Check a VIN

1995 Chrysler New Yorker steering problems

14 complaints (24% of all complaints for this car).

owner complaints
14
of this car's complaints
24%
crashes
0
recalls
0

Which part fails

  • Linkages
    5
  • Rack and pinion
    3
  • Linkages: tie rod assembly
    3
  • Hydraulic power assist system
    2

At what mileage

Complaints by mileage at the time of the problem.

0k-25k
25k-50k
50k-75k
75k-100k
100k-125k
125k-150k
150k-175k
175k-200k
200k+

Chrysler New Yorker steering problems in other years

1990199119921993199419951996

Related recalls

No recalls on record for this model year.

Related investigations

Steering column separationOpened May 7, 2003, closed July 22, 2003

Mr. Larry a. Sackey submitted a petition to the federal safety agency by letter dated april 18, 2003, requesting that agencyfurther investigate the defective collapsible steering shaft system on 1987-1995 vehicles manufactured by the daimlerchrysler corporation.in part because of 49 cfr ? 30120(g), the federal safety agency has decided to limit the scope of the petition vehicles to 1993-1995 models, excluding the 1993 jeep grand cherokee and 1994-1995 dodge ram series trucks that were recalled (93v210 & 96v230) for steering column failure.if the analysis of these vehicles had identified a potential problem, the scope could have been expanded in an investigation.a review of odi's data base shows no recent complaints and a lack of a complaint trend concerning the subject issue on the subject vehicles as a whole or by individual models.therefore, the petition is denied.for details, see federal register notice volume 68, no. 130, july 8, 2003.

DP03002

Steering system rack and pinionOpened October 29, 1999, closed September 13, 2001

There is no summary currently available

EA99031

Steering system rack and pinionOpened June 28, 1999, closed October 29, 1999

Since opening the preliminary evaluation (pe), odi has received 6 additional complaints.during the pe it was determined multiple failure modes are involved in this matter.the warranty claim rate is high for a steering system concern.the issues reported involve premature wear out at the rack and pinion interface with the inner tie rod end(s), binding and sticking of the steering gear, cracked or broken tie rod ends, sheared rack and pinion assembly bolts, and wear out of the rack and pinion mount bushings.many of the complainants mention steering wonder and loose steering.three of the most recent complaints allege a complete loss of steering due to sheared bolts.odi is upgrading this pe in order to perform a thorough technical analysis of the various system failure allegations and to quantify the effect that these failures have on vehicle control.

PE99044

What 1995 Chrysler New Yorker owners say

Most recent owner complaints, unedited.

Filed Nov 19, 2008 · Steering · 135,000 miles · GA

Complete steering failure on 1995 chrysler new yorker.

Filed Apr 25, 2003 · Steering · 32,427 miles · CA

While traveling at normal speed, the driver applied the brakes and the front end of the vehicle vibrated out of control. The steering was very loose.

Filed Aug 28, 2001 · Steering · TX

Both inner tie rod bushings and attached rods had to be replaced, the right side had failed and fallen out(rubber bushing), the left side bushing was fractured and worn out causing play in the right side wheel steering, both items were replaced and wheel alignment done.

Filed Aug 23, 2001 · Steering · OH

While backing out of a parking place the two bolts that hold the short rack to the frame sheered off at the frame causing complete loss of steering. The new bolts obtained from chrysler were gold in color instead of black like the originals which indicated to my mechanic that the new ones had a different heat treating process. I have the bolts and pieces plus pictures of same and will provide either upon request. Had I not been in a parking lot this could have been a desaster. While I have received other recall notices for this car I never received one on this.

Filed Jun 29, 2001 · Steering, Suspension · AZ

Steering noise when turning wheel left to right, bushings are bad and rack and pinion needs replaceing according to mechanic said such wear is unusually for car with such low miles - dealer, maker aware of problem said it will not do anything unless a recall is forced on them - lose of steering is a safety issue

Filed May 30, 2001 · Steering · NC

Steering failure because bolts have sheared off. Consumer stated that tie rods has been replaced twice prior to this incident.

Filed Oct 24, 2000 · Steering · PA

Consumer was at a gasoline station. As he pulled out heard a noise, and lost control. There wasn't any steering. Steering wheel was going around in circle. Dealership was notified, there were no injuries. *ak the loss of control of the vehicle was caused by snapping in half of the bolt that hold the steering rack together. This vehicle had been involved in accident before this customer purchased it.

Filed Oct 4, 2000 · Steering · KS

Both tie rod ends at steering gear box replaced. Failure due to wear of rubber bushings part no. 501825aa. This should be considered a dangerous situation which could lead to accidents , especially at highway speeds. Reported failures believed to be more numerous than chrysler will admit. See oid; id 8449555 8/1/99, id 716813 1999, id 852875 10/29/99, id 715247 at 59,000 miles 9/1/99. Cost to repair $589.00.

Filed Mar 28, 2000 · Steering · LA

It is extremely hard to steer when turning a corner. Dealer said consumer needed to replace rack and pinion steering. Consumer claimd it's dangerous to drive on the street.

Filed Jan 3, 2000 · Steering · VA

Componant failure was the two bolts that secure tie rods to rack and pinion steering sheared off, both at the same length. This happened while backing out of a parking space. In turn, both tie rods, one to each wheel became totally disabled and all steering was lost. Removed the rack and pinion and foind no defects with operation. Replaced with a remanufactured one with new bolts from the dealer. Cause remains undetermined.

Questions about the 1995 Chrysler New Yorker steering

Does the 1995 Chrysler New Yorker have steering problems?

Owners have filed 14 complaints about the steering of the 1995 Chrysler New Yorker, 24% of all its complaints, more than any other problem.

At what mileage do 1995 Chrysler New Yorker steering problems start?

Not enough complaints include the mileage to tell.

Was there a recall on the 1995 Chrysler New Yorker steering?

There is no recall for this problem on this model year.

What year does the Chrysler New Yorker have bad steering?

The Chrysler New Yorker model years with the most steering complaints are 1994 (22 complaints), 1995 (14 complaints) and 1991 (12 complaints).

Other 1995 Chrysler New Yorker problems

Fuel system 10Brakes 9Transmission 7Engine 5Suspension 5Electrical 4Lights 3Visibility 3Acceleration 2Airbags 2Body 1Tires 1

VIN decoder

See the problems and recalls for an exact car

Buying a used 1995 Chrysler New Yorker?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history