1996 Buick Regal recalls
There are 3 safety recalls on record for the 1996 Buick Regal, covering 1,069,307 vehicles in total across all the models in each campaign. Newest first.
All recalls
Steering: rack and pinion
- What is wrong
- Certain passenger vehicles have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These retainers could fail and permit the ball bearings to escape.
- Risk
- If this occurs, the pinion shaft can be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver can encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.
- Remedy
- Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began on february 5, 2004. Owners should contact buick at 1‑866‑608‑8080; chevrolet at 1‑800‑630‑2438; oldsmobile at 1‑800‑630‑6537; or pontiac at 1‑800‑620‑7668.
Recall number 03V527000 · Recall details
Fuel system, gasoline: fuel injection system
- What is wrong
- A backfire during engine starting can cause breakage of the upper intake manifold.
- Risk
- This condition can cause a no-start condition and possibly an engine compartment fire.
- Remedy
- Dealers will update the powertrain control module programming. Until the campaign repair is made, the vehicle hood should be shut whenever starting the vehicle to reduce the chance of personal injury.
Recall number 96V116000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- The left front brake line can contact the transaxle mounting bracket or attachment bolt.
- Risk
- This condition can cause the brake line to wear through, resulting in loss of brake fluid and eventual loss of one-half of the vehicle's brake system, increasing the potential for a vehicle accident.
- Remedy
- Dealers will inspect the vehicle for proper brake line clearance and reposition those brake lines found to have less than minimal clearance. Additionally, those brake lines found to have an indentation caused by the contact will be replaced and properly routed.
Recall number 96V069000 · Recall details
Questions about the 1996 Buick Regal recalls
How do I check if my 1996 Buick Regal has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the 1996 Buick Regal have?
3, covering steering, fuel system, gasoline and service brakes, hydraulic.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1996 Buick Regal?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history