While driving the pedal went to the floor, which caused the truck not to stop when the brakes were applied. The driver had to pump the brakes several times, and the truck slowed down.
1995 GMC Jimmy brakes complaints
Page 6 of 9: complaints 131 to 160 of 243, newest first, as owners wrote them.
Ant-lock brakes locked up causing loss of control/accident no deployment of air bag during collision.
Excessive wear of the brake pads.
When applying the brakes the pedal locked and would not go down. Driver had to use parking brake to stop. Dealer replaced the egr valve for the second time.
Intermittently when the brakes are applied the pedal goes to the floor and reales back up, resulting in extended stopping distance. The dealer has replaced the ABS wire/ the rotors and the brakes pads. The manufacturer has been notified.
Anti lock brakes failed resulting in a collision. Burns caused by air bags.
Intermittently when the brakes are applied the pedal goes to the floor, resulting in extended stopping distance. Brakes have to be pumped before they will catch. Dealer hs been notified.
Vehicle was hit by another automobile that ran a red light. Consumer applied brakes, but brakes failed to stop vehicle, resulting in a crash/injuries. Vehicle also sustained excessive damage.
Abs brakes caused premature stops.
Anti-lock brake system locks up and makes loud noise.
Egr valve failure. Also, brake booster failed, causing vehicle to swerve to the right, narrowly missed plowing into a line of traffic that stopped for a red light.
Prior to crash brakes felt spongy and seemed to take too long to stop vehicle. Inspection found nothing wrong, but later brake failed completely allowing vehicle to crash.
Abs failed, pedal went to the floor when it was slammed to stop in an emergency. Rotors failed, outside pad of rotors wore out before inside pad.
No failure.
Abs brakes; when applying brakes in normal conditions, the pedal goes to the floor and the brakes fail to stop vehicle. Please provide further details.
While applying ABS brakes in 6 differnet quick stop situations the brakes failed, once resulting in a collision. Dealers found no problem with the brakes.
Egr valve corroded resulting in sticking in the open piston thus losing all vacuums and causing the brakes to fail completely.
Anti lock brakes failed.
Anti lock brakes failed causing extended stopping distance.
Brakes failed.
While driving the truck applied the brakes and the truck had extended stopping distance, which allowed the truck to keep on going.
Driving at approx 55 MPH ABS brakes became inoperative, causing the consumer to rear end another vehicle in front. Brakes did not brake fast enough. Also, no deployment of air bags upon impact.
While driving along on regular road conditions, the brakes went out. Driver heard a clunking noise like metal to metal grinding. The whole brake system was replaced.
Anti lock brakes failed, causing vibration and lack of stopping control.
While driving vehicle on wet surfaces or over bumps, the ABS brakes skidded, causing vehicle not to stop properly when braking. Also, egr valve stuck open, causing loss of brakes.
While pulling into driveway at 5mp, applying bakes, brakes went all the way to the floor before stopping the vehicle.
Consumer's wife dr0ve, applied the brakes when someone pulle da u-turn in front of her, and the ABS brakes did not allow sufficient stopping. Vehicle was attempting to stop on blacktop when brakes were applied over a small amount of dirt on the road. Vehicle lost control and hit other vehicle, resulting in injuries and extensive damage to vehicle.
Anti lock brakes fail continuously, causing loss of control
Brake problems.
Whenever the ABS brakes are applied, would hear a grinding noise. This would occur at any given time. Took to dealer & had the brakes replaced.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1995 GMC Jimmy?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history