The worst 2022 Altec Digger Derrick problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
Recalls 12
Electrical system: wiring
- What is wrong
- Altec Industries, Inc. (Altec) is recalling certain 2021-2026 Altec Digger Derrick, and 2023-2025 Altec TA Series Aerial Device vehicles. Improper wiring may prevent the boom stow auto-neutral feature from engaging, which can allow the truck to be driven while the boom is still elevated.
- Risk
- When the vehicle is moved or driven with the boom out of stow, the vehicle could exceed the recorded travel height, increasing the risk of a crash.
- Remedy
- Altec will correct the wiring in the power distribution module to enable the boom stow auto-neutral functionality, free of charge. Owner notification letters are expected to be mailed November 20, 2026. Owners may contact Altec's customer service at 1‑877‑462‑5832. Altec's number for this recall is CSN-3370.
Recall number 26V617000 · Recall details
Forward collision avoidance: automatic emergency braking
- What is wrong
- Altec Industries, Inc. (Altec) is recalling certain 2019-2026 AN Series, 2023 AA Series, 2022-2026 Digger Derrick, and 2025 AM Series vehicles. The Bendix automatic braking system was not recalibrated after relocating the front radar box.
- Risk
- An improperly calibrated system may have a delayed braking response, increasing the risk of a crash.
- Remedy
- Altec will update the collision mitigation system with the revised the parameters, recalibrate, and test the system, free of charge. Owner notification letters were mailed October 16, 2026. Owners may contact Altec customer service at 1‑877‑462‑5832. Altec's number for this recall is CSN-3356.
Recall number 26V541000 · Recall details
Electrical system: wiring: power distribution module/ipdm
- What is wrong
- Altec Industries, Inc. (Altec) is recalling certain 2021-2025 Digger Derrick and 2021-2025 AM Series Aerial Device vehicles. The chassis engine may start unintentionally due to a missing diode in the Altec power distribution module.
- Risk
- An engine that starts unexpectedly increases the risk of injury to anyone near the engine compartment during maintenance operations.
- Remedy
- Altec will provide instructions to inspect the power distribution module for a diode, and provide a repair kit as necessary, free of charge. Owner notification letters were mailed March 27, 2026. Owners may contact Altec customer service at 1‑877‑462‑5832. Altec's number for this recall is CSN-3281.
Recall number 26V071000 · Recall details
Structure: frame and members
- What is wrong
- Altec Industries Inc. (Altec) is recalling certain 2011-2025 Aerial Device, Digger Derrick, and 2022-2025 Service Body vehicles. The cable step wire rope assembly may be improperly secured, which can allow the cable entry step to detach from the vehicle.
- Risk
- A cable step that fails during use increases the risk of injury.
- Remedy
- Altec will provide owners with instructions to inspect the cable crimps. If the cables are improperly crimped, Altec will provide instructions and a kit to replace the wire rope assemblies. Repairs will be performed free of charge. Owner notification letters were mailed October 24, 2025. Owners may contact Altec customer service at 1‑877‑462‑5832. Altec's number for this recall is CSN-3246.
Recall number 25V562000 · Recall details
Equipment: mechanical: winch
- What is wrong
- Altec Industries, Inc. (Altec) is recalling certain 2004-2023 DL42 and DL45 Digger Derricks. The incorrect hydraulic load holding valve may have been installed, which can cause the winch to lower uncontrollably and the load to fall.
- Risk
- An uncontrolled load falling increases the risk of injury to personnel or others nearby.
- Remedy
- Altec will replace the load holding valve, free of charge. Owner notification letters are expected to be mailed October 6, 2023. Owners may contact Altec's customer service at 1‑877‑462‑5832. Altec's number for this recall is MAB 3113.
Recall number 23V636000 · Recall details
Electrical system
- What is wrong
- Altec Industries, Inc. (Altec) is recalling certain 2022-2023 Aerial Devices (AT, TA, L44, L45, LR8, AA, AM, AN) and D series Digger Derricks (DH, DL, DM, DT). The power inverter that converts electrical DC power to AC power may have been installed without a circuit breaker to protect the AC output circuit.
- Risk
- Without a circuit breaker, the AC circuit may overheat, increasing the risk of a fire.
- Remedy
- Altec will install a 20-amp circuit breaker in the AC circuit, free of charge. Owner notification letters were mailed December 21, 2023. Owners may contact Altec's customer service at 1‑877‑462‑5832. Altec's number for this recall is CSN 3103.
Recall number 23V525000 · Recall details
Equipment: emergency: siren/lighting/strobes
- What is wrong
- Altec Industries, Inc. (Altec) is recalling certain 2021-2023 Aerial Devices, Digger Derricks, Service Bodies and Cranes. Water can leak into the strobe lights, which could cause an electrical short-circuit.
- Risk
- An electrical short-circuit can increase the risk of a fire.
- Remedy
- Altec will provide instructions to inspect the light assembly for moisture and install a new fuse. If moisture is found or the light is inoperative, a light replacement kit will be installed. Repairs will be performed free of charge. Owner notification letters are expected to be mailed July 14, 2023. Owners may contact Altec's customer service at 1‑877‑462‑5832. Altec's number for this recall is CSN 3079.
