My vehicle a 2016 GMC Sierra 1500 upon lower idle speeds loses vacuum pressure. As the vacuum level drops the brake assist decreases, increasing the braking effort, extending the distance required to stop the vehicle, which increases the risk of a crash. I have had a warning light come on advising to service the brake assist system. I took my truck to a local mechanic who confirmed the codes and learned that there had been a GM recall associated with this failure at one time, with GM recall # N192268490. There is also the federal safety agency recall bulletin 19V645000 regarding this matter as well. Upon contacting some local GM dealers in the area, I was informed that my VIN was not listed as one of the vehicles affected by this recall, so a recall notice was never sent regarding my vehicle. I was also told that I just fell outside their 10-year window regarding this matter and that they would not repair this safety issue under warranty. I called the GM customer service who could not explain why the VIN associated to my truck was not listed and they said I should contact the federal safety agency and start a claim for potential reimbursement in the future after repairs are made. I feel that this is an unnecessary step as I believe GM should honor their product and repair an obvious safety issue with the truck, especially since they knew this was an issue in thousands of their trucks where it was not my fault my vehicles VIN was not included as a potential recall issue, but I am following their suggestion
2016 GMC Sierra 1500 brakes problems
106 complaints (31% of all complaints for this car). Typical mileage when it fails: 45,000. 8 crashes reported.
- owner complaints
- 106
- of this car's complaints
- 31%
- typical mileage
- 45,000
- crashes
- 8
- recalls
- 1
Which part fails
- Power assist: vacuum2
At what mileage
Complaints by mileage at the time of the problem.
GMC Sierra 1500 brakes problems in other years
Specific symptoms reported on the 2016 GMC Sierra 1500 brakes
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
Service brakes, hydraulic: power assist: vacuum
- What is wrong
- General Motors LLC (GM) is recalling certain 2015-2017 Cadillac Escalade, 2014-2018 Chevrolet Silverado, GMC Sierra, 2015-2018 Chevrolet Suburban, Tahoe, GMC Yukon vehicles. The amount of vacuum created by the vacuum pump may decrease over time.
- Risk
- As the vacuum level drops, the brake assist decreases, increasing braking effort, extending the distance required to stop the vehicle, thereby increasing the risk of a crash.
- Remedy
- GM will notify owners, and dealers will reprogram the Electronic Brake Control Module, free of charge. The recall began October 8, 2019. Owners may contact Chevrolet customer service at 1‑800‑630‑2438, Cadillac customer service at 1‑800‑458‑8006 or GMC customer service at 1‑800‑462‑8782. GM's number for this recall is N192268490.
Recall number 19V645000 · Recall details
Related investigations
Brake Vacuum Pump Failure
On November 20, 2018, the Office of Defects Investigations (ODI) opened PE18-012 to investigate instances of sudden onset of a hard brake pedal that could result in extended stopping distance due to an issue with the brake assist vacuum pump in model year (MY) 2014 through 2016 GMC Sierra 1500 and Chevrolet Silverado 1500 series pickup trucks and MY 2015 through 2016 Cadillac Escalade, Chevrolet Suburban, Chevrolet Tahoe, and GMC Yukon SUVs.If the brake assist vacuum pump fails to operate as intended, the amount of brake power assist supplied to the driver can be significantly reduced, extending the subject vehicle stopping distance. GM stated that the root cause of pump failures was due to foreign debris such as oil sludge in the engine oil. GM stated that this debris can become trapped by the oil inlet filter screen. Under normal operation, this screen allows a small amount of oil into the brake vacuum pump. The foreign debris can, over time, clog the pump which can cause a loss of lubrication and a reduction in the amount of vacuum produced leading to a hard pedal and extended stopping distance.On December 13, 2018, GM issued a Special Coverage (N182202780) for the brake vacuum pump issue in MY 2014-2017 trucks and 2015-2017 SUVs on the K2XX platform for 6 years or 72,000 miles. Special Coverage repair includes the replacement of the vacuum pump and vacuum pump belt. Consumers received notification of the coverage via mail. On September 6, 2019, GM notified the federal safety agency that it was conducting safety recall 19V‑645 which reprograms the electronic brake control module (EBCM) and included approximately 3.5 million trucks and SUVs. In October 2019, GM extended the terms of special coverage N182202780 to 10 years or 150,000 miles as well as now including the entire scope of recall 19V‑645. In October 2020, GM expanded the scope of coverage N182202780 to include the MY 2018 Escalade and 2019 Tahoe.The remedy implemented in GM recall 19V‑645 appears to be sufficient in addressing the safety-related concerns of this issue. Loss of vacuum assist now occurs at a progressive rate as well as there being a more timely warning of a brake problem to the driver through the driver information center (DIC). In view of the recall action and revision to the special coverage, this Preliminary Evaluation is closed. The agency reserves the right to take additional action if warranted by new circumstances. The ODI reports cited above are available for review online at under the identification numbers in the attached document.
PE18012
What 2016 GMC Sierra 1500 owners say
Most recent owner complaints, unedited.
