Check a VIN

1999 Freightliner FLN problems

Typical yearClose to a typical year
Owner complaints
0
Recalls
12
Service bulletins
1

The worst 1999 Freightliner FLN problems

Ranked by number of owner complaints. Mileage and cost come from what owners wrote.

Problems by type

Tap a problem to see which part fails, at what mileage and in which other years.

Recalls 12

Steering: linkages: tie rod assemblyReported September 17, 2001 · 75,000 vehicles affected
What is wrong
Vehicle description: heavy duty trucks equipped with trw tie rod ends on certain meritor axles. The tie rod and drag link ball stud ends contain bearings that are below the specified case depth and/or hardness.
Risk
This can lead to premature wear with possible separation of the ball stud from the socket, increasing the risk of loss of control of the vehicle.
Remedy
Dealers will remove and replace all affected tie rods and drag links with different designed ends. Owner notification began november 8, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact freightliner at 1‑800‑547‑0712.

Recall number 01V140007 · Recall details

Service brakes, hydraulic: foundation componentsReported March 12, 2001 · 1,350 vehicles affected
What is wrong
Vehicle description: heavy duty trucks equipped with hydraulic brakes and a durapark park brake system manufactured by arvinmeritor. Air is entering the hydraulic rear brake cylinders through an unknown path and the rear self-adjusting brakes may not be operating properly.
Risk
This results in spongy or soft feel to the brake pedal and a loss of rear braking capability.
Remedy
Dealers will remove and replace the ABS ecu and inspect the brake pedal for proper travel. If excessive travel is detected, the brake system will be bled and rear brakes adjusted. As an interim measure, freightliner will notify all owners to have their vehicles inspected to assure proper function of the brake system. This will include adjusting and bleeding the brakes. Also, owners will be instructed that on a regular basis they should do several hard brake applications while stopped. This will exercise the self-adjusting system and if they observe a low or spongy brake pedal they will be instructed to take their vehicle in for additional service. Owner notification began march 21, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact freightliner at 1‑800‑547‑0712.

Recall number 01V085001 · Recall details

Steering: linkages: tie rod assemblyReported February 21, 2001 · 16,000 vehicles affected
What is wrong
Vehicle description: trucks, school bus and motor home chassis, and transit buses equipped with tie rod assemblies manufactured by trw. The suspect tie rods contain 24-dl model ball sockets. Certain of the tie rod ball-socket bearings have a below-specification case depth and/or hardness, which can lead to premature wear of the socket.
Risk
If this condition occurs, the driver can lose partial control of the right front wheel, possibly resulting in a crash.
Remedy
Dealers will replace the defective ball sockets and/or drag links. Owner notification began may 22, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact freightliner at 1‑800‑547‑0712 or trw customer service at 1‑866‑280‑3287.

Recall number 01V044002 · Recall details

Service brakes, air: antilockReported September 22, 2000 · 13,008 vehicles affected
What is wrong
Vehicle description: shuttle buses, recreational vehicles, utility vans, and heavy duty trucks equipped with meritor wabco phase 1, d-version antilock brake system (ABS), fail to comply to the requirements of fmvss no. 105, "hydraulic and electric brake systems." an internal diagnostic system in the ABS may not detect an extreme wheel speed sensor air gap. Such a condition could possibly occur during (1) original assembly or (2) subsequent wheel end service.
Risk
The ABS fault light will not activate and the ABS will not function at this wheel position, increasing the risk of a crash.
Remedy
Dealers will remove and replace the ABS ecu or the ecu will be reprogrammed. Owner notification began february 6, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact freightliner at 1‑800‑547‑0712.

Recall number 00V279001 · Recall details

Service brakes, airReported May 22, 2000 · 83 vehicles affected
What is wrong
Vehicle description: certain tractors fail to comply with fmvss no. 121, "air brake systems." the air lines may not be routed properly to the drive axle service brake relay.
Risk
These vehicles are not in compliance with the standard.
Remedy
Dealers will inspect for correct air line routing and reroute if necessary.

Recall number 00V152001 · Recall details

Service brakes, air: antilockReported January 18, 2000 · 21 vehicles affected
What is wrong
Vehicle description: heavy duty trucks. A heat shield between an ABS (anti lock brake system) modulating valve and a muffler was omitted.
Risk
This condition could result in longer stopping distances in emergency braking situations.
Remedy
Dealers will install a heat shield between the ABS modulating valve and the muffler.

