2021 GMC Yukon XL: engine knocking or ticking

Filed Nov 4, 2026 · Engine, Fuel system · MI

INCIDENT 1: Internal Engine Failure & Excessive Oil Consumption Component / System Failed: Engine Internal Components (Piston Rings, Valve Guide Seals, Spark Plugs) Failure Description: Excessive oil consumption (1.5 to 2.0 quarts burned every 2,000 miles) leading to heavy oil-fouling on spark plugs #5 and #7. Required complete cylinder head, oil pan, and piston teardown to replace all pistons, rings, connecting rod bearings, lifters, guides, valve guide seals, and spark plugs. Safety Risk: Severe internal engine oil consumption and plug fouling create an immediate risk of engine misfires, unexpected loss of power, or catastrophic engine failure while driving at highway speeds. Dealer / Repair Shop Confirmation: Confirmed by Dealership Service Department via oil consumption tests, spark plug inspection with oil dye, compression tests, cylinder leak-down tests, and physical teardown. Warning Symptoms: Low oil warning lamp illuminated; continuous need to top off oil between routine maintenance services. Inspection Availability: Vehicle and replaced components are available for inspection upon request.

Filed Oct 14, 2026 · Engine · AZ

On September 21, 2026, my 2021 GMC Yukon XL Denali with the 6.2L V8 engine experienced a serious engine failure at approximately 83,330 miles while traveling on Interstate 10 near Litchfield Road in Arizona. The vehicle developed engine knocking and subsequently stalled, leaving my family and me at risk on the highway. This was a serious safety concern because the engine failed unexpectedly during operation. The GMC dealership determined that the engine needed to be replaced under warranty. The replacement engine was installed in October 2026, and I received the vehicle back on October 13, 2026. My concern is that the dealership installed a remanufactured engine, and I have not received sufficient documentation confirming whether the replacement addresses the underlying defect associated with the GM 6.2L engine failures. I am concerned about the possibility of another catastrophic engine failure, particularly while traveling at highway speeds with my family. I am requesting that the federal safety agency investigate this engine failure and determine whether the replacement engine adequately addresses the safety defect. I believe these failures present a serious risk to drivers, passengers, and other motorists.

Filed Sep 29, 2026 · Engine · OK

The vehicle is consuming every bit of oil at about 1500 to 1800 miles of the 3000 mile guidelines before the next oil change. No leaks. No smoke. No knocking in motor.

Filed Sep 18, 2026 · Engine · MT

Vehicle has been consuming engine oil at a rate of approximately 1 quart per 500 miles. On XXX, owner added 1 quart of oil in [XXX], then drove a round trip to [XXX] and back (approx. 860 miles). On XXX at 55,329 miles — only 9 days and roughly 860 miles after that quart was added — an oil change was performed at an independent shop; the technician noted no oil was present on the dipstick prior to service. On XXX at 55,829 miles — exactly 500 miles later — the vehicle was taken to an authorized GMC dealership, and the dipstick again showed no oil prior to service. The dealer began the manufacturer's oil consumption test protocol, performing an oil and filter change and other maintenance. Within approximately 74 miles of this service (current mileage 55,903), the engine began making an audible knocking noise. Oil level was checked and confirmed full/normal, ruling out low oil as the cause. The knock has been intermittent — not present at cold idle start, but returning during driving conditions, raising concern about potential engine failure or loss of power while driving. They can not get it back in till XXX. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Sep 15, 2026 · Engine · TN

The rod bearing failed while traveling at highway speeds, so yes our safety as well as others traveling on the interstate. It is available for inspection. A dealership inspected and confirmed the reported problem. The manufacturer is aware of the persistent problems with these vehicles' engine components, reliability and safety. There were not any symptoms, warning lights, etc. prior to failure. I had just purchased the vehicle and it was inspected by two independent mechanics prior to failure. I have contacted the manufacture to find that my VIN was not covered under the recall. The recall covers vehicles manufactured starting 3/1/2021, my vehicle was manufactured 10/2020. THE RECALL SHOULD BE EXPANDED TO COVER ALL OF THESE VEHICLES.

Filed Sep 14, 2026 · Engine, Fuel system · TN

According to the GM Dealership the rod bearing failed disabling the engine. Dealer recommends replacing the entire engine. This consistent with recall N 252494000-N252494003 but my VIN is not included in the recall. Estimated repair $11,200. Our family was traveling roughly 55 mph on the interstate at the time of incident.

