My vehicle continued to accellerate upon entering highway. I could not slow the car down. I lost control of the car. I pulled onto the shoulder, shifted to nuetral, and turned off the ignition. The brakes were smoking and burnt out. Vehicle was disabled, I had to have it towed.
1996 Buick Regal brakes complaints
Page 2 of 3: complaints 11 to 40 of 42, newest first, as owners wrote them.
Excessive wear of brake pads/ front rotors and drums. Rotors / drums overheating which is causing them to warp. Dealer notified. Feel free to provide any further details on this matter.
Premature wear of brake rotors. Intermittently when brakes are applied vehicle vibrates. Dealer has replaced rotors twice, and problem reoccurred.
Rear bearings have failed, and the rotors were warped. Dealer has replaced the rear bearing.
Brake rotors failed causing consumer to hear a loud noise from the front and rear brakes. Nlm
While driving applied brakes and pedal went to the floor. It felt like they were going to respond, but vehicle kept rolling into an intersection, the consumer had to avoid an oncoming vehicle an d ran into an fence. The dealer has been contacted.
Extremely loud noise from the brakes when backing out from a parked position while applying the brakes. Windshield leaks at the location of the rear mirror light wires, and drips on the gear shift area. The passenger side mirror and the driver side mirror are two different colors, which might indicate the vehicle was in a wreck. I was given no history of repairs on this automobile . An "alamo" sticker was attached to the inside of the trunk lid.
Need to replace brakes for 3rd time due to warping
When brakes are applied pedal gets hard, resulting in extended stopping distances. The dealer has replaced the brakes 4 times.
While coasting at 10mph to signal light, applied the brakes and they failed to work. Had to pump brakes at least 3 times before they worked. On 19 jan 99, was going 30-35 MPH when vehicle in front stopped suddenly. Consumer rearended vehicle in front due to lack of braking power. Took to dealer & waiting for parts.
Consumer tried to stop vehicle, she couldn't because the brake pedal went all the way to floor, vehicle did not stop on time and brakes fluid was all over. Also, there was a recall before regarding ABS brakes, recall performed by installing clip to prevent rubbing, new location of shifted brakeline path resulted in rubbing two inches from original location, request manufacturer to reevaluate recall repair.
Consumer expriencing ongoing problem with braking system. Whenever driving a winding noise appears to be coming from the wheel, and when the brakes are applied the vehicle would jerk intermittently. Aslo, learned from an independent dealer that the vehicle's front end was shot, and needed major repairs. Dealer notifed, but no correction was made at this time. Brakes continue to give consumer problems.
When applying the ABS brakes the pedal travels to the floor, causing extended stopping distance. Cause unknown. Please give any further details.
Anti lock brakes failed resulting in vehicle collision.
Applied brakes to stop vehicle when they made a thumping sound. Called dealer. Took vehicle in. Vehicle started squeaking & thumping. Abs light came on & stayed.
Anti lock brakes and rotors failed.
Brakes failed, avoided three cars, hit a car in the intersection and then hit a pole. Vehicle was totaled.
Anti lock brakes failed.
The metal brake line is rubbing against the bolt in the engine compartment, causing the vehicle to lose brake fluid. Also, the brake goes down to the floor of the vehicle. Took vehicle to the repair shop.
Appears that calipers were defective, no contact between calipers and disc, resulting in pulsation and presence of rust on the disc. Inspected left front brake line for clearance/clip ret-reposition, recall 96v‑069.
Anti-lock brakes failed, causing vehicle to accelerate instead of brake, resulting in an accident.
On three occasions the vehicle accelerated out of control. After second occasion, vehicle was towed to dealership. Dealer could not find a problem. On (5) or (6) occasions the brake pedal has been extremely hard to apply. They popped and cracked. Because this does not happen when taken to dealership, they have stated that nothing was wrong with the vehicle. *ak
Brakes perform poorly causing loud noise.
Brake system is failing.
Multiple brake failure.
Brake rotors heavily rusted, causing vibration.
Consumer has experienced continuous brake problems, several repairs done to no avail. The final repair found the brake calipers defective, there was no contact between the calipers and the disc, resulting in pulsation/rust on discs.
Antilock brake warning light illuminated.
When brake pedal is depressed it goes lower than the accelerator pedal, causing accelerator pedal to be accidentally depressed/vehicle lunges forward.
Safety recall--brakes. Adjust side door for proper closing. 231 flash e-prom and install label ma-96-v9943. Safety recall--backfire. Replaced torque converter switch.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1996 Buick Regal?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history