Check a VIN

1998 Chrysler Sebring suspension problems

26 complaints (10% of all complaints for this car). Typical mileage when it fails: 129,000. 6 crashes reported.

owner complaints
26
of this car's complaints
10%
typical mileage
129,000
crashes
6
recalls
1

Which part fails

  • Front
    7
  • Front: control arm: lower ball joint
    5
  • Rear: axle: non-powered axle assembly
    2
  • Front: control arm: upper ball joint
    2
  • Front: control arm: lower arm
    2
  • Multiple axle
    1

At what mileage

Complaints by mileage at the time of the problem.

0k-25k
25k-50k
50k-75k
75k-100k
100k-125k
125k-150k
150k-175k
175k-200k
200k+

Chrysler Sebring suspension problems in other years

1995200020052010

Specific symptoms reported on the 1998 Chrysler Sebring suspension

Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.

Ball joint 16

Related recalls

Suspension: front: control arm: lower ball jointReported December 18, 2000 · 393,796 vehicles affected
What is wrong
Vehicle description: passenger vehicles. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water can intrude. Also, mmc has added the potential of leaking moisture, which can cause the ball stud to corrode.
Risk
This condition could cause the lower lateral arm ball joint to separate, increasing the risk of a vehicle crash. This campaign supercedes mmc's previous safety recall campaign, see 99v‑066.
Remedy
Dealers will inspect the lower lateral arm ball joint for wear. Ball joints that exhibit wear beyond the established tolerance will be replaced with newly designed lateral arm ball joints. Ball joints that are within the established tolerance will be cleaned and a special sealant will be applied to prevent intrusion of moisture.

Recall number 00V421002 · Recall details

What 1998 Chrysler Sebring owners say

Most recent owner complaints, unedited.

Filed Jul 20, 2015 · Suspension · 140,000 miles · KY

Tl* the contact owns a 1998 chrysler sebring. While driving approximately 20 MPH, the front driver side tire detached. The vehicle was towed to an independent mechanic who diagnosed the lower ball joint and axle failed. The vehicle was repaired, but the failure recurred. The vehicle was taken back to an independent mechanic who diagnosed that the lower arm control, lower ball joint, tie rod, and axle failed. The vehicle was not repaired. The manufacturer was made aware of the failure. The approximate failure mileage was 140,000. The VIN was not available.

Filed Aug 25, 2014 · Suspension · 44,000 miles · VA

History of failed attempts of dealer [ whitten brothers, richmond,va ] to diagnosis this problem and correct it. Problem is a harsh noise coming from the front [under ] the car when a road pot hole or imperfection [substantial ] is run over. The noise is pronounced , indicating some type of defect must be present. The last time I was there at whitten bros [5/2009] the recall which would have corrected this was not issued yet... Recall announced below ..I was never notified. I am the original owner and should have been notified of the recall by certified mail. Recalled announced 12/27/2010 by the federal safety agency. The federal safety agency reference # 10e059000 number affected : 22,689 suspension : front : control arm : lower arm federal-mogul : recalled replacement control arm assemblies parts #. K7425 , 10945 , fa4510x...and k7427 , 10946 , fa4611x note : these parts can fail causing the ball stud to wear thru the control arm housing resulting in noise and or separation of the ball stud from the control arm housing. Resulting in the driver loosing steering control..car can crash .at any speed. Federal-mogul was to notify me and replace affected parts free of charge. Safety recall began 1/ 28 / 2011 call federal-mogul to verify this situation immediately..1‑877‑489‑6659. Safety requires this situation is rectified as soon as possible.. Thank you in advance for your assistance in this matter.

Filed Aug 25, 2014 · Suspension · 44,000 miles · VA

History of failed attempts of dealer [ whitten brothers,richmond,va ] to diagnosis this problem and correct it. Problem is a harsh noise coming from the front[under ]the car when a road pot hole or imperfection [substantial ] is run over. The noise is pronounced , indicating some type of defect must be present.. The last time I was there at whitten bros the recall which would have corrected this was not issued yet... Recall announced below ..I was never notified ,,I am the original owner and should have been recalled... Recalled announced 12/27/2010 the federal safety agency reference # 10e059000 number affected : 22,689 suspension : front : control arm : lower arm federal-mogul : recalled replacement control arm assemblies parts #. K7425 , 10945 , fa4510x...and k7427 , 10946 , fa4611x note : these parts can fail causing the ball stud to wear thru the control arm housing resulting in noise and or separation of the ball stud from the control arm housing.. Resulting in the driver loosing steering control..car can crash .at any speed. Federal-mogul was to notify me and replace affected parts free of charge. Safety recall began 1/ 28 / 2011 call federal-mogul to verify this situation immediately..1‑877‑489‑6659 safety requires this situation is rectified as soon as possible.. Thank you in advance for your assistance in this matter [xxx] information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6).

