Bike has always had a lean/off-idle stalling issue. Stalling in traffric can be deadly!
2013 Husqvarna TR650 engine complaints
Page 2 of 2: complaints 11 to 28 of 28, newest first, as owners wrote them.
The motorcycle sometimes stalls when slowing down for a turn, a stop, or when taking off from a stop. It has happened both while moving and at a stop. Normally happens on city streets.
Tl* the contact owns a 2013 husqvarna tr650. The contact received a recall notification for the federal safety agency campaign number: 16v124000 (engine and engine cooling). The part needed was unavailable to perform the recall repair. The manufacturer was not notified of the issue. The VIN was unknown. The contact had not experienced a failure. Parts distribution disconnect.
Motorcycle experiences unexpected stalling while operating at low RPM's and speed. Problem is intermittent and apparently random, occurring while accelerating or decelerating. To date it has resulted in one slow speed off-road crash. I was not injured, but am concerned that the problem will result in a much more serious on-road crash.
Motorcycle will stall when taking off from a stop or when slowing down from a steady cruise to make a turn. It is dangerous to cross an intersection, I have to rev engine high and slip clutch more than normal. Bmw designed the motorcycle and owns the rights to the firmware to the engines computer. Bmw sold husqvarna to ktm and we are left high and dry without any updates to the ECM. Bmw has a similar motorcycle g650gs that has the same motor and ECM and they have received multiple updates yet bmw will not help or release the codes to the ECM so we can get this problem fixed.
The engine will randomly stall at slow speeds and rpms. This sometimes occurs both when pulling away from a stop or when coming to the stop when the clutch lever is pulled. The engine will often stumble and sometimes completely stall.
Engine stalls when trying to accelerate forward from a stop. This has caused several close calls when cars behind that expected me to move forward nearly rear-ended me. I now am in the habit of revving up the engine way more than should be necessary in order to avoid the stall.
Engine stalling at low speeds for motorcycle this puts driver in very dangerous situation prone to crash and/or getting hit from behind.
Since day one, this bike has stalled randomly when slowing for traffic or when coasting on roadways. It has caused me to fall over in grass when the bike did not fuel when it should have. It also has a random high idle and fueling is horrible throughout the rev range. I have gone to four different husqvarna dealerships on the east coast of the USA with no help. They all advise that now that ktm owns husqvarna that they do not have nor do they want the moss tool software to attempt to rectify the issues. It is a serious safety hazard which has caused me to nearly be struck several times when I hope to start from a stop but eh bike stalls and I'm stuck in a traffic lane. I barley ride my motorcycle that I paid thousands and thousands of dollars for. Canada has issued a recall and I see no reason that the USA should not have a recall and make bmw (the owner of husqvarna during the making of my bike) or ktm (the owner of thusqvarna now) to fix this serious safety issue. Please help!!!!
Engine stalls randomly at low speeds when often times when trying to accelerate from a stop but may also happen when approaching a stop.
This motorcycle stalls often and with no warning. Especially when slowing down or coming to a stop. I have stalled at least 20 times. The last stall was on a downhill coming out of the drive way. At the end of the driveway I slowed down to make a right turn and the engine stalled causing me to fall. I hurt my neck and badly burned my leg. I will not ride this bike until husqvarna/bmw fix this stalling problem. This stall is caused by a poorly mapped ecu (elecrtric control unit). The low speed fuel delivery is so lean that the engine just stops upon slowing down. This could be deadly while negotiating an intersection. I have called several husqvarna dealers but they refuse to offer any help.
At low engine RPM and/or at low vehicle speed, the engine stalls and shuts off. This has occurred over 25 times ever since I took delivery of the vehicle. This is a very dangerous fault because in certain situations, stalling can result in injury, dropping the vehicle, or even a fatality.
Tl* the contact owns a 2013 husqvarna tr650 motorcycle. The contact stated that the motorcycle would decelerate and stall. The vehicle was not diagnosed or repaired. The manufacturer was notified. The failure mileage was 10. Updated 10/2/14*cn the consumer stated the motorcycle would stall at random low speeds. Updated 10/07/14 the vehicle was repaired under recall. Updated
My husqvarna tr650 motorcycle has a stalling problem at low speed/coming off of idle. When starting to move from a stop, the motorcycle periodically stalls. This is a potentially dangerous situation because the bike will start moving before the stall occurs, potentially putting the bike and occupant in the path of oncoming traffic while the rider attempts to restart the motorcycle. The problem has repeatedly occurred since I purchased the motorcycle. The problem is well cited on the following husqvarna motorcycle owners forum: http://www.cafehusky.com/forums/tr650.28/.
The motorcycle runs severely lean, causing it to stumble and stall at low rpms. This is primarily noticed when accelerating from idle. My first experience with it was making a left turn across a four lane road with oncoming traffic. As I started to move forward and leaned into the turn, the bike stalled causing the rear tire to quickly lockup as engine power was cut. I disengaged the clutch, but was too late to prevent crashing. Luckily, oncoming traffic saw me soon enough to stop, and I avoided being struck by an oncoming vehicle. The crash was low speed and resulted in only minor injury to my left leg, but prevented me from riding and performing airborne operations (army) for a few weeks. In my 6000 miles since the original accident, the vehicle has suffered countless off-idle stalls, and has put me in jeopardy many times.
Stalls often while pulling away from a stop, also happens while riding at low speed.
Tl* the contact owns a 2013 husqvarna tr650. The contact stated that the motorcycle stalled while accelerating. The motorcycle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was 10 and the current mileage was 13,800. Updated 09/16/14*lj the consumer stated the engine would sometimes stall when engaging the clutch after a complete stop. It occurred on different occasions when pulling into traffic. Updated 11/18/14
Tl* the contact owns a 2013 husqvarna tr650 motorcycle. The contact stated that while sitting at a stop, the vehicle stalled when the contact tried to accelerate. The failure continued to occur intermittently over a period of one year. The vehicle was not taken to the dealer for a diagnostic testing, however they could not duplicate the failure. The manufacturer was not notified of the failure. The approximate failure mileage was 2,600.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2013 Husqvarna TR650?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history