Tl* the contact owns a 2004 genie tz50 towable lift. The contact stated that while driving 65 MPH, the aluminum outrigger fell off during transport due to the disintegration of a rubber washer. The manufacturer was notified and agreed to replace the washer that was damaged, but would not supply a kit to prevent the other three from having the same safety issue. Updated 07/10/12
The worst 2004 Genie TZ-50 problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
- Suspension1
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
- Suspension1
Recalls 3
Structure
- What is wrong
- On certain trailer mounted aerial work platform booms, the hold down bracket that secures the mast/upper structure for transport may become damaged or loose over time. If the mast hold-down bracket sustains structural damage, it may no longer be capable of holding the trailer mast in place during transport.
- Risk
- This could result in upper structure movement and could contribute to the trailer becoming unstable when rounding a corner, increasing the risk of a crash.
- Remedy
- Genie will provide a mast cradle replacement kit to owners of all affected machines free of charge. The recall began on april 5, 2007. Owners may contact genie at 866‑927‑7269.
Recall number 07V141000 · Recall details
Electrical system
- What is wrong
- On certain trailer mounted aerial work platform booms, the outriggers (stabilizers) can function when the machine is not in a fully stowed position.
- Risk
- The down limit switch and its location on the machine allow the limit switch to be activated when it comes in contact with the boom arm, making it possible to raise the outriggers while the platform is elevated, increasing the risk of injury to the operator.
- Remedy
- Genie will provide a limit switch replacement kit and installation instructions to owners of all affected machines. The recall began on january 11, 2007. Owners may contact genie at 1‑877‑738‑7530.
Recall number 06V484000 · Recall details
Steering: linkages
- What is wrong
- On certain trucks, during assembly, the drag link attachment nuts at the pitman arm and steering arm may have been incorrectly torqued. Residual grease and paint which was applied as a rust inhibitor on the steering arm may have contributed to a loss of torque after assembly.
- Risk
- Increased wear for the draglink connections can occur creating a noticeable increase in the amount of steering wheel free play. If this condition was ignored, a loss of steering control of the vehicle could occur which could result in a crash.
- Remedy
- Dealers will inspect the steering arm tightness and remove all grease and paint from the steering arms and retorque the draglink attachment nuts at the steering arm and pitman arm. The recall began on may 12, 2006. Owners may contact hino at 1‑248‑648‑6430.
Recall number 06V169000 · Recall details
What 2004 Genie TZ-50 owners say
Most recent owner complaints, unedited.
Compare the 2004 Genie TZ-50
Other model years
2004
Questions about the 2004 Genie TZ-50
Is the 2004 Genie TZ-50 reliable?
Owners have filed 1 complaint about the 2004 Genie TZ-50, close to a typical TZ-50 model year.
What is the most common problem with the 2004 Genie TZ-50?
Suspension, with 1 complaint.
How many recalls does the 2004 Genie TZ-50 have?
3 recalls, covering structure, electrical system and steering.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2004 Genie TZ-50?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history