2003 Crane LDT2 Problems: 0 Complaints, 3 Recalls

The worst 2003 Crane LDT2 problems

Ranked by number of owner complaints. Mileage and cost come from what owners wrote.

Tap a problem to see which part fails, at what mileage and in which other years.

Service brakes, airReported February 1, 2008 · 672 vehicles affected

What is wrong: Crane carrier is recalling 672 my 1999-2001 coe,my 1999-2002 ldt, my 2001-2007 ldt2, my 1998-2003 let, and my 2001-2007 let2 refuse cab and chassis for failing to comply with the brake release timing requirements of federal motor vehicle safety standard no. 121, "air brake systems." the brake release timing was slower than required.
Risk: This standard specifies performance and equipment requirements for vehicles equipped with air brake systems, including air-over-hydraulic brake systems, to ensure safe braking performance under normal and emergency conditions.
Remedy: Crane will replace several fittings and hoses which will increase the air flow and subsequently improve the brake release timing. The recall began on march 14, 2008. Owners may contact crane carrier at 918‑832‑7305.

Recall number 08V049000 · Recall details

WheelsReported May 6, 2004 · 172 vehicles affected

What is wrong: On certain vehicles equipped with galaxy disc truck wheels, size 22.5" x 9", a failure of these wheels can occur.
Risk: If the wheels are not identified and replaced a sudden failure of the wheel may occur without warning possibly resulting in a vehicle crash which could cause serious injury or even death.
Remedy: Galaxy is handling all owner notification and remedy for this campaign. Galaxy will notify its customers and replace the wheels. Owners should contact galaxy tire at 1‑800‑343‑3276 or crane at 1‑918‑836‑1651.

Recall number 04V217000 · Recall details

Service brakes, air: slack adjusters: automaticReported May 1, 2003 · 130 vehicles affected

What is wrong: On certain trailers equipped with a specific combination of reyco suspension, eaton drive axle, and bendix slack adjusters, the failure of a drive axle slack adjuster to automatically adjust as required to compensate for brake wear, will cause an out of adjustment condition. If this condition occurs and is not identified and corrected through normal inspections and maintenance, the slack adjuster will over-rotate and may contact the suspension lower spring saddle.
Risk: If this occurs, braking performance will be inhibited, increasing the risk of a crash without warning.
Remedy: Crane carrier will supply, at no charge, gunite slack adjusters and installation instructions to replace the existing bendix slack adjusters on the drive axle. The installing facility will be reimbursed by crane for one (1) hour labor per vehicle at their posted labor rate. Owner notification began on june 10, 2003. Owners should contact crane at 1‑918‑832‑7305.

Recall number 03V167000 · Recall details

Used buying checklistWhat to check on a 2003 Crane LDT2 before you buy

Is the 2003 Crane LDT2 reliable?

Owners have filed 0 complaints about the 2003 Crane LDT2.

What is the most common problem with the 2003 Crane LDT2?

There are not enough complaints to tell.

How many recalls does the 2003 Crane LDT2 have?

3 recalls, covering service brakes, air and wheels.

See the problems and recalls for an exact car

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.