1995 Chrysler Concorde suspension problems

Filed May 25, 2008 · Steering, Suspension · 62,874 miles · CA

1995 chrysler continuing steering and alignment problems.

Filed Nov 19, 2002 · Suspension · PA

Consumer states that when braking and without warning the front-end bracket snap causing the consumer to pull over. Dealer notified.. Ts

Filed Feb 21, 2002 · Suspension · IL

On several occasions, vehicle exhibits an intermittent shudder condition when driving between 10 - 20 MPH, manufacturer notified.

Filed Jan 16, 2002 · Acceleration, Engine · SC

When putting gear lever into drive the engine revs, and the transmission will not come out of first gear, vehicle will not drive properly anymore.*ak consumer states engine light comes on and vehicle shakes like it is going to come apart.

Filed Jan 12, 2001 · Suspension · FL

A loud clunking noise and a loss of handling was experienced when braking and turning the car/ loss of control of the car seemed possible.

Filed Mar 9, 2000 · Electrical, Steering · MO

Steering pump failed. Nlm

Filed Jan 2, 2000 · Suspension · MO

Problem: lower control arm bracket separates from engine cradle, causing half-shaft to pull out of transaxle. Fix: reinforce engine cradle at control arm bracket.. Vehicle owners were supposed to be notified in dec. Of 1999. I was not notified. I found this in michigan business briefs. Sept. 18 , 1999. I would like to see some action on this, because I want to keep this car a while longer. Thank you.

Filed Dec 28, 1999 · Suspension, Transmission · MO

Recall -problem lower control arm bracket separated from engine cradle, causing half-shaft pulled out of transaxle. Fix: reinforced engine cradle at control arm bracket.

Filed Dec 9, 1999 · Engine, Fuel system · PA

Front end struts wre replaced after reporting clunking noise in front end when car was placed in reverse. One year later, while enroute from pennsylvania to washington on vacation, the steering broke when backing out of a parking space in an underground parking lot in south bend, in. Rack and pinion was repaired by dealership in south bend. Started to smell gas fumes in vehicle while driving to washington. Tried to get repairs in south dakota but was unable to find a dealership who would repair it. Located dealership in pasco, washinton torepair the fuel line which was not connected properly after rack repair, as I was told by dealer. Battery exploded while in parking lot at local mall. Air conditioner started emitting musty smell. Had air conditioner charged twice and it still doesnt seem to hold a charge. Car would not start on 12/3/1999. Thinking it was the battery, tried to jump the car but was told by mechanic that it sounded like it might be the timing belt. Now I find the water pump leaked which may have caused a blown gasket. Mechanic reports little compression in three cylinders and 1500.00 estimate for repair.

Filed Jun 8, 1999 · Brakes, Steering · TX

Problem seems to start with the transmission clunking then eventually you will start to hear a popping noise in your front end, coming from the tie rod. Thought this was a suspension problem but took to dealer the first time and they replaced my brakes and serviced transmission. Cluncking noise still existed when you let off the gas and the slightly accellerated. Turns out the tie rod, transmission mount and axle were to blame. Can't tell you about the axle as they told me they would replace but did not show up on repair. I know that there seems to be serious problem with the drive train and suspension in the car. As for the dip stick, the heat created by the engine is cooking the plastic in the colored dipstick to the point it just falls apart. I recently had the tie rod and transmission mount replaced and now have a much worse cluncking noise the same day of the replacement...can I get some help as I feel this car is a serious problem waiting to happen..