I've had to replace the battery in this 3 times. Alternator 1. And Throttle Body Position Sensor twice. And now it's all starting to act up again. Car stalls, no reason, all dashboard warning lights flash and it stalls. No dashboard lights at night. Occasionally they flicker. Windshield wipers either won't work or won't shut off. Front windows are unusable, the track broke and back windows don't have power to make them work. Airbag and abs lights always flashing on dash and warning bell goes off all the time. Now my High beam wires have completely crumbled and radio takes 5-10 minutes to come on. Obviously a major electrical issue. I've lost my job thanks to the "reliability" of this money pit. Owned 3 years, problems began then. Today all lights are flashing, the air starts blowing high, wipers go on. I stop at light and it shuts off. Had to push off busy road. Waited half hour and it started, but now check engine, air bag, throttle body and seat belt lights all on. Very slowly, with many breaks, drive home & car smells like burning rubber. Visually can't find source. All fuses are good, and brand new battery last week.
Chrysler Sebring abs comes on
38 of the 2,832 owner complaints about the Chrysler Sebring describe aBS light or ABS activating, most of them for the 1995 model year.
- owner complaints
- 38
- worst model year
- 1995
- typical mileage
- 36,000
By model year
Often reported together
Premature wear 5Brake failure 5Grinding brakes 4Stalling 3Adaptive cruise 3Jerking 2Headlights 2No deployment 2
Trouble codes mentioned
C1044 1
What owners say
Engine frequently stalls while driving. I've had my car shut off while I'm driving many times, the steering wheel and brakes lock up and it makes it hard to get off the street to safety. This happens a LOT. It is very dangerous and scary. I get anxiety everytime I drive because I'm scared of it happening again. My car once turned off in the middle of a busy intersection while trying to turn. It came on after about 45 seconds but it was terrifying. Battery often dies (just replaced it). Horn would go off randomly without stopping for a long time. I had to disconnect the horn (on both sides) because it would keep randomly going off with no way to stop it. Cruise control stopped working one day. Sometimes it comes up when I press cruise control but it turns off when I try setting a speed. Drivers window broke inside, I think something snapped inside the door. I've had it replaced 3 times but it keeps breaking. A/C makes an awful grinding noise sometimes, but it goes away if I turn the A/C off then back on. Also with the A/C, a door or something inside the dash will get stuck every so often and it makes a LOUD clicking like noise but it goes away after about 20 seconds (something to do with the actuator?). Brake light will come on sometimes when I stop. It goes away shortly after I start driving again. ABS light has been on my dash for a few months now. Most of these issues have been happening for over a year now. Most of this shows up under a recall from 2008, ELECTRICAL SYSTEM: WIRING. It doesn't show up under my VIN number but I'm having the same exact problems.
There were 7 recalls on my make, year, model vehicle. Three of which were Brakes, Air Bags, and the TPMS tire monitoring system. Other body parts, doors and hood releases had recalls along with hvac/air conditioning systems. Radiator/fan motor failures. Doors flying open during transit. The ABS control module could cause the brakes to lock-up during braking. Shorts from unused connectors for the computer/TPMS system/brakes and air bags have been causing many unpredictable breakdowns. Some predictable, from past records, state recorded Instances from 180,963 vehicles that just failure of the TPMS monitor system has already caused engine no start, dead battery, Inoperable cruise control, remote start system, engine stalling which could cause a "crash without warning". This was what i read on the www.autoblog site concerning this vehicle. I contacted the Chrysler Recall Center and the site says the dealer's techs would seal the wiring "free of charge", and to replace the front seat track position sensors "free of charge". The recall center said they wouldn't do any repairs at their "free of charge" policy for ME. They said that I would have to pay out-of-pocket, when the site says they already serviced 180,963 vehicles "free of charge". I'm broke and on fixed income. Why are they being so unfair. From what I heard, and I could be wrong, but I was made to believe that there is no expiration date for recalls. If they already state online, some of the recalls could cause a "crash without warning", why would they refuse me? This happened yesterday to me. The Check TPMS System warning notice appeared, along with the Air Bag Red warning light at the top of the speedometer, while I was driving. The tire pressure screen appeared showing the tire pressure of the four tires. They are all fully Inflated. The Air Bag red light came on/off a few times, while driving home and the tire pressure screen remains on all the time. I don't want an accident.
Tl* the contact owns a 2007 chrysler sebring. The contact was driving 20 MPH when the brakes failed when applied. The ABS warning light illuminated during the failure. The vehicle was not taken to the dealer. The manufacturer was not contacted. The vehicle was not repaired. The failure mileage was 84,500 and the current mileage was 84,643.
This car shuts off, all the light so on and off and this has been happening since it was less than a year old. We have taken it to chrysler dealership and they have said it didn't happen when they had it. The interior light comes on when you turn on right turn signal. The ABS light goes on and off and the seatbelt light.
