The contact owns a 2011 Hyundai Tucson. The contact received notification of the federal safety agency Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
2011 Hyundai Tucson brakes complaints
Page 2 of 2: complaints 11 to 34 of 34, newest first, as owners wrote them.
Nothing yet, but the information sent to me on 11-28-2023 stated that the defect could cause a fire and be quite dangerous, but no remedy has come forth yet. It is unsettling to drive a car which could catch fire while driving or parked. How long do we patiently wait for our cars to burst into flames?
The contact owns a 2011 Hyundai Tucson. The contact received notification of the federal safety agency Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2011 Hyundai Tucson. The contact stated while driving 25-30 MPH at night, the vehicle was shuddering and lost motive power. The contact was able to veer to the side of the roadway. The contact off and restarted the vehicle, and the check engine warning light illuminated. The contact continued driving; however, the failure recurred, and the vehicle could not exceed 30 MPH. The contact pulled into the nearest gas station. The vehicle was towed to the dealer, where it was diagnosed and determined that the engine needed to be replaced. The manufacturer covered the cost of the repair. The vehicle was repaired. Additionally, the contact received notification of the federal safety agency Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was approximately 116,000. VIN tool confirms parts not available.
The contact owns a 2011 Hyundai Tucson. The contact received notification of the federal safety agency Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2011 Hyundai Tucson. The contact received notification of the federal safety agency Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2011 Hyundai Tucson. The contact received notification of the federal safety agency Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2011 Hyundai Tucson. The contact received notification of the federal safety agency Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2011 Hyundai Tucson. The contact received notification of the federal safety agency Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2011 Hyundai Tucson. The contact received notification of the federal safety agency Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The local dealer was made aware of the issue and confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2011 Hyundai Tucson. The contact stated that while driving at an undisclosed speed, the brake pedal was depressed and went to the floorboard. The ABS, the Hill Descent, and an unknown warning light were illuminated. The contact received notification of the federal safety agency Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact called an independent mechanic and was referred to the federal safety agency Hotline. The failure mileage was unknown. VIN tool confirms parts not available.
The contact owns a 2011 Hyundai Tucson. The contact received notification of the federal safety agency Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The local dealer was made aware of the issue and confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2011 Hyundai Tucson. The contact received notification of the federal safety agency Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
No known malfunction at this time on my vehicle - however a recall #251 has been issued with no repair available. Recall strongly recccommends parking car outside and away from structures due to possible fire which can also occur during driving. This problem has been going on with Hyundai cars for several years - AND THEY STILL DON'T HAVE A SOLUTION??? I called my two local dealerships and neither was aware of recall campaign 251. I asked if my ABS module completely failed - what module would they replace it with? I was advised that they would probably sell me a new one costing $1900 plus labor THAT HAS THE SAME PROBLEM!!! Hyundai is not taking this seriously - This is not being repaired in a timely manner. PLEASE RESTRICT THEM FROM SELLING ANYMORE CARS IN THE USA UNTIL THIS RECALL HAS A REMEDY!
The contact owns a 2011 Hyundai Tucson. The contact received notification of the federal safety agency Campaign Number: 23V651000 (Service Brakes, Hydraulic) however, the part to do the recall repair was not yet available. The local dealer was contacted and determined that the parts were not available for repair. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue and confirmed that parts were not available for repair. The contact had not experienced a failure. VIN tool confirms parts not available.
Recalls for my model
The ABS and Master Cylinder both had a pressure leak which caused the brakes to not engage. The sensor light also never activated to indicate a problem. While driving down the road my brakes would not engage unless I began to pump them, and even then they were unpredictable. We do not currently have the old parts as it was disposed of by the mechanic we went to. The independent mechanic was able to replicate the problem when the car was at a standstill in the shop. It was not inspected by anyone but the independent mechanic. There was no warning prior to this issue occurring. It started out small and I reported it to my mechanic but they could not replicate it. However within a time frame of 3 weeks, it was very severe and deemed unsafe to drive. P
Highway, bridge, following significantly far back. Car stops ahead and I brake in plenty of time (my son was in the front seat and can attest to that). Car brakes but very slowly, not in time so we hit the stationary car and then we were hit much harder from behind. Airbags deployed. The car immediately filled with smoke which I attributed to the air bags because I did not know any better. Very scared, I screamed for the kids to get out of the car. Smoke was gone by the time police arrived. We were ok, my son and I had sore ribs and while talking with police my left hand was burning from something. Nothing was visible so I saw know point in telling anyone. It left a rash and within time it peeled and now is back to normal. A few days later, had some headaches. Went to the athletic trainer at our school (I am a teacher) and was put on concussion protocol. Car was totaled. The front looked like an accordion as we were pushed significantly into the vehicle in front by the car who hit us from behind. I was so relieved that everyone was ok that I really did not think about it until recall notice came for the car which of course was already gone. Engine problems with "oil leaks and possible spontaneous fires, increasing risk for accident" is the wording on the recall.
