Master cylinder and rear brake cylinder failed causing the brake light to illuminate. Nlm
1993 Buick Lesabre brakes complaints
Page 2 of 3: complaints 11 to 40 of 70, newest first, as owners wrote them.
No summary
Abs brake light illuminates, indicating a malfunction within the system, dealer states that problem occurs due to a defective ABS solenoid sensor. Please give any further details.
Abs brake light comes on and stays on until consumer shuts the car off.consumer called manufacturer.
A/c no working properly due to relay sticking open/failure.mjs
When applying the brakes during normal braking on wet road conditions, ABS warning light came on along with the traction off light. The pmv valve shorted out. The valve was replaced and the system was bled. Dealer has done repairs at owner's expense. Manufacturere agreed to reimburse for part of the cost, but the owner has yet to receive it. *ak
Abs brakes needed replacement.
Windshield washer pump failed.
Abs light came on, and unable to turn off unless cost goes to consumer.
Consumer is having a problem with the anti-lock skid system. When driving the ABS light comes on, indicating a problem in the system, the anti-lock skid system does not work only the regular hydraulic brakes. Manufacturer has not been contacted.
Abs system failed to operate. Dealr refused to repair unless cost goes to consumer.
Abs brake warning light remained illuminated, indicating malfunction within the system. Dealer states that the pmv valve has to be replaced. Please give any further details.
The vehicle ABS system malfunctioned, causing light to come on, and extended stopping distance when the which almost caused an accident. Also, dealer replaced a "major component".
Right front brakes failed.
Vehicle had approximately 18,623 miles when master cylinder needed to be replaced. Vehicle had 20,000 miles when ABS became inoperative. Had to install new pressure modulator valve. Also all lines connecting to cylinder are corroded, need to be replaced, resulting in total defective brake system.
Upon applying brakes (ABS), vehicle responds poorly. Vehicle involved in an accident a year ago. Area dealership not able to correct the problem unless duplicated on scene.
Main module to ABS system failure.
Studs on front rotors are too short.
Driving at approximately 30 MPH in wet conidtions, ABS became inoperative, felt soft, ABS light went on. Dealer replaced valve kit.
Anti-lock brake failure.
When applying the brakes the master cylinder leaked brake fluid which could result in decreased braking ability.
Abs warning light came on when skid situation occured and would not reset. Dealer indicated the complete ABS main master system locked up and would not retract. Light still on and ABS still not working.
Anti lock brakes failed.
Master cylinder/proportional valve/rear brake cylinders leak brake fluid.
Abs dash light pressure modulator valve failed.
Abs system stopped working and the ABS light stayed on, cause unknown.
Antilock brake warning light illuminated.
Anti-lock braking system became inoperative while driving, ABS warning light appears continuously, only hydraulic brake works. Also, replaced master cylinder.
Abs brake failure, when driving saw ABS light come on (yellow) ABS system inoperative, replacement of the breake pressure module valve.
Warning light came on saying ABS was out. Dealer says a part in the ABS was defective.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1993 Buick Lesabre?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history