Engine stalled. Restarted. Cleaned electric control throttle. Ran 2 days with no problem except for rough idling (this was happening before first shut down). Engine stall, restarted. Drove home. Today engine stalled again. Two of incidents occurred while stationary and once in motion.
2010 Chrysler 300: engine stalls while driving
9 of the 123 complaints about the 2010 Chrysler 300 describe engine stalls while driving.
- owner complaints
- 9
- of this car's complaints
- 7%
- typical mileage
- 54,189
- recalls
- 0
Engine stalls while driving by model year
What owners say
Alternator fails causing engine stalling while driving for vehicles equipped with a 5.7l or 3.6l engine and a 160, 180 or 220 amp alternator, the alternator of the vehicle may fail, resulting in the engine stalling while driving. A failed alternator would also lead to a dead battery, preventing the vehicle from having electrical power to start. The alternator in affected vehicles also could possibly short circuit, causing an engine fire. The car turned off while in the drive position. I was leaving the company parking deck. I received two battery jumps the car turned on and once the jumping cables was removed and the gear switched to the position of drive the car turned off. I also purchased a new battery this year as it happened before earlier this year
Alternator failed, the vehicle stalled after two jumps
While driving on my way to work I was pulling up to a stop sign before merging onto busy traffic on a main road when my car cut off. I tried starting it again but it would turn over but it would not stay running. After tow attempts I stopped trying turned on my hazards and signaled for the cars behind to try to go around (as this was not easy as I was blocking traffic). No warning lights were on, or came on previously, I maintained adequate 3000 mi oil changes, and maintenance. Meanwhile a police officer helped me put the car in neutral and moved me out of the way of traffic and stayed near while I waited on the tow truck. I am grateful that my car did not stall out on the highway while I was transporting my child. The thought of my car suddenly stalling is frustrating and scary! With the mileage of my car, the engine should be the least of my worries.
Ignition switch caused engine to shut down while driving and caused problems with starting. After three trips to dealer problem was found to be the ignition switch and was replaced. Stalling while driving is a safety issue that should be cause for a recall. Note! The expensive ignition switch was replaced at my cost. I have the repair invoices.
Tl* the contact owns a 2010 chrysler 300. The contact stated that the vehicle stalled for approximately five seconds before it started. The vehicle was not repaired. The manufacturer was not made aware of the issue. The failure mileage was 36,060. Updated 12/18/15*lj; updated 04/23/18*jb
Was driving down the rd in city limits when lightning bolt light came on as well as traction control light...car bucked through intersection before stalling in middle of rd nearly causing an accident... Drove immediately to dealership while stalling at every light on way there.. Dealership claimed it was egr tube seal replaced as I started to drive off lights came back on ... No fix... So then dealer changed map sensor said didn't know what else could be problem.. Driving home car stalled again.. The next day was a holiday so I got the car home called service they told me it may be learning the car and to continue to drive.. A week later still stalling everyday. Called service and left message with no return call.. Can not keep paying for rental or them to tell me they don't know. I've had this car maybe 8 mos and had all service done on it... This is ridiculous!
Vehicle stalled for no reason,taken to dealership and no apparent problem except needing fuel when fuel gauge showed 1/4 tank available .second incident today 10/29/12 vehicle stalled again. Fuel warning light didn't turn on because it showed tank had 1/4. Apparently vehicle needed fuel. When stopped at gas station. Didn't fill up completely but dispenser will stop as is tank was full. Wouldn't allow to fill tank to the max.
Tl* the contact owns a 2010 chrysler 300. The contact stated that the vehicle would stall without warning. After some of the occurrences, the vehicle would not restart for approximately 15 to 20 minutes. The vehicle was taken to an authorized dealer on several occasions, but they were unable to remedy the failure. The failure mileage was 38,000 and current mileage 42,000.
Service bulletins that may apply
- Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire
- NAG1 (5A580)
- Part Description: Valve Body Assembly Issue Description: Valve body design was changed between 2010MY and...
- Part Description: Short Runner Valve (Actuator) Issue Description: Issue 1~ JC,JS '08-09MY 3.5L only~ Caution
- Gasoline Engine Diagnostic Inspection Procedure
- Chrysler: malfunction light is on with a stored trouble code
Related recalls
No recalls on record for this model year.
Questions about the 2010 Chrysler 300 stalling
Is engine stalls while driving a common problem on the 2010 Chrysler 300?
9 of 123 owner complaints about the 2010 Chrysler 300 (7%) mention engine stalls while driving. The model year with the most reports is 2006.
Is there a recall or service bulletin for this on the 2010 Chrysler 300?
There are 0 recalls and 9 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2010 Chrysler 300
VIN decoder
See the problems and recalls for an exact car
Buying a used 2010 Chrysler 300?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history