2001 International Harvester 4400 problems

What is wrong

On certain heavy duty trucks equipped with international dt530, cummins, or caterpillar I-6 engines, the positive battery cable between the batteries and the starter may rub against an electrical ground cable between the starter and frame rail.

Risk

This could cause an electrical short and/or fire.

Remedy

Dealers will inspect for any chafing. If there is no evidence of chafing, a saddle clamp will be installed. If there is evidence of chafing, the damaged cables will be replaced and the saddle clamp installed. The recall began on august 16, 2004. Owners should contact international at 1‑800‑448‑7825.

Recall number 04V306000 · Recall details

What is wrong

Certain heavy duty trucks fail to comply with the requirements of federal motor vehicle safety standard no. 121, "air brake systems." the primary and secondary air supply hoses from the foot valve to the primary and secondary air tanks were improperly routed at the tank.

Risk

If the primary air circuit is damaged, the brakes will not apply when the brake pedal is depressed increasing the risk of a crash.

Remedy

Dealers will inspect and repair vehicles. Owner notification will be completed by october 3, 2003. Owners who take their vehicle to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1‑800‑448‑7825.

Recall number 03V317000 · Recall details

What is wrong

Certain heavy duty trucks fail to comply with the requirements of federal motor vehicle safety standard no. 104, "windshield wiping and washing systems." due to the design of the windshield washer pump motor circuit, the system's ability to function is impaired when it is full of frozen water and the pump motor shaft is locked or frozen (cannot rotate).

Risk

Any resultant reduced visibility could cause a crash.

Remedy

Dealers will install a new 10 amp fuse in place of the 5 amp fuse and a new 10 amp label will be placed over the original 5 amp designation on the fuse panel label. Owner notification began on june 27, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1‑800‑448‑7825.

Recall number 03V161000 · Recall details

What is wrong

On certain school and transit buses built with bosch zero offset pin slide (zops) hydraulic disc brakes, the zops hydraulic disc brakes may experience calipers sticking in the applied position, which can result in excessive or abnormal heat generation at one or more of the brakes.

Risk

The combination of the following factors may collectively result in an unreasonable risk to motor vehicle safety: potential fire at a wheel end, high incident rates of stuck calipers, and evacuation and containment concerns relating to multiple passengers.

Remedy

International will notify its customers and repair the buses free of charge. The recall began october 29, 2004.

Recall number 03V062000 · Recall details

What is wrong

On certain heavy duty trucks equipped with manual transmissions, lower clutch rods with turnbuckles are failing from fatigue near the turnbuckle due to bending forces experienced during each clutch pedal cycle.

Risk

The clutch rod can break without warning and make it difficult to shift and if the clutch rod breaks while the vehicle is stopped or decelerating, the vehicle could lunge unexpectedly in the direction of the selected gear, increasing the risk of a crash.

Remedy

Dealers will replace the clutch rod assembly with a solid rod design that does not have a turnbuckle. Owner notification began july 19, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1‑800‑448‑7825.

Recall number 02V174000 · Recall details

What is wrong

Vehicle description: heavy duty trucks. These vehicles could experience a loss of the low beam headlights, the high beam headlights, or both. A software problem within the electrical system controller (ESC) can cause the circuit for the low beam or the circuit for the high beam headlights to fuse or open, resulting in loss of either the low or high beam headlights or possibly even both.

Risk

A headlight fusing condition could occur without warning to the driver and potentially leave the driver in a blackout situation while operating the vehicle in the dark.

Remedy

Dealers will reprogram the ESC. Owner notification is expected to begin october 12, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1‑800‑448‑7825.

Recall number 01V315000 · Recall details

What is wrong

Vehicle description: heavy duty trucks. There is an electrical problem with a remote power module. These vehicles were built with the ability to add six remote switches per module, which are mounted outside the cab and are used to turn on and off circuits that perform custom electrical functions. If two or more remote switches are actuated on within 100ms of one another, all six of the outputs on the remote power module will turn on. If two or more remote switches are actuated off with 100ms of one another, all six of the outputs on the remote power module with turn off.

Risk

Unintentional activation of remote body accessories could cause a crash resulting in property damage, personal injury, or death.

Remedy

Dealers will replace all the remote power modules. Owner notification began july 27, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1‑800‑448‑7825.

Recall number 01V212000 · Recall details

This investigation focused on international medium duty trucksand school bus chassis weighing up to 33,000 pounds, equipped with hydraulic brakes and built with the bosch zero offset pin slide (zops)brake system calipers.international used the zops calipers from april 1997 through june 2002.odi was concerned about reports of the brake calipers sticking in the applied position, resulting in excessive heat.as the investigation progressed, odi became aware of wheel end fires, some of which occurred on school buses.during the investigation odi obtained warranty data which was sorted and analyzed by vrtc test engineers and odi to gain an understanding of the magnitude of the problem.after a thorough warranty data analysis, related testing and document reviews, odi met with international, shared the data analysis and shortly afterwards, international agreed to a safety recall.further details are included on pages 2 - 4.

EA02034