Loss of ABS when applying brakes. This happens at all levels of braking, I.e. Heavy, medium and minimal braking. When loss of ABS happens, the pedal decends to the floor and a buzz/racheting noise is heard. This problem has lead to potentially 4 major accidents. To solve the loss of braking, driver has to "re-pump" the pedal after loss has occured. (no mil/scan tool code recorded) .
1996 Chrysler Cirrus: brake failure
6 of the 160 complaints about the 1996 Chrysler Cirrus describe brake failure.
- owner complaints
- 6
- of this car's complaints
- 4%
- recalls
- 2
Is there a fix? There are 2 recalls for this area of the car. See below
Brake failure by model year
- 20002
- 19993
- 19981
- 19966
- 199528
What owners say
While driving, upon applying brakes to make a gradual stop the brakes failed to respond. Vehicle would need an extended stopping distance. Vehicle was involved in a crash. Consumer has contacted the dealer which determined that the front brake rotors were the incorrect size causing the problem. Front brake rotors were replaced. Ts
Consumer was traveling about 35mph on a highway street, and went to apply brakes and pedal went all the way to the floor. He passed the stop sign, there were no brakes. Then, as he rode down the street, three blocks later the brakes came back and the emergency brakes handle was up.
Experienced total brake failure prior to/after recall repairs (96v075/074). *ak
Abs brakes failed 3 times, brake pedal dropped almost to the floor and felt spongy for a little while.
The master cylinder is empty because there's a crack in it which caused a complete brake failure. The pedal goes to the floor before the vehicle is stopped. *ak
Related recalls
Service brakes, hydraulic: foundation components: master cylinder
- What is wrong
- The brake master cylinder can leak brake fluid due to a damaged double lip rear piston seal.
- Risk
- Brake fluid leakage can result in diminished effectiveness of one half of the split brake system. The instrument panel warning light(s) will signal system impairment prior to partial brake system loss.
- Remedy
- Dealers will replace the rear brake master cylindr piston assembly.
Recall number 96V075000 · Recall details
Service brakes, hydraulic: antilock/traction control/electronic limited slip
- What is wrong
- Corrosion of the ABS hydraulic control unit can cause the solenoid valves to stick in the open position.
- Risk
- If either front wheel valve sticks, the vehicle would swerve from a straight stop when the brakes are applied.
- Remedy
- Dealers will install a plate and silicone grease injected into the solenoid cavity to eliminate the potential for this condition.
Recall number 96V074000 · Recall details
Questions about the 1996 Chrysler Cirrus brake failure
Is brake failure a common problem on the 1996 Chrysler Cirrus?
6 of 160 owner complaints about the 1996 Chrysler Cirrus (4%) mention brake failure. The model year with the most reports is 1995.
Is there a recall or service bulletin for this on the 1996 Chrysler Cirrus?
There are 2 recalls and 0 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 1996 Chrysler Cirrus
VIN decoder
See the problems and recalls for an exact car
Buying a used 1996 Chrysler Cirrus?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history