1997 International Harvester 3800 recalls
There are 3 safety recalls on record for the 1997 International Harvester 3800, covering 36,034 vehicles in total across all the models in each campaign. Newest first.
All recalls
Service brakes, hydraulic: foundation components: disc
- What is wrong
- On certain school and transit buses built with bosch zero offset pin slide (zops) hydraulic disc brakes, the zops hydraulic disc brakes may experience calipers sticking in the applied position, which can result in excessive or abnormal heat generation at one or more of the brakes.
- Risk
- The combination of the following factors may collectively result in an unreasonable risk to motor vehicle safety: potential fire at a wheel end, high incident rates of stuck calipers, and evacuation and containment concerns relating to multiple passengers.
- Remedy
- International will notify its customers and repair the buses free of charge. The recall began october 29, 2004.
Recall number 03V062000 · Recall details
Vehicle speed control: accelerator pedal
- What is wrong
- Vehicle description: school buses equipped with the international i6 electronic engine and an extra thick bus body floor. The accelerator pedal to floor clearance is approximately 1.2 inches with a standard bus body floor. However, some customers ordered an additional 3/4 inch thick floor and extra thick floor mats to serve as insulation in cold climates. When this extra flooring is used, the bottom edge of the accelerator pedal, when depressed, can come in contact with the floor.
- Risk
- Should the accelerator pedal contact the floor, the pedal could get caught and not return to the idle position increasing the risk of a vehicle accident.
- Remedy
- Dealers will inspect the flooring on these buses to insure there is a minimum of 1/4 inch clearance. On buses with less than 1/4 inch clearance, the dealer will remove the pedal and cut off the bottom of the pad to obtain the proper clearance.
Recall number 96V239000 · Recall details
Suspension: rear
- What is wrong
- Vehicle description: school buses and heavy duty trucks equipped with rear axle assemblies produced by dana spicer. Certain rear axle assemblies were improperly heat treated which could allow pinion breakage at the pinion threads.
- Risk
- Cracks can initiate and result in separation of the threaded end of the pinion resulting in separation of the yoke and drive line from the rear axle increasing the risk of a vehicle accident.
- Remedy
- Dealers will replace the rear axle carrier/pinion assembly.
Recall number 96V240000 · Recall details
Questions about the 1997 International Harvester 3800 recalls
How do I check if my 1997 International Harvester 3800 has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the 1997 International Harvester 3800 have?
3, covering service brakes, hydraulic, vehicle speed control and suspension.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1997 International Harvester 3800?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history