traffic, a vehicle crash involving death or serious injury may result.
Remedy: Altec has developed kits to improve the attachment of the billet steel counterweights. Customers at their option may perform the repair or have a dealer install the kit free of charge. The safety recall is expected to begin during april 2011. Owners may contact altec at 1‑877‑462‑5832.

Recall number 11V197000 · Recall details

Steering: hydraulic power assist: hose, piping, and connectionsReported September 2, 2010 · 34 vehicles affected

What is wrong: Altec is recalling certain model year 2006-2007 at200a, at235, model year 2007-2010 at235p and model year 2008 at3xg trucks built on gm chassis. There is a potential hydraulic hose routing condition in the engine compartment. The hose could contact and cause some abrasions to an oem 12v chassis wire or possibly rub on the steel power steering line which may lead to possible damage of the hydraulic line.
Risk: This could result in a burst hydraulic hose damage wiring, or a fire.
Remedy: Altec will provide instructions to dealers on how to inspect and install the new bracket free of charge. This service will be performed free of charge. The safety recall began on september 15, 2010. Owners may contact altec at 1‑877‑462‑5832.

Recall number 10V399000 · Recall details

Questions about the Altec AT200A recalls

How do I check if my Altec AT200A has an open recall?

Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.

Do I have to pay for a recall repair?

No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.

How many recalls does the Altec AT200A have?

8, covering equipment, electrical system and tires.

VIN decoder

See the problems and recalls for an exact car

Buying a used Altec AT200A?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history