Geo Tracker recalls

What is wrong

Vehicle description: sport utility vehicles. Mislabeled seat belts intended for 2-door model vehicles were installed in the 4-door front passenger seat belt location. For the passenger seat safety belt, if the child seat mode has been engaged or the belt is extended during normal use and then retracted, the belt cannot be extended again and is unusable. The reset function to normal emergency mode does not work because the 2-door belt webbing is shorter.

Risk

In a crash, an unbelted occupant could receive severe injuries.

Remedy

Dealers will inspect and replace incorrect seat belt assemblies. Owner notification began may 3, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet at 1‑800‑222‑1020.

Recall number 01V124000 · Recall details

What is wrong

Vehicle description: passenger vehicles. Some of these vehicles have an inoperative brake lamp-actuating switch. If the brake lamp-actuating switch does not function properly when the brake pedal is depressed, the brake lights may be inoperative. On vehicles equipped with automatic transaxle, a failure in the brake lamp-actuating switch may also prevent shifting out of park. This does not comply with the requirements of fmvss no. 108, "lamps, reflective devices, and associated equipment."

Risk

If this were to occur while the vehicle was in motion and another vehicle was following closely, a vehicle crash could occur.

Remedy

Dealers will replace the stop lamp switch assembly.

Recall number 99V273001 · Recall details

What is wrong

Vehicle description: passenger vehicle. The windshield may have been improperly installed and may not meet the windshield retention during a frontal impact requirements of fmvss no. 212, "windshield mounting."

Risk

In the event of a crash, the windshield may not be properly retained and injury to vehicle occupants could occur.

Remedy

Dealers will replace the windshields on affected vehicles.

Recall number 98V329000 · Recall details

What is wrong

Vehicle description: passenger vehicles. The coupling that connects the steering column shaft to the intermediate steering shaft is cracked. This could allow the steering shafts to separate.

Risk

If this were to occur while the vehicle was in motion, a loss of steering control could occur increasing the risk of a crash.

Remedy

Dealers will replace the steering shaft coupling.

Recall number 98V324001 · Recall details

What is wrong

The fuel tank on these vehicles can become punctured by a fuel tank flange attachment reinforcement during rear-end collisions. This does not comply with the requirements of fmvss no. 301, "fuel tank integrity."

Risk

Consequence of non-compliance: if an ignition source was present, fuel leakage resulting from this puncture could result in a post-crash fire.

Remedy

Dealers will install two new shield gussets between the fuel tank and attachment brackets to prevent the reinforcement from puncturing the fuel tank wall.

Recall number 96V121001 · Recall details

What is wrong

The steering wheel center hub to spoke weld can fracture.

Risk

This condition will allow the steering wheel to separate from the steering column increasing the risk of a vehicle accident.

Remedy

Dealers will inspect the steering wheel for the suspect steering wheel lot date code and replace any found to have this suspect date.

Recall number 96V118000 · Recall details

What is wrong

The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." if a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.

Risk

The safety belts would not provide adequate protection to an occupant in a vehicle crash.

Remedy

Owners should promptly check the condition and operation of both front safety belt buckles and carefully inspect the red release button for any breaks or cracks. They should ensure that both buckles are operating properly by inserting each latch plate into its buckle, tugging on the belt to make sure the latch is securely locked, and then pressing the release button. The latch plate should pop out of the buckle when the button is pressed. If either release button shows a sign of breaking or cracking or if either buckle fails to operate properly, owners should promptly contact their authorized dealer to schedule an appointment to have the buckle replaced or repaired, free of charge. The manufacturer is developing a remedy designed to prevent failure of the buttons that are not currently broken.

Recall number 95V103007 · Recall details

What is wrong

The right rear and left axle shaft housing tubes were incorrectly welded and can fracture. Fracture of the rear axle shaft housing can result in separation of the affected wheel assembly and separation of the brake line.

Risk

Separation of the wheel assembly can cause loss of vehicle control and separation of the brake line results in loss of one-half of the braking system, increasing stopping distance. In either case, an accident can occur.

Remedy

Dealers will inspect the welds of the rear axle assemblies on involved vehicles and, if necessary, replace the complete rear axle assembly.

Recall number 94V073001 · Recall details

What is wrong

These vehicles were assembled with a lower steering shaft that can separate due to a mislocated weld.

Risk

If the separation occurred while the vehicle was in motion, a loss of steering control can result and an accident can occur without prior warning.

Remedy

Dealers will inspect the steering shaft and replace it if necessary.

Recall number 94V016000 · Recall details