Brake pedal goes alway down to floor, and vehicle makes noises. Dealership is aware of problem.
1992 GMC Suburban brakes problems
66 complaints (85% of all complaints for this car). 23 crashes reported.
- owner complaints
- 66
- of this car's complaints
- 85%
- crashes
- 23
- recalls
- 1
Which part fails
- Antilock/traction control/electronic limited slip59
- Foundation components5
- Foundation components: disc3
- Foundation components: master cylinder2
- Power assist1
- Pedals and linkages1
- Foundation components: drum: drum1
- Antilock: interconnecting assembly(wiring)1
At what mileage
Complaints by mileage at the time of the problem.
GMC Suburban brakes problems in other years
Specific symptoms reported on the 1992 GMC Suburban brakes
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
Service brakes, hydraulic: pedals and linkages
- What is wrong
- The pivot bolt holding the brake pedal to its support bracket may be improperly tightened and may not have engaged the locking material on the bolt. The bolt can disengage from the nut.
- Risk
- If the pivot bolt disengages from the nut while thevehicle is in motion, there will be a loss of brake control and could result ina vehicle accident.
- Remedy
- Dealers should inspect the hand started brake pedal bolts and torque them to specification.
Recall number 92V056000 · Recall details
Related investigations
Poor brake performance
Poor performance of ABS brakes
EA95026
What 1992 GMC Suburban owners say
Most recent owner complaints, unedited.
Brake pedal went to floor while making a stop, and all brake warning lights came on.
I have had brake failure on this vehicle since I bought it. The brakes would lose hold and the vehicle would lurch forward as if it were on ice. I was able to avoid collisions through luck and also by being very aware of the problem and leaving extra space between the vehicle in front of me. Various dealers misdiagnosed this problem several times. First time, front brake job, second time, rear brake adjustment. Third time, they said the pump was bad. Miraculously the warning light came on for the very first time in the dealership. $900 later I have a new ABS pump. Now the truck pulls to the right. It did not do this before. Dealer suspected that the ABS pump was defective. Upon replacement, the truck still pulls to the right. They now suspect that the left front brake hose is breaking down internally and causing uneven pressure to the front calipers causing the pulling sensation. They are not sure, so this will be more $ out of my pocket for a trial and error that may or may not work. I have over $1300 in brake repairs and this vehicle still does not stop properly. I am running out of patience and money. Your help will be appreciated. Thanks.
In december of 1993, I was involved in a multi-car accident. While I did not create the accident, I did contribute by crashing into the rear of one of the cars. The cause - my brakes simply would not stop the vehicle in a normal amount of time. The ABS system made all kinds of interesting noises. However, the vehicle would not stop similar to other vehicles including my previous suburban that I had owned and driven. Following repairs, I took the suburban to a gmc dealer who replaced the master cylinder (at my cost) and idd a test drivel the mechanic said the brakes were working properly. They were not! And still do not work as well as other vehicles with or without anti-lock brakes. Recently I was makina a right turn when a younnster shot thru the intersection on a bicycle. I jumped on the brakes and again heard that sickening groan but no brake action. Fortunately the brakes eventually did grab and the young man swerved to avoid a collision. This recent incident caused me to re-read a syndicated news report from last july. The federal safety agency was working with gm to recall and repair ABS systems in various SUV's. The article also said a second investigation was under way involving my '92 suburban. I'd like to be included in that investigation. At present I still drive this vehicle and I know it will not stop in normal stopping distance. I have started to investigate removing the ABS system and installing something safer. Any advice you might provide would be appreciated.
While driving, was coming to a rolling stop, ABS brakes were applied & they would lock up on the 2-wd. Been to dealer & the ABS brakes repaired on 3/16/98. The locking of ABS brakes has returned. Manufacturer shows no recall of brake problem.
Upon applying the ABS brakes vehicle pulled right. Brake pedal had gone to floor in an emergency stop or while just wating at light or stop sign. Pressure would cause pedal to go to floor. Taking vehicle to dealer to check ABS system.
Towing brakes were erractic. Abs light kept flashing after entering gas station. Wasn't towing. Abs light came on after starting vehicle. When brakes were applied, red light came on for ABS. Have taken to dealer numerous time on ABS system & each time was informed owner's problem due to the towing that was done.
When brakes were applied vehicle shot ahead and then began to stop. All incidences of failure seemed to occur when the rear wheels momentarily lost control with pavement, I., going over a manhole cover that was recessed/pavement depressions at expansion joints or heavy concentrations of water. In the roadway. When vehicle encountered one of these conditions under heavy brake pressure, the ABS brakes wou;ld emit a loud groaning noise, and vehicle would accelerate ahead. Then after one or two car lengths would grab hold and try to stop. In all of these cases, there were no injuries.
Anti-lock brakes fail when in a potential sliding situation (going onto a slick surface, like ice or wet pavement). The ABS actually attempts to work, and then shuts off, leaving only the regular brakes. This has happened multiple times. Each time we have to pay to have something reset, otherwise the lights on the dash , saying there is a brake problem, remain on. We have been told by the dealer (several times) that it doesn't hurt to drive it like this, but the ABS are not working as long as those lights are on. This is very frustrating - at the time the ABS are needed, they fail, every time. I'm tired of them not working, and paying to have them reset.
Ea95026, poor brake performance; when applying the brakes harder than normal the ABS warning light came on and would not go off. There was some vibration in the pedal. Driver had to drive suburban off the road to avoid a crash. This happened on dry pavement and wet pavement. The dealer could not find a problem with the system, and reset the computer. The computer was reset twice for this reason. Please provide any further details.
Questions about the 1992 GMC Suburban brakes
Does the 1992 GMC Suburban have brakes problems?
Owners have filed 66 complaints about the brakes of the 1992 GMC Suburban, 85% of all its complaints, more than any other problem.
At what mileage do 1992 GMC Suburban brakes problems start?
Not enough complaints include the mileage to tell.
Was there a recall on the 1992 GMC Suburban brakes?
Yes, 1 recall: 92V056000. Check your VIN to see if your car still needs the free repair.
What year does the GMC Suburban have bad brakes?
The GMC Suburban model years with the most brakes complaints are 1994 (276 complaints), 1993 (162 complaints) and 1999 (123 complaints).
Other 1992 GMC Suburban problems
Visibility 12Engine 2Suspension 2Transmission 2Body 1Electrical 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 1992 GMC Suburban?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history