Check a VIN

1994 Am General Hummer recalls

There are 3 safety recalls on record for the 1994 Am General Hummer, covering 5,450 vehicles in total across all the models in each campaign. Newest first.

All recalls

Vehicle speed control: accelerator pedalReported March 12, 1996 · 3,000 vehicles affected
What is wrong
The coating used to protect the accelerator pedal shaft is incompatible with the bronze bushing through which the shaft passes. Over time, and in the presence of a corrosive environment (water, road salt), the shaft can corrode inside the bushing increasing the amount of friction between the rotating shaft and the stationary bushing.
Risk
A corroded accelerator pedal shaft can cause the engine throttle to bind and not fully return to idle when the operator's foot is removed from the accelerator pedal increasing the potential for a vehicle accident.
Remedy
Dealers will install a revised accelerator pedal and shaft assembly.

Recall number 96V049000 · Recall details

Vehicle speed controlReported February 13, 1995 · 150 vehicles affected
What is wrong
Water can accumulate in the cruise control cable and if the outside temperature is below freezing and the cruise control is engaged, the water can freeze causing the cable to bind and not release as intended when the brake pedal is applied or the system is turned off at the master cruise control switch.
Risk
The engine throttle can stick open resulting in loss of throttle control with the increased potential for a vehicle accident.
Remedy
Dealers will remove the current cruise control actuator and cable assembly and install a new assembly. Additionally, dealers will change the routing of the cable.

Recall number 95V023000 · Recall details

Fuel system, gasoline: delivery: hoses, lines/piping, and fittingsReported September 1, 1994 · 2,300 vehicles affected
What is wrong
The oil pressure switch which controls the power to the electric fuel pump can fail. Failure is due to a missing rubber seal between the switch and the wiring harness. The missing seal allows contaminants to enter the switch causing it to fail in the open or closed position.
Risk
If the switch fails in the closed position, the pump will continue to run when the engine is off, draining the battery. If the switch fails in the open position it will cause poor performance and possibly stalling.
Remedy
Dealers will inspect the vehicles for the presence of the seal. If the seal is missing, the switch will be replaced and a new seal will be installed.

Recall number 94V164000 · Recall details

Questions about the 1994 Am General Hummer recalls

How do I check if my 1994 Am General Hummer has an open recall?

Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.

Do I have to pay for a recall repair?

No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.

How many recalls does the 1994 Am General Hummer have?

3, covering vehicle speed control and fuel system, gasoline.

VIN decoder

See the problems and recalls for an exact car

Buying a used 1994 Am General Hummer?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history