1997 International Harvester 8100 recalls
There are 3 safety recalls on record for the 1997 International Harvester 8100, covering 4,221 vehicles in total across all the models in each campaign. Newest first.
All recalls
Service brakes, air: slack adjusters
- What is wrong
- Vehicle description: heavy duty trucks equipped with air brake haldex automatic slack adjusters, long stroke brake chambers, and dana brakes. The automatic slack adjuster anchor brackets can fail due to fatigue fracture and completely separate, causing the slack adjusters to function as manual slack adjusters.
- Risk
- If the support bracket for an automatic slack adjuster fails, the brakes at that wheel end will not automatically adjust. As the brake linings wear, the vehicle will have reduced braking capacity, increasing the risk of a crash.
- Remedy
- Dealers will install a new bracket on each suspect slack adjuster. Owner notification began february 22, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1‑800‑448‑7825.
Recall number 01V023000 · Recall details
Suspension: rear
- What is wrong
- Vehicle description: school buses and heavy duty trucks equipped with rear axle assemblies produced by dana spicer. Certain rear axle assemblies were improperly heat treated which could allow pinion breakage at the pinion threads.
- Risk
- Cracks can initiate and result in separation of the threaded end of the pinion resulting in separation of the yoke and drive line from the rear axle increasing the risk of a vehicle accident.
- Remedy
- Dealers will replace the rear axle carrier/pinion assembly.
Recall number 96V240000 · Recall details
Suspension: rear
- What is wrong
- The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. Each spindle contains a keyway slot in which the locking tab for the wheel bearing nut locking mechanism is inserted. The length of the keyway slot may not be long enough to accommodate the tab causing the tab to be deformed or damaged during installation.
- Risk
- This locking tab prevents the wheel bearing nut from loosening during vehicle operation. If this tab is deformed, the nut can loosen allowing the wheel to separate from the axle increasing the risk of a vehicle accident.
- Remedy
- Dealers will replace the drive axle housing nuts with a conventional wheel nut hardware system.
Recall number 96V233002 · Recall details
Questions about the 1997 International Harvester 8100 recalls
How do I check if my 1997 International Harvester 8100 has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the 1997 International Harvester 8100 have?
3, covering service brakes, air and suspension.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1997 International Harvester 8100?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history