Filed Sep 10, 2026 · Engine · CA

My 2021 GMC Yukon XL Denali with the 6.2L L87 V8 has experienced two significant lifter/valvetrain failures. The first occurred at approximately 6,500 miles and was repaired by a GMC dealer. That failure involved cylinder #4, including a collapsed/stuck lifter and bent pushrod. The current failure occurred at approximately 110,269 miles. The vehicle initially operated normally. While traveling about 10 mph and approaching a major thoroughfare, the engine suddenly began making a loud knocking noise and the vehicle began shaking violently. There were no warning lights or other symptoms beforehand. Three children were in the vehicle. When the driver attempted to accelerate, the vehicle failed to gain speed normally, and additional accelerator input made the knocking and shaking significantly worse. The check-engine light began flashing, and “Service ESC” and “Service Traction Control” warnings appeared, along with multiple other warning lights. The engine continued running. The driver made a U-turn before entering the major roadway and drove about 0.2 miles very slowly back home. An independent repair facility diagnosed P0305, cylinder #5 misfire. Moving the ignition coil and spark plug did not move the misfire, and the #5 spark plug was oil-soaked. A GMC dealer later confirmed a stuck lifter on cylinder #5 and advised that the failed lifter damaged the camshaft. My concern is the sudden loss of normal acceleration and severe engine malfunction without warning, especially because this same L87 engine previously suffered a major lifter failure at low mileage. I am asking the federal safety agency to determine whether repeated L87 lifter/valvetrain failures represent an additional safety-related defect or failure pattern.

Filed Aug 31, 2026 · Engine · SD

the engine started knocking and vehicle shaking while on interstate. vehicle was towed to service center and they determined that one valve was stuck and another one turned 90 degrees and the cam shaft was also ruined. It was required to replace the engine as that was a less costly option than replacing the damaged parts. A dash light came on and was flashing while my daughter was driving it to [XXX]. The vehicle was towed from the parking lot they were at when reaching [XXX]. Unsure of where the engine went to after the service center removed it, but I think they had to send it back to GM. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Aug 25, 2026 · Engine · CA

Driving on the freeway the engine started making super loud knocking noises for while going 70mph . Then it immediately died everything turned off no power I was barely able to get it off the freeway while coasting. And my husband tried to push it off the road more but when it dies we are not able to put the car in neutral !! It’s a push button gear shift ! When there’s no power the buttons don’t work!! It was 105 degrees out that day in Sacramento , the car had zero power the battery is not the problem . The motor is blown and the car hasn’t started since that day. These cars are dangerous to just die in the middle of the freeway! The motor has already been replaced in Feb 2026, we bought it in march of 2026 with 57k miles on it. I added about 12k miles and the motor blew up again!

Filed Jul 7, 2026 · Engine · GA

This is from dealership “found customers concern of engine light is on and ticking noise found cylinder 4 lifters to be collapsed causing the exhaust gasses to be trapped in the cylinder causing the cylinder wall to dry out and leaving scratches on the cylinder wall recommend replacing motor due to this problem at this time”

Filed Apr 26, 2026 · Engine · PA

On April 20th, 2025 while accelerating from a stop light, my vehicle (2021 GMC Yukon Denali XL, 6.2L V8) started making a ticking noise and the service engine light started flashing. I was within a few minutes of my house and limped my vehicle home. The next morning, I started it and it exhibited the same symptoms. I called my local GMC Dealer, Wright Buick GMC, and was advised to have the vehicle towed to them. It was towed to the dealership and within a few days I was advised that the engine needed replaced. I had heard a story that there was a pending recall, so I had hoped that this would resolve itself without a bill to me. unfortunately I was advised that there was no actual outcome on how to handle recalls, so if I wanted my vehicle back, I would have to pay the $11K for replacement as I was outside of my power train warranty (I had roughly 73,000 miles on my car). I have hoped for some resolution to include my vehicle in this recall but I have not yet received any word from GMC.

Filed Apr 16, 2026 · Engine · LA

I previously opened the federal safety agency Complaint Number11637208 on January 20, 2025 regarding the internal engine failure of my 2021 Yukon Denial XL on January 3, 2025. After filing that Complaint, the engine in my Yukon was replaced by GMC in February 2025. After replacement, the engine was allegedly tested, given an oil cap change, and OK'd by the GMC dealership. On Sunday, April 12, 2026, the replacement engine in my Yukon failed without warning and left me (and my family members, who were also in the Yukon) stranded in the lane of traffic on the westbound College Drive exit of I-10. We had it towed to the GMC dealership (Royal Buick GMC) the same day, they diagnosed it, and according to text communications I received from them on April 14, 2026, the Yukon's engine needs to be replaced again because the engine internally failed - likely due to the failure of the engine's internal rod bearing. No one in my family feels safe in the Yukon anymore. GMC should not be allowed to replace these engines with more faulty engines. If something more is not done soon, people are going to die because of the wrecks caused by these faulty engines.