transmission seized up
2007 GMC Yukon: engine failure
5 of the 428 complaints about the 2007 GMC Yukon describe engine failure.
- owner complaints
- 5
- of this car's complaints
- 1%
- recalls
- 0
Engine failure by model year
What owners say
Happened two times yesterday. 2007 yukon denali odometer: 191,707 engine hours: 1443.9 first, stabilitrak control turned off and engine power was reduced illuminated on the message center of the dash board. Car would not accelerate above 20 MPH. When I would try to push the gas petal there would be a shutter in the rear of the vehicle. I was able to put the car in park, turn it off and tried restarting. Same issues continued. I limped to my work a less than a mile away to try and figure out what was happening as I had myself and 4 kids in the car after trick or treating. I shut off the car and waited for a bit while I read online what was causing this. Upon restarting the car, it started working again as normal. Safety risk when you can't accelerate past 20 MPH on a 45 mile per hour road. Second occurance was a few hours later. I turned the car on to leave and the same things happened, this time it was driving like I had lost my power steering and no engine power. Luckily, again, I was in a spot to pull off to the side, turn the car off and made it home okay. This car has a brand new engine. Upon reading here and some other things online it seems the stabilitrak has numberous reports of this same thing. Luckily I have been in a spot where it didn't become dangerous and I knew what to do based on reading here. I use my yukon for work so can't have this happening and it's dangerous for myself, my kids and other drivers on the road if they happen to be behind me when it happens. Hopefully with enough complaints something can be done to fix this issue. I have included a pic of the symbol that illuminated on my dashboard when this happened.
74,000 miles on the odometer and loud ticking noise coming from the engine on the left side. After doing my research and taking it to the dealership hamby in perry, ga they said I needed a new engine but I got a second opition it is the afm lifters a camshaft thats causing the noise gm needs to do a recall asap
While driving on surface streets, the yellow ABS warning came on, "stabilitrack" light came on. The warning lights started dinging, the transmission slammed between gears, the lights came and went and the door locks were going up and down continuously. Lost power also, pulled off and shot off engine. Truck would not restart as electrical system was dead. Same thing happened 10k miles earlier. This has happened 2times and the car only has 53,000 miles. Repairs took over 10 days as the engine was not communicating with the car. Replaced engine control module
When vehicle was inspected I was told that there was an exhaust leak in exhaust manifold. Dealership found a broken bolt on left side and replaced it. I have just been informed that I now as of 01/30/2012 with 62,760 miles I have another bolt broken on the right side. After researching on internet it is obvious that gm has a design fault in using lower grade bolt which are breaking in large numbers. I implore the ntsa to require gm to replace these defective bolts either by recall or as incident occurs at no cost to car owners. I am told that the exhaust leak can cause failure of the catalytic converter and other engine failure problems which can result in safety issues.
Service bulletins that may apply
- This service bulletin provides information for maintenance cleaning of the fuel injectors and gasoline...
- This service bulletin provides guidelines and diagnostic/repair information to technicians regarding...
- This service bulletin advises of a new fuel injection cleaner kit used for decarbonizing the intake valves...
- This service bulletin provides technicians with information to help identify the differences between what...
- This technical bulletin advises of a new fuel injection cleaner kit used for decarbonizing the intake...
- This service bulletin provides service information to technicians on guidelines to replace Oil Cooler, Oil...
- This PI bulletin advises the technician on the proper way to install the pistons in an engine.
- Engine and engine cooling
Related recalls
No recalls on record for this model year.
Questions about the 2007 GMC Yukon engine failure
Is engine failure a common problem on the 2007 GMC Yukon?
5 of 428 owner complaints about the 2007 GMC Yukon (1%) mention engine failure. The model year with the most reports is 2023.
Is there a recall or service bulletin for this on the 2007 GMC Yukon?
There are 0 recalls and 179 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2007 GMC Yukon
Door locks 26Check engine light 22Loss of power 17Airbag light 11No deployment 6Jerking 6ABS 5Grinding brakes 5Fire or smoke 5Seat belt 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2007 GMC Yukon?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history