Check a VIN

1995 International Harvester 4700 recalls

There are 5 safety recalls on record for the 1995 International Harvester 4700, covering 9,351 vehicles in total across all the models in each campaign. Newest first.

All recalls

SeatsReported March 6, 2003 · 2,418 vehicles affected
What is wrong
On certain heavy duty trucks equipped with bostrom driver seat models 910, 910sc, or 914 and international's parking brake code 04036, if someone outside the cab adjusts/slides the driver's seat to its most forward position, with the parking brake set, the seat will contact and release the parking brake lever.
Risk
If the parking brake is accidentally released, the vehicle could move unexpectedly, increasing the risk of a crash.
Remedy
Dealers will install a stop-bracket on the seat track to limit the travel of the seat so that the seat cannot release the parking brake lever. Owner notification began on march 31, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1‑800‑448‑7825.

Recall number 03V083000 · Recall details

Service brakes, air: slack adjustersReported December 6, 2000 · 40 vehicles affected
What is wrong
Vehicle description: heavy duty trucks. The vehicles involved in this recall were built for export with manual slack adjusters and were sold in the us. These vehicles need to have automatic slack adjusters in order to comply with the requirements of fmvss 121, "air brake systems."
Risk
These vehicles do not comply with the standards.
Remedy
Dealers will replace the manual slack adjusters will automatic slack adjusters.

Recall number 00V413000 · Recall details

Parking brake: driveline: hydraulic: hoses, lines/piping, and fittingsReported November 22, 1994 · 71 vehicles affected
What is wrong
At low ambient temperature, with the parking brake applied abd the engine running, pressure can build up sufficiently to partially pressurize the brake chamber which controls the ddm park brake at the rear of the transmission allowing the parking brake to partially release.
Risk
If the vehicle is parked on a moderate incline, the vehicle can roll away without warning and possibly result in an accident.
Remedy
Dealers will re-plumb the hydraulic lines of the hydraulic park brake system preventing unintentional release of the park brake.

Recall number 94V232000 · Recall details

Vehicle speed control: accelerator pedalReported October 7, 1994 · 6,449 vehicles affected
What is wrong
The base of the electronic accelerator pedal is made of die cast aluminum. The base mounts directly to the cab firewall. The cab firewall is not rigid enough or flat enough at the mounting surface, causing stress on the accelerator base that will cause the mounting pads on the base of the pedal assembly to fail and totally separate from the firewall.
Risk
This can cause loss of speed control, driver distraction, and result in an accident.
Remedy
Dealers will inspect the accelerator pedal assembly and install a plate between the accelerator mounting base and the firewall on those units where the base is not broken and has no visible signs of a crack. If the base is broken or cracked, the accelerator assembly will be replaced with a new redesigned accelerator pedal assembly.

Recall number 94V196000 · Recall details

Engine and engine cooling: engine: gasoline: turbo/superchargerReported August 2, 1994 · 373 vehicles affected
What is wrong
Four compression backplate retaining fasteners on the turbo-charger were torqued only hand tight. This allows the fasteners to loosen, and causes oil to leak into the compressor air side of the turbo-charger which, when coupled with the heat precipitated by the compressor and the mixing action of the compressor wheel, can result in an air/oil mixture that fuels the engine.
Risk
When this occurs, engine run-on and subsequent loss of operator control via the normal throttle mechanism can occur, which could result in a vehicle accident.
Remedy
Replace the suspect turbo-charger with a new turbo-charger.

Recall number 94V144000 · Recall details

Questions about the 1995 International Harvester 4700 recalls

How do I check if my 1995 International Harvester 4700 has an open recall?

Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.

Do I have to pay for a recall repair?

No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.

How many recalls does the 1995 International Harvester 4700 have?

5, covering seats, service brakes, air and parking brake.

VIN decoder

See the problems and recalls for an exact car

Buying a used 1995 International Harvester 4700?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history