Crane LDT2 recalls

What is wrong

Crane Carrier Company (Crane Carrier) is recalling certain model year 2008-2015 COE, LDT2, and LET2 trucks manufactured February 25, 2008, to May 20, 2015, and equipped with certain Cummins Westport ISL G engines. Excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase ventilation breather, possibly allowing engine oil to come into contact with hot surfaces.

Risk

If engine oil comes into contact with a hot surface, there is an increased risk of a fire.

Remedy

Cummins will notify owners on behalf of Crane Carrier, and dealers will secure the ends of the 90-degree elbow. In addition, the electronic control module (ECM) will be reprogrammed with software that can adjust the engine output under misfire conditions to limit crankcase pressures. These repairs will be performed free of charge. The recall began on June 12, 2015. Owners may contact Crane Carrier customer service at 1‑918‑836‑1651 or Cummins customer service at 1‑800‑343‑7357.

Recall number 15V314000 · Recall details

What is wrong

Crane Carrier Company (Crane) is recalling certain model year 2013 LET2 and LDT2 vehicles manufactured June 30, 2014, to July 31, 2014. The Cummins ISB or ISL engines in these vehicles may have been equipped with Fleetguard UFF-XT fuel filters, part number FF63009, whose filter shell may separate from the fuel filter nut plate causing the engine to stall without warning.

Risk

If the engine stalls unexpectedly there is an increased risk of a crash.

Remedy

Cummins will notify owners on behalf of Crane, and Cummins service centers will replace the fuel filter with a non-defective one, free of charge. The recall began on September 29, 2014. Owners may contact Crane customer service at 1‑918‑836‑1651. Owners may also contact Cummins at 1‑800‑223‑4583. Cummins number for this recall is C1545.

Recall number 14V531000 · Recall details

What is wrong

Crane Carrier Company (Crane) is recalling certain model year 2008-2014 LET2, COE, LDT2, and LE2 refuse vehicles manufactured April 16, 2008, through February 28, 2014, and equipped with certain Cummins Westport Model ISL G engines. Condensation in the intake manifold may freeze during cold weather conditions and interfere with the proper operation of the intake manifold pressure sensor.

Risk

The improper operation of the sensor could induce elevated exhaust temperatures or flames from the exhaust pipe, increasing the risk of a vehicle fire or burn injury to a person near the exhaust pipe.

Remedy

Cummins Inc. and Cummins Wesport Inc. will notify owners, and authorized Cummins service facilities will upload a new ECM calibration, free of charge. The manufacturer has not yet provided a notification schedule. Customers may contact contact Crane at 1‑918‑832‑7305 or Cummins Inc. at 1‑800‑343‑7357.

Recall number 14V124000 · Recall details

What is wrong

Crane carrier is recalling certain model year 2010-2011dr, let2,oet, ws, and model year 2010 ldt2 cab and chassis utility vehicles manufactured from october 26, 2010, through march 18, 2011 and equipped with gunite automatic air brake slack adjusters. Due to an incomplete "knitting" of the iron at the time of casting, inadequate structural integrity of the slack adjuster housing can occur, which could cause the housing to break at the handle under normal operating loads.

Risk

Slack adjusters with this flow notch could crack under normal braking conditions causing loss of braking which could result in a vehicle crash.

Remedy

Crane carrier will notify owners and accuride/gunite will conduct the remedy for this campaign and replace the subject slack adjusters free of charge. The safety recall began on april 26, 2011. Owners may contact accuride at 1‑800‑677‑3786 or crane carrier at 1‑918‑832‑7305.

Recall number 11V234000 · Recall details

What is wrong

Crane carrier is recalling 16 my 2007-2008 ldt2 and let2 refuse packervehicles equipped with c7 or c9 caterpillar diesel engines. The fuel pump outlet check plug may be cracked which could cause fuel to spray and leak.

Risk

Fuel leakage, in the presence of an ignition source, could result in a fire.

Remedy

Crane carrier is working with caterpillar (please see 08e042). Caterpillar will replace the fuel pump plug free of charge. The recall is expected to begin during september 2008. Owners may contact caterpillar at-1‑800‑447‑4986 or crane carrier at 1‑918‑836‑1651.