Multiple issues with this vehicle. The latest one is the most serious. A faulty ABS sensor cause the brakes to operate abnormally. The ABS light may come on then go off and (periodically goes on and off). Regardless of the light status, the ABS system randomly engages and does not allow the vehicle to stop in a safe manner. The ABS when engaged resists the driver from apply pressure to the brake pedal. The result is the car not stopping. Luckily I was going slow and there was no one around other wise there would have been an accident. The ABS light came on, resisted my braking force then went off and allow the brakes to engage as anticipated. The roads were normal, dry and free of debris/ loose fill. This happened twice over two days. On the second day I parked the car and let it sit until it's service date. The service department diagnosed a faulty sensor with code c1044. They said it was due to rust. First this is a 2007 car, second if rust on a sensor is going to inhibit normal braking then the part is defective and or the design is defective. I was lucky some one else is not going to be. Abs is designed to pump the brakes under certain conditions. I'm sure normal driving at 25 MPH on a dry normal surface isn't one of them. Even if the ABS fails the operator should still be able to stop the car by applying manual force to the brake petal. This failure does not allow effective use of the brakes! Second issue is the lights (both interior and exterior dimming) with audible surges in the climate control blower. The dealer says this is due to my remote starter even though this issue has been occurring well before the remote starter was involved. Third issue is the rear window repeatedly coming out of track there were other issues with the brakes rotors warping and brake light coming on, gas cap light coming on, tire sensors
Letter from senator brown on behalf of constituent regarding issues with his 2007 chrysler sebring )dot/I#2010-1253-respond to cleveland, oh office *tgw the consumer stated he was unable to shift the gear out of park. The ABS light illuminated and stayed on and the brakes would not work until the vehicle was driven about a block. He had to drive very slow until the brakes engaged.
My 2007 chrysler sebring caught on fire. Smoke was coming from the dashboard and steering area. The ABS light came on after the smoke. (ps there were no physical injuries, but mentally it's frightening, we're terrified to get back into that car! Mentally 2 persons were injured.
Intermittent ABS and traction control warning light illuminate during drive pavement conditions. Have taken this to dealership and they say this is normal. Found real notice (campaign 06v493000). Apparently they still can not get this corrected with this recall. The dealership has had this vehicle twice for the same problem. When this happen the ABS engages and it almost pulled me off the road it was braking so hard!
Tl*the contact owns a 2007 chrysler sebring. While driving 40 MPH, the vehicle shakes. The brakes fail to work properly and feel as if they are tapping on something when the pedal is depressed. When the contact turns the vehicle, there is a rubbing sensation. In addition, the cruise control does not work. The contact could not control the vehicle because it accelerated on its own. The ABS light illuminated on the instrument panel. The contact received a recall notice for the tire pressure monitoring system and electrical connectors and the vehicle was repaired. The dealer stated that the vehicle was not under warranty due to the recall that was issued. The vehicle will only be repaired at the contact's expense. The vehicle was diagnosed as having electrical failure. The federal safety agency campaign id number was unknown. The failure mileage was 44,751 and the current mileage was unknown.
Related recalls
Service brakes, hydraulic
- What is wrong
- Chrysler is recalling certain model year 2010 chrysler sebring; dodge avenger and nitro; jeep liberty, commander and grand cherokee; and model year 2009-2010 dodge ram truck. These vehicles may have been built with an improperly formed or missing brake booster input rod retaining clip.
- Risk
- This could result in brake failure without warning which could cause a crash.
- Remedy
- Chrysler will replace the brake booster input rod retaining clip free of charge. The safety recall is expected to begin during february 2010. Owners may contact chrysler at 1‑800‑853‑1403.
Recall number 10V009000 · Recall details
Service brakes, hydraulic: antilock/traction control/electronic limited slip: control unit/module
- What is wrong
- On certain vehicles, the antilock brake system (ABS) control module software may cause the rear brakes to lock up during certain braking conditions.
- Risk
- This could result in a loss of vehicle control and cause a crash without warning.
- Remedy
- Dealers will reprogram the ABS electronic control unit. The recall began on february 19, 2007. Owners may contact daimlerchrysler at 1‑800‑853‑1403.
Recall number 06V493000 · Recall details
Service brakes, hydraulic: power assist
- What is wrong
- The power brake booster vacuum hose was improperly installed on the intake manifold vacuum nipple.
- Risk
- A disconnected vacuum hose causes an increase in engine idle speed and loss of power assist during brake application increasing the risk of a vehicle accident.
- Remedy
- Dealers will fully install the intake manifold vacuum hose to the vacuum nipple on the intake manifold.
Recall number 96V123000 · Recall details
Questions about the Chrysler Sebring abs
Why does the abs come on in the Chrysler Sebring?
Owners who report it most often also describe rotors or pads wearing out early, brake failure and grinding or squealing brakes, and the codes they mention most are C1044.
Which Chrysler Sebring years have aBS light or ABS activating problems?
The model years with the most reports are 1995 (13 complaints), 2007 (9 complaints) and 1996 (3 complaints).
VIN decoder
See the problems and recalls for an exact car
Buying a used Chrysler Sebring?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history