1- transmission issue, it’ll occasionally slip from 1-2 gear and engine rpm’s will shoot up making it when you release the gas pedal it’ll kick into second gear it’ll also do minor kicks into other gears (8l90 transmission) 2- breaks issue, unsure of what the problem is but at very low speeds like parking or going in slow traffic the break pedal will get really hard making you have to press extra hard for it to break, releasing and pressing again doesn’t help either
While traveling at low speeds in parking lots and in the operation of parking, my 2016 GMC Sierra 1500 gets a hard brake pedal that goes to the floor but I have no brakes. I almost hit a person in a local grocery store parking lot, at the bank driving up to the ATM, and I almost lost my truck over a bank because the brakes failed. This has happened multiple times at low speeds but it is getting more consistent recently. It has endangered myself and others. It is only a matter of time until damage occurs or someone gets hurt.
The contact owns a 2016 GMC Sierra 1500. The contact stated that while her and her husband were driving on several occasions at various speeds, the brake was depressed; however, the braking distance was extended, and the vehicle took longer to slow down. The contact also stated that occasionally while driving at undisclosed speeds, her husband observed a loud sound coming from the engine compartment. The vehicle was taken to the dealer where it was diagnosed and determined that the engine and braking system needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was unknown.
I towed a trailer last month and noticed some hard breaking issues in slow moving traffic. Las night as I was parking my vehicle under the car port, I had to press on the brakes to straighten my vehicle and as I was moving forwards slowly, my brakes failed, the pedal was stiff and I almost hit my other vehicle and the garage door.
Driving at low speed such at in drive thru or parking lot if you press brake couple repetitive times pedal gets hard and you have to press really hard to stop it’s like vacumn assist losses vacumn in braking assist been happening last couple years but I’ve learned to adjust my braking at low speed to adapt
Stopping at a stop sign with several cars in front of me my vehicle wouldn’t stop, luckily the car in front of me moved. I immediately called the dealership to have my vehicle repaired. They confirmed my brakes had a problem including the vacuum pump having an internal failure. They replaced vacuum pump and required belts then charged me $800.00 for this service.
On a recent road trip my family and I experienced an issue with the Brake Assist on my 2016 GMC Sierra. When I returned back from our vacation I took the vehicle to a 3rd party mechanic that I trusted to perform diagnostics. He advised that I would need a new vacuum pump and stretch belt to correct the issue. Upon receiving this information I advised him to move forward with the repair. What I didn't know was that Special Coverage N182202780 covers this exact repair from GM at no cost to the customer. I followed up with GM to see if I could recoup any of the cost and I was told no because I didn't get the work done at a GM dealership. I find this to be extremely frustrating as I did not know there was a special notice that would have covered this defect, and if I had I would of taken the vehicle to a GMC dealership. I feel that GM should reimburse me for the defect that was known even if I had the vehicle serviced at my chosen mechanic. Any help would be greatly appreciated
The contact owns a 2016 GMC Sierra 1500. The contact stated that while reversing into a parking space and attempting to stop the vehicle, the brake pedal required an excessive amount of effort to bring the vehicle to a complete stop. The vehicle returned to normal functionality, but the failure became a regular occurrence. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. After investigating the failure, the contact related the failure to the federal safety agency Campaign Number: 19V645000 (Service Brakes, Hydraulic). The VIN was included, and the vehicle was repaired. The manufacturer was notified of the failure but provided no assistance. The failure mileage was 63,000.
Braking system is malfunctioning while driving at slower speeds. It has malfunctioned while backing up and almost hit another vehicle. It also malfunctioned while coming to a stop light. Brake system is not working as it should and is feeling spongy upon braking. It feels like the brake pedal is all the way to the floor before it will eventually stop the truck. In researching this problem, there was a recall on the secondary brake system back in Feb of 2020. I bought the truck in June of 2020. I never got any information that there was a recall from the dealership I bought it from. I am unable to drive my truck due to this problem. I have not taken the truck to a GMC dealer as of yet but planning to.
Questions about the 2016 GMC Sierra 1500 brakes
Does the 2016 GMC Sierra 1500 have brakes problems?
Owners have filed 106 complaints about the brakes of the 2016 GMC Sierra 1500, 31% of all its complaints, more than any other problem.
At what mileage do 2016 GMC Sierra 1500 brakes problems start?
The typical (median) mileage in owner complaints is 45,000 miles.
Was there a recall on the 2016 GMC Sierra 1500 brakes?
Yes, 1 recall: 19V645000. Check your VIN to see if your car still needs the free repair.
What year does the GMC Sierra 1500 have bad brakes?
The GMC Sierra 1500 model years with the most brakes complaints are 2015 (229 complaints), 2014 (144 complaints) and 2000 (131 complaints).
Other 2016 GMC Sierra 1500 problems
Transmission 85Electrical 54Engine 41Steering 38Suspension 15Visibility 14Airbags 12Fuel system 9Driver assistance 8Body 7Seats 7Acceleration 4Lights 4Wheels 4Seat belts 2Tires 2
VIN decoder
See the problems and recalls for an exact car
Buying a used 2016 GMC Sierra 1500?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history