Check a VIN

Home And Park Roadtrek recalls

There are 8 safety recalls on record for the Home And Park Roadtrek, covering 5,494 vehicles in total across all the models in each campaign. Newest first.

Home And Park Roadtrek recalls by model year

2006 12002 12001 12000 11999 11998 21994 21993 11992 21991 21990 1

All recalls

Equipment: other: labelsReported May 11, 2006 · 736 vehicles affected
What is wrong
On certain motor homes built on chevrolet chassis and equipped with a decorative dash trim kit, the adhesive backed synthetic trim is attached to the dash, engine cover, door panel and the chevrolet "bow tie" decal is attached to the steering wheel (directly over the existing bow tie impression). This decal could affect the deployment of the air bag safety restraint built into the steering wheel.
Risk
In the event of a vehicle crash in which the driver side air bag is deployed, the resulting functionality of the air bag is uncertain, which can increase the risk of injury to vehicle occupants.
Remedy
Owners will be instructed to remove the steering wheel decal. The recall began on may 30, 2006. Owners may contact home and park at 1‑800‑663‑0066.

Recall number 06V160000 · Recall details

Seat belts: front: anchorageReported July 26, 2002 · 249 vehicles affected
What is wrong
On certain motor homes built on chevrolet g-van chassis, it is possible, that on some units, the passenger side seat belt was not assembled correctly to the structural member of the vehicle. The swivel plate may not be attached to the bolt holding the retractor assembly.
Risk
In the event of a crash, the seat occupant may not be properly restrained increasing the risk of personal injury.
Remedy
Dealers will remove and reinstall the swivel plate correctly. Owner notification began july 25, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact home & park at 1‑888‑762‑3873.

Recall number 02V206000 · Recall details

Fuel system, gasoline: storage: tank assembly: filler pipe and capReported November 26, 1999 · 606 vehicles affected
What is wrong
Vehicle description: class b motor homes built on dodge 3500 or 2500 van chassis. The generator fuel pickup fitting was self tapped into a drilled hole beside the fuel sending unit on top of the plastic fuel tank. Sealant was used on the thread before the fitting was screwed into the tank. On some vehicles, the fuel pickup fitting was not sealed properly against the tank wall, and when the tank is full, fuel or fuel vapors can leak out.
Risk
In a crash, fuel or fuel vapors can leak when the tank is full, increasing the risk of a fire.
Remedy
Dealers will replace the self tapping fuel pickup with a new one with regular thread fitting secured to the tank with a lock nut inside the tank.

Recall number 99V335000 · Recall details

Fuel system, gasoline: delivery: hoses, lines/piping, and fittingsReported October 20, 1998 · 404 vehicles affected
What is wrong
Vehicle description: class 'b' motor homes built on dodge 1500, 2500 and 3500 van chassis. The fuel line from the fuel tank to the engine may not be properly secured to the chassis. The fuel line can contact the engine exhaust manifold creating a fuel leak.
Risk
This condition can cause fuel or fuel vapor leaking resulting in a potential fire hazard. Also the engine could stall from lack of fuel, resulting in loss of power braking and power steering control.
Remedy
Dealers will inspect the fuel line for heat exposure damage, replace if necessary, and install the fuel line into existing plastic clamps. A nylon cable tie will be added to secure the fuel line to an adjacent wiring harness.

Recall number 98V261000 · Recall details

Fuel system, gasoline: storage: tank assembly: filler pipe and capReported June 22, 1998 · 404 vehicles affected
What is wrong
Vehicle description: class 'b' motor homes built on dodge 1500, 2500 and 3500 van chassis. The fuelvent hose from the fuel tank to the fuel fill entry may not be vapor tight due to over tightening of the gear clamp at the connection of the plastic vent tank outage to the rubber vent hose. This can result in fuel or fuel vapor leaking.
Risk
This condition can cause fuel or fuel vapor leaking resulting in a potential fire hazard. Also the engine could stall from lack of fuel, resulting in loss of power braking and power steering control.
Remedy
Dealers will remove the gear clamp securing the rubber vent hose to the plastic vent tube, install a rigid insert tube into the plastic vent tube, and reattach the hose and clamp. The riberglass cover in the running board storage compartment must first be removed for access.

Recall number 98V136000 · Recall details

Parking brake: conventional: mechanical: linkage and cableReported September 16, 1994 · 271 vehicles affected
What is wrong
The parking brake cable is routed to the right rear wheel causing it to cross and contact the steel brake line. This can cause the abrasion and rupture of the steel brake line resulting in a loss of brake fluid.
Risk
Loss of brake fluid due to the rupture of the steel brake line causes loss of rear braking capability which can result in extended stopping distances and can cause an accident.
Remedy
Dealers will reroute the parking brake cable away from the steel brake line. The steel brake line will be replaced if abrasion or wear is evident.

Recall number 94V163000 · Recall details

Equipment: electricalReported March 2, 1993 · 969 vehicles affected
What is wrong
The generator exhaust pipe, located at the rear roadside of the vehicle, can emit hot exhaust gases from a damaged, worn, defective, or improperly installed exhaust pipe, melting the adjacent polyethylene storage trunk.
Risk
The damaged storage trunk allows generator and/or vehicleexhaust gases to enter the vehicle, resulting in a hazard to vehicle occupants.
Remedy
Replace any defective generator exhaust pipes, repair holes in the polyethylene storage trunk, and install a heat shield between the generator exhaust pipe and the storage trunk.

Recall number 93V026000 · Recall details

SeatsReported November 2, 1992 · 1,855 vehicles affected
What is wrong
1) the seat system slide tracks do not allow the seats to slide, and there is an incorrect angle of the upper torso safety belt caused by non-chrysler hardware at the shoulder safety belt anchorages.
Risk
The vehicles do not meet the requirements of fmvss 207,"seating systems" and fmvss 210 "safety belt assembly anchorages". Occupants ofthe affected seats would not be sufficiently protected in the event of a suddenstop or accident.
Remedy
Replace the defective seat slides with a stronger double locking slide track; replace the long slide tracks with shorter slide tracks, and replace the non-chrysler safety belt anchorages with conforming chrylser hardware.

Recall number 92V157000 · Recall details

Questions about the Home And Park Roadtrek recalls

How do I check if my Home And Park Roadtrek has an open recall?

Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.

Do I have to pay for a recall repair?

No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.

How many recalls does the Home And Park Roadtrek have?

8, covering equipment, seat belts and fuel system, gasoline.

VIN decoder

See the problems and recalls for an exact car

Buying a used Home And Park Roadtrek?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history