Check a VIN

2000 GMC Sonoma recalls

There are 3 safety recalls on record for the 2000 GMC Sonoma, covering 237,815 vehicles in total across all the models in each campaign. Newest first.

All recalls

Equipment: other: labelsReported September 8, 2000 · 223,194 vehicles affected
What is wrong
Vehicle description: light duty pickup trucks and sport utility vehicles. Some of these vehicles were built with incorrect payload information on the vehicle certification label. The payload shown on the label is greater than the maximum validated payload. If the vehicle were loaded to the incorrectly labeled payload, it may not ride and handle in the manner that the driver expects.
Risk
This could result in a loss of control of the vehicle or an inability to stop the vehicle within expected stopping distances.
Remedy
Owners will be sent a new label for installation on the driver's door of the vehicle.

Recall number 00V258001 · Recall details

Service brakes, hydraulic: antilock/traction control/electronic limited slipReported February 28, 2000 · 10,674 vehicles affected
What is wrong
Vehicle description: light duty pickup trucks equipped with 4-wheel disc brakes. Some of these vehicles have an antilock brake system (ABS) motor containing an out-of-specification spring clip. This clip could allow the motor bearing to become misaligned. If misalignment occurs, eventually the ABS would be non-functional.
Risk
The base brakes would remain fully functional, but the dynamic rear proportioning (drp) system, which optimizes front to rear brake balance, would become inoperative.
Remedy
Dealers will replace the brake pressure module valve assembly.

Recall number 00V055000 · Recall details

Service brakes, hydraulic: antilock/traction control/electronic limited slipReported August 11, 1999 · 3,947 vehicles affected
What is wrong
Vehicle description: s -trucks equipped with 2 wheel drive. These vehicles may have had the right-hand antilock brake system (ABS) module feed pipe and/or brake crossover pipe tube nuts tightened without seating the pipe-flared-ends enough to withstand normal assembly and vehicle inputs without partially unseating. This does not comply with requirements of fmvss no. 105, "hydraulic service brake normal, emergency, and park braking performance."
Risk
If this occurred, the seating seal could be broken during vehicle assembly, or from early road inputs or brake fluid cycling, and a leak could occur increasing the brake stopping distance.
Remedy
Dealers will inspect the brake pipe union for signs of brake fluid, and if necessary, install a new brake pipe union.

Recall number 99V220000 · Recall details

Questions about the 2000 GMC Sonoma recalls

How do I check if my 2000 GMC Sonoma has an open recall?

Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.

Do I have to pay for a recall repair?

No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.

How many recalls does the 2000 GMC Sonoma have?

3, covering equipment and service brakes, hydraulic.

VIN decoder

See the problems and recalls for an exact car

Buying a used 2000 GMC Sonoma?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history