Chrysler Crossfire stalling problems

Filed Jul 20, 2017 · Engine · 141,000 miles · FL

Tl* the contact owns a 2004 chrysler crossfire. The contact stated that while driving at various speeds, the vehicle stalled without warning. The vehicle was not able to restart. The vehicle was towed to unknown dealer where the failure was undetermined. The manufacturer was not notified of the failure. The approximate failure mileage was 141,000. The VIN was not provided.

Filed Jan 11, 2017 · Electrical · 79,000 miles · SC

Tl* the contact owns a 2004 chrysler crossfire. While driving various speeds, the vehicle stalled and also failed to start on several occasions. The failures recurred intermittently. The vehicle was taken to an independent mechanic, but the cause of the failure was unable to be determined. The manufacturer was notified of the failure. The failure mileage was 79,000.

Filed Nov 3, 2016 · Engine, Visibility · 61,000 miles · DC

Tl* the contact owns a 2005 chrysler crossfire. The contact stated that while driving at 30 MPH, the vehicle stalled without warning. In addition, the rear window fractured and became loose from the hedges. The vehicle was taken to be repaired but the details were unknown. The manufacturer was not made aware of the failure. The failure mileage was 61,000.

Filed Aug 1, 2016 · Engine · 118,000 miles · VA

I was driving 70 MPH on i81 when my 2010 chrysler crossfire simply stopped running. I was beside a truck with one in front and 3 behind. Barely made it to the side of the road and caused a lot of breaking and honking. The 5th time this has happened, and was extremely dangerous.... The crossfire does not start after the engine stalls and the steering wheel locks up. I'm amazed that I made it out alive each time. Have spent $1800 trying to have it fixed but the chrysler dealership doesn't know what the problem is. This is ridiculous

Filed Jun 16, 2016 · Electrical, Engine · 23,000 miles · MD

At 50 MPH on a maryland state highway, the engine unexpectedly shut off resulting in the vehicle coasting to a stop in the traffic lane (there was no shoulder). Fortunately, I was not struck by another vehicle, but it was dark and vehicles coming over a small hill and slight curve had to take evasive action to avoid a collision. The engine would crank and start briefly and then sputter to a stop. Or, it would just crank and not fire or not crank at all. I was eventually, with assistance, able to push the vehicle off the roadway into a residential driveway. I had the vehicle towed to my residence for further diagnosis. The vehicle would later start and run normally for a short period, but then was plagued by a large list of issues to include: malfuncitoning indicator lights illuminated - brake light, brake wear indicator, traction control, stability control; p0600 data link loss code; vehicle not shifting out of park; speedometer not working, etc. Eventually, the engine would no longer crank at all. All issues were remedied by replacing the relay control module (rcm) - a part that was, and still is, manufactured by stribel. This part has know issues related to poorly soldered connections that cause no-start conditions or cause the vehicle to stall while operating. The rcm is also plagued by failure of the internal relays (engine control, fuel pump, traction control, secondary air pump) themselves which may be hastened by overheating as a result of the poor solder joints. If it has not already happened, someone is going to be seriously injured or killed when their chrysler crossfire (or any one of a number of mercedes benz vehicles utilizing the same stribel relay) stalls due to this widely know defect and is struck by another vehicle.

Filed Dec 15, 2014 · Transmission · 123,000 miles · FL

Tl* the contact owns a 2004 chrysler crossfire. While driving 30 MPH, the engine stalled without warning. The vehicle was taken to a dealer where it was diagnosed that the transmission needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 123,000.

Filed Sep 21, 2014 · Fuel system · 89,679 miles · FL

While driving on 08/17/14 my crossfire suddenly stalled and would not restart. I had to have the vehicle towed to a local chrysler dealer for repairs. The following repairs were needed: fuel pump #14073001 filter fu #14029003 relay non #08052328 these seem to be the same parts recently recalled on jeep vehicles. Will chrysler add my crossfire to the recall list? What can I do?

Filed Jul 6, 2014 · Brakes, Engine · 153,000 miles · LA

After driving 30 miles without problems engine stalls. Attempts to start it failed but when key is in on position not start position starter engages. Attempted several times and each time key turned on starter engaged even without clutch depressed which is normally required, even in gear with clutch released starter engaged. Have yet to get engine started tho condition continues. Towed car home to my shop where im investigating this issue.

Filed May 15, 2014 · Engine · 90,000 miles · GA

Tl* the contact owns a 2004 chrysler crossfire. The contact stated while driving approximately 65 MPH, the vehicle suddenly stalled. The contact indicated that the defect recurred on multiple occasions. The failure was not diagnosed nor was the vehicle repaired. The manufacturer was not notified of the defect. The failure mileage was 90,000. The current mileage was 130,000.

Filed Apr 23, 2014 · Engine · 26,000 miles · MO

Tl- the contact owns a 2004 chrysler crossfire. The contact stated that while driving approximately 50 MPH the vehicle suddenly stalled. After restarting the engine the vehicle operated as normal. The contact indicated that the defect had occurred on multiple occasions. The vehicle was not diagnosed or repaired. The manufacturer was not notified. The failure mileage was 26,000. Jft