2000 International Harvester 4400 recalls
There are 3 safety recalls on record for the 2000 International Harvester 4400, covering 66,671 vehicles in total across all the models in each campaign. Newest first.
All recalls
Electrical system: 12v/24v/48v battery: cables
- What is wrong
- On certain heavy duty trucks equipped with international dt530, cummins, or caterpillar I-6 engines, the positive battery cable between the batteries and the starter may rub against an electrical ground cable between the starter and frame rail.
- Risk
- This could cause an electrical short and/or fire.
- Remedy
- Dealers will inspect for any chafing. If there is no evidence of chafing, a saddle clamp will be installed. If there is evidence of chafing, the damaged cables will be replaced and the saddle clamp installed. The recall began on august 16, 2004. Owners should contact international at 1‑800‑448‑7825.
Recall number 04V306000 · Recall details
Service brakes, hydraulic: foundation components: disc
- What is wrong
- On certain school and transit buses built with bosch zero offset pin slide (zops) hydraulic disc brakes, the zops hydraulic disc brakes may experience calipers sticking in the applied position, which can result in excessive or abnormal heat generation at one or more of the brakes.
- Risk
- The combination of the following factors may collectively result in an unreasonable risk to motor vehicle safety: potential fire at a wheel end, high incident rates of stuck calipers, and evacuation and containment concerns relating to multiple passengers.
- Remedy
- International will notify its customers and repair the buses free of charge. The recall began october 29, 2004.
Recall number 03V062000 · Recall details
Power train: clutch assembly
- What is wrong
- On certain heavy duty trucks equipped with manual transmissions, lower clutch rods with turnbuckles are failing from fatigue near the turnbuckle due to bending forces experienced during each clutch pedal cycle.
- Risk
- The clutch rod can break without warning and make it difficult to shift and if the clutch rod breaks while the vehicle is stopped or decelerating, the vehicle could lunge unexpectedly in the direction of the selected gear, increasing the risk of a crash.
- Remedy
- Dealers will replace the clutch rod assembly with a solid rod design that does not have a turnbuckle. Owner notification began july 19, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1‑800‑448‑7825.
Recall number 02V174000 · Recall details
Questions about the 2000 International Harvester 4400 recalls
How do I check if my 2000 International Harvester 4400 has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the 2000 International Harvester 4400 have?
3, covering electrical system, service brakes, hydraulic and power train.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2000 International Harvester 4400?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history