Tl*the contact owns a 1991 chrysler town and country. While the vehicle was parked the contact noticed the ABS warning light illuminated on the instrument panel. The contact also stated the ABS function was constantly on which made the vehicle difficult to drive. The dealer stated the vehicle had previously been repaired under the federal safety agency campaign id number: 96v099000 (service brakes, hydraulic:antilock) and would have to be diagnosed for the failure. The contact stated prior to the recall repairs she had not experienced a failure with the vehicle. The vehicle was not repaired. The approximate failure mileage was 72,000.
1991 Chrysler Town and Country brakes problems
10 complaints (40% of all complaints for this car). Typical mileage when it fails: 125,000. 1 crash reported.
- owner complaints
- 10
- of this car's complaints
- 40%
- typical mileage
- 125,000
- crashes
- 1
- recalls
- 3
Which part fails
- Antilock/traction control/electronic limited slip8
- Foundation components: disc1
At what mileage
Complaints by mileage at the time of the problem.
0k-25k
25k-50k
50k-75k
75k-100k
100k-125k
125k-150k
150k-175k
175k-200k
200k+
Chrysler Town and Country brakes problems in other years
Specific symptoms reported on the 1991 Chrysler Town and Country brakes
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
Service brakes, hydraulic: antilock/traction control/electronic limited slip
- What is wrong
- The ABS hydraulic control unit can experience excessive brake actuator piston seal wear causing pump-motor deterioration.
- Risk
- If this condition occurs, the ABS function could be lost and reduced power assist would be experienced during vehicle braking increasing the potential for a vehicle accident.
- Remedy
- Dealers will test the vehicle's anti-lock brake system and repair the vehicles if necessary. Also the warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will also be reimbursed for previous ABS component repair costs.
Recall number 96V099000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- The anti-lock brake system high pressure pump may be porous which will result in brake fluid leakage.
- Risk
- Fluid leakage eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
- Remedy
- Replace the ABS high pressure pump and high pressure hose if the last six digits of the bar code label on the pump are between 052300 and 059262.
Recall number 92V030000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- The anti-lock brake system high pressure hose may leak or detach at its crimped end fitting resulting in the discharge of hydraulic fluid.
- Risk
- Fluid discharge eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
- Remedy
- Replace the ABS high pressure hose with a hose of different design and construction.
Recall number 91V191000 · Recall details
Related investigations
Abs braking system fails
There is no summary currently available
EA94028
Abs braking system fails
There is no summary currently available
PE94024
Braking performance loss
Abs system leaks are alleged by consumers which result in complete brakefailure. Severre leaking occurs while the vehicle sits for several hoursresulting in complete loss of fluid. Leaks are appearing in both the highand low pressure lines possibly due to a faulty seal or coupling. Onecomplaint alleges fluid being forced out of brake reservoir when engine isstarted, possible pointing to a faulty check valve in the accumulator.
PE91094
Abs control failure
There is no summary currently available
PE91093
What 1991 Chrysler Town and Country owners say
Most recent owner complaints, unedited.
Tl*the contact owns a 1991 chrysler town and country. While driving 30 MPH, the ABS failed to operate and the vehicle took 20-30 additional feet to stop. The ABS light illuminated intermittently. While at the dealer on february 15, 2008, they stated that there was failure with the wiring and the vehicle needed a cylinder module and electrical work. The repair would cost approximately $200. The contact had the vehicle repaired, but the failure recurred. The dealer stated that nothing further could be done. The failure mileage was 104,000 and current mileage was 118,000.
Dt:the contact received the federal safety agency recall, campaign 96v099000 concerning ABS brakes. While pulling out of a parking space the ABS activated. The vehicle was stopped without incident. The vehicle was repaired under this recall. However, the brakes failed twice within a week. The vehicle was repaired again, and the contact was afraid to drive the vehicle.
The federal safety agency recall 92v030000 concerning brake pump failure. Consumer contacted the manufacturer, and was told that vehicle was recalled, and to proceed to the dealer for repairs. Consumer had the repairs done, and experienced brake failure four times since the pump was replaced. On each occasion the pump was replaced with a defective pump.
When the brakes are applied there is a delay before the vehicle will stop.
The brake pedal became hard when the driver made a sudden stop which resulted in extended stopping distances. The dealership repaired the vehicle but the problem still exist.
Loss of brakes --car is equipped with antilock brakes --third separate incident.
Vehicle experienced 3 episodes of complete ABS failure while driving, the manufacturer refused to rectify the problem under recall 96v‑099.
Recall related, 96v099, vehicle involved in side collision, impact position, speed 35mph, ABS brake failure, rear passenger side wheel off hwy, applied brakes and pedal went to the floor. *ak
The ABS braking system failed. Tt
Questions about the 1991 Chrysler Town and Country brakes
Does the 1991 Chrysler Town and Country have brakes problems?
Owners have filed 10 complaints about the brakes of the 1991 Chrysler Town and Country, 40% of all its complaints, more than any other problem.
At what mileage do 1991 Chrysler Town and Country brakes problems start?
The typical (median) mileage in owner complaints is 125,000 miles.
Was there a recall on the 1991 Chrysler Town and Country brakes?
Yes, 3 recalls: 96V099000, 92V030000, 91V191000. Check your VIN to see if your car still needs the free repair.
What year does the Chrysler Town and Country have bad brakes?
The Chrysler Town and Country model years with the most brakes complaints are 2008 (319 complaints), 2010 (165 complaints) and 1993 (123 complaints).
Other 1991 Chrysler Town and Country problems
Engine 3Locks 3Seat belts 3Transmission 3Body 2Tires 2Airbags 1Electrical 1Fuel system 1Steering 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 1991 Chrysler Town and Country?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history