Both the downhill brake light and stability track control light came on at the same time. My car wouldn't get out of park, or when I got it in drive, it wouldn't go back into park. Taking it to the shop today, noticed it might be from a brake switch.
The downhill brake control (dbc) indicator and the electronic stability control (ESC) lights come on while car is in operation for no apparent reason - driving normal speed - about 45 MPH, in normal dry road conditions. When I go to stop the car, the shift lever gets stuck and cannot put in park. It takes a few tries at jiggling the shift lever and jiggling key in ignition to get it to go into park. After shutting off engine, restart is normal with the dbc and ESC lights no longer on. This has happened at least 10 times since original time I noticed it a few months ago. Due to death in the family and other issues, have not been able to take it into to dealer since the first occurrence I noticed in march. I'm taking it in tomorrow and will advise.
Incline and traction control lights illuminated on dash, signaling an electrical problem. Discovered that exterior brake lights failed to illuminate upon depression of brake peddle, or would work intermittently. Also discovered that while the vehicle was in this condition, the car would not allow the gear shift to go into park. This was a very dangerous condition for this vehicle and could have resulted in the vehicle being rear ended due to the inoperable brake light indicators.
Comment: I have brought in my tucson for the clunking transmission issue 5 times now. Each return to the service center results in a cannot duplicate response. 1. On the morning of 28 march 2013, approximately 20 seconds after starting the vehicle the transmission was shifted into drive, a loud mechanical clunk was heard and felt from the driver's seat, the transmission did not respond, the vehicle would not move when the gas pedal was depressed, and the p,r,n,d indicator in the dash board display went blank. The car was shifted into p, a loud mechanical clunk' was heard and felt followed by a loud crunch'. The ignition was turned off, and the vehicle was restarted with no issues once the vehicle was warmed up. 2. Recall service for the transmission cooling line coupling performed, the vehicle began exibiting the transmission disengage and reengage symptom while driving under acceleration. This occurs approximately once a day under any incline or flat condition while accelerating. 3. While accelerating up hill, specifically up hill while accelerating up to 45 MPH the vehicle will down shift to climb the hill. Under 2 conditions 1. Cruise control engaged, 2. Constant accelerator pedal application.the vehicle will not re-upshift once the hill has been completed and keeps an elevated RPM range of approximately 3000 RPM even while on level ground while passing tax and revenue. The rpms do not lower and the transmission will not up shift until either the brake pedal is depressed (to disengage the cruise control), or the accelerator is lifted. Note: the entire time this situation is occurring the econ green light is illuminated.. The safety issue is that the transmission intermittently disengages while driving, sometimes while departing intersection. The transmission roblem has continued and grown worse with exapnding problems.
Tl* the contact owns a 2011 hyundai tucson. The contact stated that when driving at least 5 MPH over road bumps that the vehicle would sporadically lose braking power for one to two seconds. The vehicle was not inspected by a dealer nor repaired. The manufacturer was not contacted. The failure mileage was approximately 1,700.
2011 hyundai tuscon speed sensor wires located behind tires. Wire is fully exposed to any road debris, easily severed which effects ABS and traction control. Wire sticks out 3 inches in open air of the under carriage, also located close enough to the tires that if they kick up any debris it is in the direct path of the wire. Not heavy duty rap over the wire and could be broken by gripping by hand and pulling on it.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2011 Hyundai Tucson?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history