Recall number 08V476000 · Recall details

What is wrong

Crane carrier is recalling certain vehicles equipped with caterpillar c13 diesel engines. The extension pipes attached to the aftertreatment regeneration device (ard) may develop a hole, and heat and flame may escape during a regeneration of the diesel particulate filter.

Risk

This may result in a fire hazard.

Remedy

Crane is working with caterpillar to repair these vehicles (please see 08e054). Owners may contact caterpillar at 1‑800‑447‑4986 or crane at 918‑836‑1651.

Recall number 08V445000 · Recall details

What is wrong

Crane carrier is recalling 672 my 1999-2001 coe,my 1999-2002 ldt, my 2001-2007 ldt2, my 1998-2003 let, and my 2001-2007 let2 refuse cab and chassis for failing to comply with the brake release timing requirements of federal motor vehicle safety standard no. 121, "air brake systems." the brake release timing was slower than required.

Risk

This standard specifies performance and equipment requirements for vehicles equipped with air brake systems, including air-over-hydraulic brake systems, to ensure safe braking performance under normal and emergency conditions.

Remedy

Crane will replace several fittings and hoses which will increase the air flow and subsequently improve the brake release timing. The recall began on march 14, 2008. Owners may contact crane carrier at 918‑832‑7305.

Recall number 08V049000 · Recall details

What is wrong

On certain cab and chassis ready-mix, hay hauler, refuse and well service vehicles, there may be material flaws in the drag link assemblies.

Risk

A failure of the drag link may cause a loss of steering control, which could result in a crash.

Remedy

Crane carrier will supply and install, at no charge, a replacement drag link. The recall began on september 6, 2005. Owners may contact crane carrier at 1‑918‑836‑7305.

Recall number 05V381000 · Recall details

What is wrong

On certain vehicles, a mechanical interference may exist between the throttle pedal and an access plug in the cab sheet metal.

Risk

The throttle pedal may contact the access plug and not return to the idle position causing a loss of vehicle control, increasing the risk of a crash.

Remedy

Crane carrier will relocate the throttle pedal at no charge. The recall began september 17, 2005. Owners may contact crane carrier at 1‑918‑832‑7305.

Recall number 05V380000 · Recall details

What is wrong

On certain vehicles equipped with galaxy disc truck wheels, size 22.5" x 9", a failure of these wheels can occur.

Risk

If the wheels are not identified and replaced a sudden failure of the wheel may occur without warning possibly resulting in a vehicle crash which could cause serious injury or even death.

Remedy

Galaxy is handling all owner notification and remedy for this campaign. Galaxy will notify its customers and replace the wheels. Owners should contact galaxy tire at 1‑800‑343‑3276 or crane at 1‑918‑836‑1651.

Recall number 04V217000 · Recall details

What is wrong

On certain trailers equipped with a specific combination of reyco suspension, eaton drive axle, and bendix slack adjusters, the failure of a drive axle slack adjuster to automatically adjust as required to compensate for brake wear, will cause an out of adjustment condition. If this condition occurs and is not identified and corrected through normal inspections and maintenance, the slack adjuster will over-rotate and may contact the suspension lower spring saddle.

Risk

If this occurs, braking performance will be inhibited, increasing the risk of a crash without warning.

Remedy

Crane carrier will supply, at no charge, gunite slack adjusters and installation instructions to replace the existing bendix slack adjusters on the drive axle. The installing facility will be reimbursed by crane for one (1) hour labor per vehicle at their posted labor rate. Owner notification began on june 10, 2003. Owners should contact crane at 1‑918‑832‑7305.

Recall number 03V167000 · Recall details

What is wrong

On certain tag and pusher axle assemblies purchased from ridewell, the axle assemblies have an actual weight rating less than that specified on the label and therefore fail to comply with the requirements of part 567.5, "certification."

Risk

Loading the tag/pusher axle to the gawr label rating or loading the vehicle to the gvwr label rating will cause the pusher/tag axle to be overloaded.

Remedy

Crane will provide owners with replacement vehicle certification labels and installation instructions. Owner notification began october 4, 2002. Owners who do not receive the free remedy within a reasonable time should contact crane at 1‑918‑832‑7333.

Recall number 02V231000 · Recall details