Recall number 23V357000 · Recall details
Equipment: mechanical: boom/crane/ladder
- What is wrong
- Altec Industries, Inc. (Altec) is recalling certain 2021-2023 DT85 Digger Derricks. The Boom pressure limiter may allow the boom to lift loads above the rated capacity and over the Hydraulic Overload Protection (HOP) setting.
- Risk
- Lifting loads above the boom capacity could overload the unit and cause instability, increasing the risk of injury.
- Remedy
- Altec will provide instructions to owners to test the boom lift pressure limiter setting and set it to the correct pressure, free of charge. Owner notification letters are expected to be mailed July 7, 2023. Owners may contact Altec's customer service at 1‑877‑462‑5832. Altec's number for this recall is CSN 3078.
Recall number 23V340000 · Recall details
Equipment: mechanical
- What is wrong
- Altec Industries, Inc. (Altec) is recalling certain 2017-2022 DC, DB, DL, DM, DH, DT, and D2/3/4000 Digger Derricks. The hardware that secures the removable auger hex extension bar to the drive unit coupler was not installed, which may cause it to detach.
- Risk
- An auger extension bar that detaches while the digger drive unit is deployed, can increase the risk of injury to nearby personnel.
- Remedy
- Altec will provide instructions for owners to inspect the auger extension assembly for missing hardware. If hardware is found to be missing, a replacement kit will be provided by Altec, free of charge. Owner notification letters are expected to be mailed June 30, 2023. Owners may contact Altec's customer service at 1‑877‑462‑5832. Altec's number for this recall is CSN 3076.
Recall number 23V326000 · Recall details
Structure: body
- What is wrong
- Altec Industries, Inc. (Altec) is recalling certain 2016-2022 DM, DH, DC, DL, D2000, D3000, and D4000 series digger derricks, and AM55 aerial devices. The base of the rear pole rack may be missing a weld.
- Risk
- A missing weld on the rear pole rack can lead to a crack that could cause the pole and rack to drop in height, increasing the risk of an injury.
- Remedy
- Altec will inspect the rear pole rack mounting plate, and if necessary, replace any required welds, free of charge. Owner notification letters are expected to be mailed May 26, 2023. Owners may contact Altec's customer service at 1‑877‑462‑5832. Altec's number for this recall is CSN 3064.
Recall number 23V216000 · Recall details
Structure: critical fasteners
- What is wrong
- Altec Industries, Inc. (Altec) is recalling certain 2022 DC & DM Series Digger Derrick vehicles. During production, an incorrect bolt may have been used to attach the derrick rotation bearing.
- Risk
- An incorrect bolt in the derrick rotation bearing may cause the adjacent bolts to be overloaded during operation, which could cause separation of the rotation bearing, and increase the risk of an injury.
- Remedy
- Altec will inspect and if an incorrect bolt is found, replace the bolts affected bearing race, free of charge. Owner notification letters are expected to be mailed March 10, 2023. Owners may contact Altec's customer service at 1‑877‑462‑5832. Altec's number for this recall is CSN 3045.
Recall number 23V003000 · Recall details
Equipment: mechanical: boom/crane/ladder: controls/control wiring
- What is wrong
- Altec Industries, Inc. (Altec) is recalling certain 2016-2022 E-series & DH-H series Digger Derricks. The relay connectors may have been reattached to the incorrect plug after a stability test was performed. If the connections are not correct, the hydraulic overload protection system will not function.
- Risk
- A nonfunctional overload protection system may result in the operator unknowingly overloading the system, increasing the risk of injury.
- Remedy
- Altec will inspect and reattach the connectors, if necessary, free of charge. Owner notification letters were mailed on June 29, 2022. Owners may contact Altec's customer service at 1‑877‑462‑5832. Altec's number for this recall is CSN 858.
Recall number 22V349000 · Recall details
Technical service bulletins for the 2022 Altec Digger Derrick 26
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Altec has learned that hydraulic hoses on certain DM-E and DH derricks, built between 2021 and 2025, can...
- Altec has learned that the velocity fuse, part of the HOP plumbing on the lower boom lift cylinder, may...
- Altec has learned that the king pin towing capacity placard might not be installed on certain DL derricks...
- Altec has developed additional features and functionality for JEMS Connect
- Altec Industries, Inc. has received notification from International that a condition exists relating to...
- Altec has learned that certain DC and DM model derricks built from January 2019 to June 2024 could have...
- Altec has learned that the structural subbase welds on certain DH derricks built from July 2016 to...
- Altec has learned that certain DT85H derricks built from May 2022 to December 2023 equipped with a Parker...
- Altec has learned that a 12-volt Airtronics relay installed in the PDM could have been manufactured to an...
- Altec has learned that certain Altec units equipped with an AXIS telematics control unit (TCU) built from...
Compare the 2022 Altec Digger Derrick
Other model years
Questions about the 2022 Altec Digger Derrick
Is the 2022 Altec Digger Derrick reliable?
Owners have filed 0 complaints about the 2022 Altec Digger Derrick.
What is the most common problem with the 2022 Altec Digger Derrick?
There are not enough complaints to tell.
How many recalls does the 2022 Altec Digger Derrick have?
12 recalls, covering electrical system, forward collision avoidance and structure.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2022 Altec Digger Derrick?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history