2001 GMC Yukon engine problems

Filed Nov 18, 2025 · Electrical, Engine · LA

UNKNOWN one the the main problem wheel hub engine electrictrical

Filed Sep 2, 2014 · Engine · 173,000 miles · AZ

Tl* the contact owns a 2001 gmc yukon. While driving approximately 50 MPH, the engine stalled without warning and the vehicle failed to restart after several attempts. The vehicle was towed to the contact's residence and was not diagnosed or repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 173,000.

Filed Mar 19, 2014 · Acceleration, Engine · 68,000 miles · CA · crash

My complaint is related to the already in effect recall for gm recall no. 06083. I want to request that another investigation be done. Due to the fact that I have been having the same type of problem with my 2001 gmc yukon sle 5.3l v8. The problem began a few years back in 2006 and until this present time, its getting worse as time passes by. When it happened the very first time I contacted gm and they obviously said that they had no reported incidents as the one that I was describing for my vehicle.then when I saw the recall on the local news in 2007 I gave them a call back and again they claimed that no incidents were reported for my specific model and engine, so they brushed me off quickly as if I were just calling cause I had nothing else to do & was just looking to waste my time and theirs!. I have had a couple of incidents occur where the truck has stall while in drive and at a speed between 10 -40 MPH on a southern california fwy (where you can always count on traffic congestion). My family members and myself have been very lucky to have escaped without injury.in trying to understand what's happening with my vehicle I came across many gmc owner forums were complaints from people with my same engine and model SUV had been looking for the reason and solution what caused that vehicle behavior. My SUV has the same exact issues described in the following paragraph which I copied from the recall explanation : "the crankshaft position can operate intermittently or fail completely. If the sensor operates intermittently, the ses light may illuminate and the vehicle may run rough. The engine may stall, and if so, may re-start immediately or after a cool down period." consequence: "if the sensor becomes completely inoperative, the engine will quit running and will not re-start. Either of these failures can increase the risk of a crash" investigate&help consumers.

Filed Mar 20, 2006 · Engine, Fuel system · NJ

2001 yukon transmission seal failed because of rough shifting, serpentine drive belt squeaks. Vehicle leaked fuel consumer had to get a ride home while fire dept cleaned up spill. *ts a seal failed and coolant leaked into the transmission and destroyed it. The radiator seal failed. The head light lens was loose.

Filed Apr 23, 2005 · Engine · 42,550 miles · CA

On three separate occasions my check engine light came on and all three times the sai (emissions) valves were rusted causing them to fail. The dealer told me since the valves are located directly under the exhaust the condensation falls onto the them causing them to rust. They also said there is no permanent fix for this.

Filed Oct 27, 2004 · Acceleration, Body · FL

Multiple failures; A/C odors, door lock, suspension alignment and brakes. *bf there were problems with the following: weather strip was loose, the A/C blew warm, the belts squeaked, there was a mildew odors, the window regulator, the front seat belt squeaked, the door panel, the steering wheel rattled, drive shaft, accelerator pedal, the wipers were noisy, the hinge pin on the radio was loose, engine noises, A/C drain would not drain at times until the passenger door was closed/water lead and caused by the left front floorboard. Recall#01v159000, 02v253000, 03v094000.

Filed Jun 12, 2003 · Electrical, Engine · 2,000 miles · CA

The serpentine belt has been replaced twice and then the alternator was replaced because when the truck is started it makes a squealing noise and after all that, it still makes the noise.

Filed Apr 1, 2003 · Electrical, Engine · MS

Cruise control failure caused by an aberrant voltage on stop lamp circuit. Also the PCM, starter and serpentine belt was replaced. *ak

Filed Jun 25, 2002 · Engine · CA

Vehicle had been sitting for about 2 hours and consumer drove vehicle less than a block and temperature gauge was showing hot. Consumer pulled over, and black smoke was coming from hood. Catalytic converter was red hot. Took vehicle to dealer, and dealer stated that fuel was dumping in catalytic converter. Please provide any further information.

Filed Mar 5, 2002 · Engine · MI

When vehicle is cold engine makes a knocking noise and is sluggish. Duration of the problem has progressed currently affecting vehicle when it warms up. Dealer was contacted and was aware of problem. *ak consumer states the engine has piston problems.