The contact owns a 2015 Chrysler 300. The contact stated that while driving at 69 MPH on the freeway, when the contact attempted to switch lanes and the vehicle spun independently, causing her to collide with another vehicle on the front driver side. The contact mentioned her rear bumper detached from the vehicle. No air bags deployed. The contact did not sustain any injuries. No medical attention was required. The contact vehicle was towed to Emerine's Central Auto and Towing. The contact stated that a police report was filed. The contact stated the vehicle was previously diagnosed by an independent mechanic, and the ABS speed sensor needed to be replaced. The vehicle was repaired prior to the accident, as the ABS speed sensor was replaced. The manufacturer was not notified of the failure. The approximate failure mileage was 141,000.
2015 Chrysler 300: ABS light or ABS activating
7 of the 99 complaints about the 2015 Chrysler 300 describe ABS light or ABS activating.
- owner complaints
- 7
- of this car's complaints
- 7%
- typical mileage
- 52,000
- recalls
- 0
ABS light or ABS activating by model year
What owners say
The contact owns a 2015 Chrysler 300. The contact stated while driving approximately 40 MPH, the brake pedal was depressed but felt soft. The contact stated that the failure occurred at various speeds, requiring that the brake pedal be depressed with excessive force. The contact stated that the ABS and ESC warning lights were illuminated. The contact stated that while braking following a curve in the road, the rear end of the vehicle started swaying slightly to the right and left. The contact stated that the warning lights were constantly illuminated. The contact had taken the vehicle to a local dealer, where it was diagnosed and determined that one of the wheel sensors needed to be replaced. The vehicle was repaired; however, the failure reoccurred. The contact had not taken the vehicle back to the dealer. The vehicle was not diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 18,000.
Electronic stability control/ ABS light/ brake light.. While driving the ESC and ABS popped on together, after cranking back up the vehicles brake light appeared, something is stopping the vehicle from driving normal. Upon stopping at red lights the car jerks, also it skids when making left and right hand turns. The car revs when accelerating but the rpms are reduced as if in limp mode. The car is very dangerous to drive especially two lane highways it gravitated towards the ditch this time I just could turn the wheel, because sometimes the wheel is very hard to turn.
The service electronic stability control and service ABS brake system lights are on in 2015 chrysler 300 sport
The ABS light comes on every time I drive it. Sometime it feels like something is under the brake peddle. The car was in motion each time. It was never on a turn.. Was there a recall at anytime?
Tl* the contact owns a 2015 chrysler 300. While attempting to start the engine, the service stability, ABS, and traction control warning indicators remained illuminated. Also, the vehicle hesitated to accelerate and would not respond immediately. The contact stated that the vehicle lost power and did not immediately accelerate when depressing the accelerator pedal. The vehicle was taken to heritage dodge (9219 harford rd, baltimore, md) to be diagnosed, but the failure could not be duplicated .the manufacturer was notified of the failure. The failure mileage was 42,000.
Drove car to town thursday 10/11/18 everything was fine get in car friday morning 10/12/18 start car warning comes up on display ecs ABS awd disabled, I do not drive vehicle till friday 10/18/18 to take it to dealership, they charged $89 to run scan tool to find out front left wheel speed sensor is faulty would be $240 to replace sensor, which consists of 3 bolts and being plugged in, and code cleared . This is not a 3 hour job. Currently there are no wheel speed sensors available and are on indefinite back order due to an unbelievably high demand. Can not drive car safely due to the car being crippled because of a $29 sensor. I have owned this car less than 6 months and have driven less than 5000 miles, the sensor literally went bad in my driveway, the mechanics new it is a massive problem and are charging people way over what should be for what is an obviously defective part. They also told me is would be fine to drive until they can get the part which is untrue due to 2 safety moduals and one drive train function being disabled. The fact that they are on an indefinite backorder from the factory tells this is a model wide problem and needs to be addressed.
Service bulletins that may apply
- Pad kit - rear disc brake, front disc brake
- Decreased Remote Start And RKE Range
- Vibration While Braking
- Anti-lock brake module (ABS) before replacing the ABS module, please call fadi korkis at cell (586) 722-4100
- Anti-Lock Brake Module (ABS) Before replacing the ABS module, please call Fadi Korkis at cell (586) 722-4100
- Flash: RA3/RA4 Radio Software Enhancements
- Rotor
- Rotor
Related recalls
No recalls on record for this model year.
Questions about the 2015 Chrysler 300 abs
Is ABS light or ABS activating a common problem on the 2015 Chrysler 300?
7 of 99 owner complaints about the 2015 Chrysler 300 (7%) mention ABS light or ABS activating. The model year with the most reports is 2012.
Is there a recall or service bulletin for this on the 2015 Chrysler 300?
There are 0 recalls and 15 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2015 Chrysler 300
VIN decoder
See the problems and recalls for an exact car
Buying a used 2015 Chrysler 300?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history