Recall number 00V013000 · Recall details

Suspension: front: hubReported October 26, 1999 · 2,976 vehicles affected
What is wrong
Vehicle description: heavy duty trucks. The outboard bearing on the steering axle hubs can fail due to water intrusion through a hubcap vent.
Risk
This condition can result in a separation of the wheel.
Remedy
Dealers will remove the hubcap and inspect for water intrusion and corrosion. The hub and bearing assembly will be replaced if there is evidence of corrosion. A non-vented hubcap will be installed.

Recall number 99V295000 · Recall details

SteeringReported August 17, 1999 · 224 vehicles affected
What is wrong
Vehicle description: trucks with steering linkages converted to stand-up right-drive by fontaine modification company. These vehicles have a steering cross shaft that connects the right side steering column to the left side steering column, with a miter box, and u-joint at each side. The cross shaft, miter box shaft, and u-joint have keyways and the u-joint has a set screw at both connections. The keys can work loose and fall out.
Risk
This condition can result in a loss of steering on the right hand side.
Remedy
Dealers will install nuts and bolts through the universal joint ends and shafts which will create a positive lock between the steering gear boxes.

Recall number 99V224000 · Recall details

Electrical system: ignition: moduleReported July 27, 1999 · 320 vehicles affected
What is wrong
Vehicle description: heavy duty trucks equipped with caterpillar engines and eaton autoshift transmissions. The engines can stall because of software problems.
Risk
Increased steering effort can occur.
Remedy
Caterpillar is conducting the owner notification and remedy of this recall. Dealers will update these engines with software changes.

Recall number 99V181002 · Recall details

Suspension: rearReported July 2, 1999 · 204 vehicles affected
What is wrong
Vehicle description: trucks equipped with tuftrac suspensions. The rear suspension axle clamps can fracture, allowing the rear axle to shift.
Risk
This condition could cause a loss of vehicle control, increasing the risk of a crash.
Remedy
Dealers will install new upper and lower axle clamps.

Recall number 99V172000 · Recall details

Steering: steering wheel/handle barReported June 9, 1999 · 666 vehicles affected
What is wrong
Vehicle description: heavy duty trucks equipped with dual steering. The steering column pinch bolts may be under-torqued or missing.
Risk
This condition could result in a loss of steering control, increasing the risk of a crash.
Remedy
Dealers will inspect for the presence of the required fasteners, install fasteners is missing, and retorque to specifications.

Recall number 99V143000 · Recall details

Service brakes, airReported March 29, 1999 · 285 vehicles affected
What is wrong
Vehicle description: heavy duty trucks equipped with meritor air brake automatic slack adjusters. Some of the automatic slack adjusters had insufficient torque applied to the guide pawl cap screw.
Risk
Without sufficient torque on the guide pawl cap screw, the brakes could gradually lose adjustment, increasing the vehicle stopping distance.
Remedy
Dealers will check the torque on the automatic slack adjuster guide pawl. If there is no torque, the brakes will be adjusted and the guide pawl will be tightened to 15-20 ft. Lbs.

Recall number 99V055002 · Recall details

See all 12 recalls for the 1999 Freightliner FLN

Technical service bulletins for the 1999 Freightliner FLN 1

Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.

Used buying checklistWhat to check on a 1999 Freightliner FLN before you buy

Compare the 1999 Freightliner FLN

Other model years

2005

Questions about the 1999 Freightliner FLN

Is the 1999 Freightliner FLN reliable?

Owners have filed 0 complaints about the 1999 Freightliner FLN.

What is the most common problem with the 1999 Freightliner FLN?

There are not enough complaints to tell.

How many recalls does the 1999 Freightliner FLN have?

12 recalls, covering steering, service brakes, hydraulic and service brakes, air.

Share your experience with the 1999 Freightliner FLN

Tell other buyers what went wrong and what it cost. We review every report before it appears, and we never publish names, emails or VINs.

No names, contact details or links. Reports about a dealer or a person are not published.

VIN decoder

See the problems and recalls for an exact car

Buying a used 1999 Freightliner FLN?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history
Is this car on a recall?Check VIN