Filed Aug 24, 2014 · Suspension · 44,000 miles · VA

History of failed attempts of dealer [ whitten brothers,richmond,va ] to diagnosis this problem and correct it. Problem is a harsh noise coming from the front[under ]the car when a road pot hole or imperfection [substantial ] is run over. The noise is pronounced , indicating some type of defect must be present.. The last time I was there at whitten bros the recall which would have corrected this was not issued yet... Recall announced below ..I was never notified ,,I am the original owner and should have been notified with a recall letter. Recalled announced 12/27/2010 the federal safety agency reference # 10e059000 number affected : 22,689 suspension : front : control arm : lower arm federal-mogul : recalled replacement control arm assemblies parts #. K7425 , 10945 , fa4510x...and k7427 , 10946 , fa4611x note : these parts can fail causing the ball stud to wear thru the control arm housing resulting in noise and or separation of the ball stud from the control arm housing.. Resulting in the driver loosing steering control..car can crash .at any speed. Federal-mogul was to notify me and replace affected parts free of charge. Safety recall began 1/ 28 / 2011 call federal-mogul to verify this situation immediately..1‑877‑489‑6659 safety requires this situation is rectified as soon as possible.. Thank you in advance for your assistance in this matter [xxx] information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6).

Filed Oct 28, 2012 · Body, Engine · 131,000 miles · NY

I purchased a 1998 chrysler sebring lxi the car has numerous problems, one is the control arm in the vehicle. This is a list of other evac problems - I was told that there was a recall on my vehicle for various problems - please advice - need help - called chrysler dealerships and first they said my vehicle was not affected - then they tell me they can charge me $149.00 to reset the computer catalyst(g)/nmhccatalyst(d) evaporative system(g)/ unsupportive(d) 02 sensor(g) exhaust gas sensor(d) 02 sensor heater (g) pm filter (d) egr/vvt (g,d) po455 evaporative emission system leak detected (large leak) my headlamps are yellow and my rear window looks like there is some kind of mold sandwiched into the glass and defrost...almost impossible to see out of at night.

Filed Oct 20, 2010 · Suspension · 130,000 miles · IA · 1 injury

1 very little notice just heard some squeaking 2 the failure was the tire buckled causing us to lose control 3 still needing repair.

Filed Aug 31, 2010 · Suspension · 156,000 miles · MI

Tl* the contact owns a 1998 chrysler sebring. The contact was driving 15-20 MPH when the front driver side lower ball joint fractured from the vehicle causing the wheel to also separate from the vehicle. The contact stated that the front suspension was problematic but had not experienced any incidents that presented a safety risk. The vehicle was repaired. The VIN was not available. The current and failure mileage was approximately 156,000.

Filed Mar 11, 2010 · Suspension · 142,000 miles · WI · crash · 2 injuries

Information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6) the federal safety agency campaign id number 00v421002 make chrysler / model sebring / year 1998 [xxx] recall number 967 front ball joint fell apart and almost killed both of us . We were never notified by chrysler there was a recall on this vehicle or we would have had it looked at immediately .

Filed Dec 3, 2007 · Suspension · 90,000 miles · TN

Tl*the contact owns a 1998 chrysler sebring. The front driver side wheel nearly detached from the vehicle while driving 45 MPH. The contact heard a horrible grinding noise underneath the vehicle and then the steering wheel jerked. She depressed the brake pedal and managed to stop the vehicle. She then noticed that the wheels were mostly out of place. She called the dealer and they notified her of a recall for the same failure that her vehicle was experiencing. The dealer stated that the vehicle had been previously repaired and could not be repaired again. The contact stated that the vehicle had never before been repaired. The failure and current mileages were 90,000. Updated 01/03/08. *lj recall# 00v421002 the dealer informed the consumer there was a recall on the lower ball joints, however it had already been fixed on the vehicle. Updated 12/31/07.

Filed Jun 27, 2006 · Suspension · 171,000 miles · LA · crash

This owner''s ''98 chrysler sebring was serviced for remedy relative to recall campaign 04v‑421-002 at approximately 160,000 miles. At approximately 171,000 miles the lower lateral arm separated from the ball joint at low speed (20 '' 25 MPH). Owner stated that after action inspection found the joint dry (no lubrication) & pitted. ''it wore to the point where it popped out of the socket.'' there were no injuries as a result of the incident. Damaged systems include, half-shaft, wheel, tire, fender, front fascia and possibly transmission. Chrysler is currently inspecting vehicle.

Questions about the 1998 Chrysler Sebring suspension

Does the 1998 Chrysler Sebring have suspension problems?

Owners have filed 26 complaints about the suspension of the 1998 Chrysler Sebring, 10% of all its complaints.

At what mileage do 1998 Chrysler Sebring suspension problems start?

The typical (median) mileage in owner complaints is 129,000 miles.

Was there a recall on the 1998 Chrysler Sebring suspension?

Yes, 1 recall: 00V421002. Check your VIN to see if your car still needs the free repair.

What year does the Chrysler Sebring have bad suspension?

The Chrysler Sebring model years with the most suspension complaints are 1996 (70 complaints), 1995 (46 complaints) and 2002 (37 complaints).

Other 1998 Chrysler Sebring problems

Body 65Brakes 35Acceleration 23Wheels 22Engine 21Transmission 21Airbags 19Electrical 16Visibility 16Tires 14Steering 13Seat belts 11Fuel system 9Locks 7Lights 3Seats 2

VIN decoder

See the problems and recalls for an exact car

Buying a used 1998 Chrysler Sebring?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history