No summary listed for above vehicle.
1994 Chrysler LHS brakes complaints
Page 2 of 2: complaints 11 to 34 of 34, newest first, as owners wrote them.
Consumer was driving approximately 35 MPH when applied the ABS, and pedal went to the floor. Vehicle rear ended a honda, and driver 's side air bag did not deploy. Passenger's side air bag raised up, but did not come out.
Front end suspension out of alignment. Mjs
We are not satisfied with the reliability and performance of the original and replacement parts on a chrysler lhs we purchased new in 19994. The following are the high failure parts and systems on the car: 1. Water pump and associated parts (2 times) . It has failed twice, the first time was at 59,559 miles when it froze up and took the timing belt with it. The second time the pump developed a leak at 102,275 miles, which was 42,716 miles on the replacement pump. 2. Disc brakes and associated parts (2 times and need to be turned again). The rotors warp due to overheat from the brake pads. The first time the rotors were turned at 56,441 miles and then again at 84,347 miles. Right now the car has 102,750 miles and the rotors need to be turned again. 3. Airconditioning system and associated parts (2 times). The airconditioning system evaporator coil leaked at 62,299 miles, but was covered by an extended warranty. The evaporator coil is leaking again at 102,750 miles and is not covered by warranty. This is a very expensive procedure in that the dashboard has to be removed. 4. Fuel rail and associated parts (1 time). Due to a strong gas smell the fuel rail was replaced. When the dealer insisted that the problem wasn't covered by warranty, we paid to have the problem fixed. We were later reimbursed by chrysler when we called their customer service.
Our traction controll went out in december of 1997 and then our ABS went out. After the dealer made repairs under warranty our car never seemed to run the same again. Very sluggish and the transmission appeared to slip at times. Took it back in march 1997 and was told there was a problem with a electrical module for the ABS. Never were told of a recall. After that the card got terrible fule mileage and the transmission started to lock in second gear at times. When you turn the car off and re start it would be fine. We out it back in the shop three more times before I finally got it to lock into second gear and I drove it to the shop. The problem was fixed but we are still getting very bad fuel mileage. Had the fuel rail fixed for a leak on recall but still having bad fuel mileage. The transmission is still acting up. We are taking it back in again but the dealer doesn't feel there is a problem. When the dealer was repairing the fule rail they told us that they blew out a piston. Had to leave the car to rebuild the engine. Dealer did give us a rental car and have been very good to us. This car has too many problems and will be sold, no more chryslers in this family.
Fuel o-ring failed prior to recall repair work causing fuel leakage, not able to perform recall repair due to lack of parts. (98v‑184)
Dealer said computer for ABS and traction control malfunctioned.
1. Headlight focus and illumination has been very poor, no solution seems to be available. 2. Front disk brake rotors warped at the first hard application of the brakes. Dealer attempted repair four or five times and when they would no longer honor the warranty took the vehicle to an independant shop and they finally fixed the problem. 3. Twice the right driver's seat back hinge has failed when the driver sat back. Repair accomplished by independent shop. 4. After noticing a strong smell of gasoline, discovered fuel leaking from the front of both left and right fuel injection rails. Vehicle has been taken to the dealer for repair but seems that there is a long waiting list for the repair parts which are back ordered.
This is the 3rd set of disc brake rotors. The rotors can only be refaced one time. They warp, due to heat. The heat generated is uneven, causing the warping, because the brake disc pads are unequal in size, by design. Chrysler is purposely designing failure into its components. The unequal sized brake pads are not necessary as there is adequate room for equal sized pads. All lhs chryslers should be recalled and repaired at manufacturers expense, requiring them to redesign the brake pads to prevent unequal heating of the rotors. It is high time that chrysler be made to answer for their engineered failure of safety components.
The brakes stick intermittantly.
Brake pads and rotors failed.
Vehicle would not shift into park (would only go as far as neutral) and engine could not be turned off. Emergency brake was applied and had to be released manually. When released the vehicle suddenly accelerated crashing before it stopped. Fuses had to be disconnected in order for engine to shut off. Consumer was injured in this accident. Vehicle experienced an engine malfunction, the alternator belt burned, causing engine to smoke and stall. Battery failed. Turn signals did not work. Tires were out of balance and caused vibration. Transmission experienced vibration, gears malfunctioned, a code revealed a problem between the transmission control module and the powertrain module under heavy acceleration, consumer was informed this was possibly caused by a sticky throttle position sensor. Brakes experienced vibration due to brakes being out of round, the front brakes and front rotors were replaced.
Small fuel leak, few days later all the warning lights came on.
When driving the vehicle and coming to a stop have to pump the brakes several times before the vehicle would stop. *ak consumer stated the inside of brake pads were disintergrated so that when the brakes were applied the right side exploded leaving a gap between rotor and metal braking of pad, thus it took several pumps pf pedal to close gap and allow brakes to work, there was no warning of the pads going bad since the outside pads of both sides were next to new condition and they are the one with squealer.
Brakes failed.
Brake rotors failed, causing klunking noise when brakes are applied.
Abs, brake failure, failure of disc rotors on the front, causing extended stopping distance and vibration. Applied the brakes, extended stopping distance, impact 12:00 position, speed 45mph.
Put vehicle in park it would only go as far as neutral, turned off ignition in all position, engine continued to run. The key was removed, emergency brake to close to floor to engage appropriately, than the brake released fully and the vehicle accelerated fully.
At 21,000 miles the rotors are warped, need to be replaced . Please describe .
Engine arbitrarily loses power/cuts out, driver loses power steering and power braking, completely unpredictable at any speed.
Abs computer failed.
Abs, brake failure, front rotors and pads continue to waro, replaced every 12,000 miles
During the snow the ABS system would go out and not stop the vehicle. Please describe.
Abs braking systems. Please describe. Tt
VIN decoder
See the problems and recalls for an exact car
Buying a used 1994 Chrysler LHS?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history