1995 International Harvester 8100 Problems: 0 Complaints, 3 Recalls

The worst 1995 International Harvester 8100 problems

Ranked by number of owner complaints. Mileage and cost come from what owners wrote.

Tap a problem to see which part fails, at what mileage and in which other years.

Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittingsReported August 2, 1995 · 278 vehicles affected

What is wrong: These vehicles were built with an improperly plumbed brake system which affects the braking on the rear axle when running either bobtail or pulling a trailer.
Risk: This condition can affect the stopping ability of the vehicle because the front steer axle brakes and trailer's brakes would be doing most of the braking. Increased stopping distances would be required causing accelerated wear on the steer axle and the trailer brakes.
Remedy: Navistar dealers will inspect vehicles and repair by installing brake lines and fittings as required.

Recall number 95V144000 · Recall details

Vehicle speed control: accelerator pedalReported October 7, 1994 · 6,449 vehicles affected

What is wrong: The base of the electronic accelerator pedal is made of die cast aluminum. The base mounts directly to the cab firewall. The cab firewall is not rigid enough or flat enough at the mounting surface, causing stress on the accelerator base that will cause the mounting pads on the base of the pedal assembly to fail and totally separate from the firewall.
Risk: This can cause loss of speed control, driver distraction, and result in an accident.
Remedy: Dealers will inspect the accelerator pedal assembly and install a plate between the accelerator mounting base and the firewall on those units where the base is not broken and has no visible signs of a crack. If the base is broken or cracked, the accelerator assembly will be replaced with a new redesigned accelerator pedal assembly.

Recall number 94V196000 · Recall details

Engine and engine cooling: engine: gasoline: turbo/superchargerReported August 2, 1994 · 373 vehicles affected

What is wrong: Four compression backplate retaining fasteners on the turbo-charger were torqued only hand tight. This allows the fasteners to loosen, and causes oil to leak into the compressor air side of the turbo-charger which, when coupled with the heat precipitated by the compressor and the mixing action of the compressor wheel, can result in an air/oil mixture that fuels the engine.
Risk: When this occurs, engine run-on and subsequent loss of operator control via the normal throttle mechanism can occur, which could result in a vehicle accident.
Remedy: Replace the suspect turbo-charger with a new turbo-charger.

Recall number 94V144000 · Recall details

Is the 1995 International Harvester 8100 reliable?

Owners have filed 0 complaints about the 1995 International Harvester 8100.

What is the most common problem with the 1995 International Harvester 8100?

There are not enough complaints to tell.

How many recalls does the 1995 International Harvester 8100 have?

3 recalls, covering service brakes, hydraulic, vehicle speed control and engine and engine cooling.

See the problems and recalls for an exact car

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.