2013 International 9900 technical service bulletins
144 technical service bulletins and manufacturer communications cover the 2013 International 9900.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- This article provides guidance to dealership personnel, Technical Services personnel, Dealer Service...
- There are two ways to program 5000 and 9000 odometer
- New CARB Idle Reduction Change Request
- This tool is designed to compare Diamond Logic feature data across multiple vehicle configuration files
- This document provides guidance for assessing the feasibility of implementing a customer-requested change...
- Engine replacements for all International engines will need to follow this procedure.
- This document will guide the user through a step-by-step procedure for detecting water leaks in vehicle...
- This document will guide the user through understanding Prop Shaft Codes and understanding the variations...
- In some geographic areas, ambient temperatures reaching below 15°F (-10 °C), including high levels of...
- Title: Service Portal iKNow Feedback Case Types Applies To: All
- Title: Driveline Information Center and Troubleshooting Procedures Applies To: All Vehicles
- Title: A/C Refrigerant and Oil Capacities Applies To: All current models
- Title: Fan belt replacement guidelines for frayed edges Applies To: All Models
- Title: Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition...
- Title: Steering Gear Seal Repair Guidelines Applies To: Steering gears
- Title: How to Request a Horsepower Quote Applies To: All International and Cummins Electronic engines
- This document reminds technicians of the critical relationship between the truck's suspension and the...
- Applies To: All Navistar Powered Trucks Requesting Engine Emission Label Replacement, Certificate of...
- This article addresses chassis lean conditions on all chassis
- Suggested alignment target values when performing a vehicle axle alignment.
- Starter Diagnostics and warranty claim procedure; all engines EXCLUDING Cummins ISB engine with Allison...
- J1939 Data Link Source Address Information
- Diagnosis of chassis wander complaints.
- General Wheel Speed Sensor Troubleshooting
- How to request a horsepower quote; all International and Cummins engines
- J1939 Data Link Troubleshooting
- Starter diagnostics and warranty claim procedure for all engines and all chassis EXCLUDING vehicles...
- J1939 Data link source address information
- Pico Scope CCOS (Crankcase Separator Test)
- PicoScope Test 5V & 12V Intermittent Open and Short circuit diagnostics
- PicoScope Test
- PicoScope Test for Datalink (CAN) Health Shorts & opens
- PicoScope Test Resistance and Ohmmeter
- PicoScope Test One Channel RCT
- Power Steering Diagnostics Flow / Pressure Specifications For Power Steering Gears and Power Steering Pumps
- How to obtain As built parameter list
- Engine Oil Capacities
- Oil leaks at the Bottom of the Oil Filter Module; Only International A26, N13, or 2010 and newer 11 and 13...
- General wheel speed sensor troubleshooting
- Aftertreatment Clamp Corrosion; Single Can Aftertreatment Systems
- Frame Rail Straightness Inspection Procedure
- Suggested alignment target values when performing a vehicle axle alignment
- Fuel Filters, Winter Additives, and Blending Fuels for Cummins® Engines
- Cab Lean Concern
- Driveline Information Center and Troubleshooting Procedures
- Repair Procedures for Vehicles Struck by Lightning
- Ambient Air Temperature (AAT) Sensor Faults/Location/Diagnostics
- MaxxForce 15L Engine Oil Leaks; an aid in repairing engine oil leaks on the MaxxForce 15L engine.
- A/C Refrigerant and Oil Capacities
- Cleaning and Disinfecting Trucks and Buses
- Bendix EC80 Blank Module Replacement Program;
- Key Codes and Key Cutting Information (Not for CV Series)
- NEW Ultrasonic DEF Head Unit; All SCR vehicles
- Oil Capacities; All Electronic International Engines 1994
- Suspension Lean Diagnostics; All models
- NEW Ultrasonic DEF Head Unit available; Only models equipped with SCR Aftertreatment.
- NEW Ultrasonic DEF Head Unit; only models equipped with SCR Aftertreatment
- Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition Procedure
- NEW Ultrasonic DEF Head Unit
- ISB Starting System Diagnostics; Only models built with cummins ISB engines
- Build to VIN Wiring Harnesses
- FLR-10
- Tool Instruction
- Engine Oil Capacities All Electronic International Engines 1994
- Radio Diagnostics and Information
- Build to VIN Wiring Harnesses; Axle Configuration: 6x4
- Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition Procedure;...
- Updating OnCommand Link with Accelerator
- ISX, N13, and N9 / N10 Aftertreatment Private Data Link Troubleshooting
- Winter Front Usage
- Engine Oil Capacities
- OnCommand EZ-Tech
- Using Supplier Software to Check DTCs
- Trailer Auxiliary Switch Lamp Burning Out; Only Vehicles Equipped with Feature Code 0008TTH or 0008THG
- NEW Ultrasonic DEF Tank Sending Unit; only models with SCR Aftertreatment system.
- Urea Quality Sensor (UQS) Supplemental Diagnostic and Service Information; only models with SCR...
- HVAC fault 2609-19 with 4th Gen BCM; Only models equipped with 4th generation BCM
- Dealer EZ-Tech and Diagnostic Software Support Resource Center
- CPA Injector Misfire Detection; Only models with 2004 thru 2017 International engines.
- OnCommand EZTech
- SCR Vehicles Setting 3363-16 (FC1713) due to Crossed DEF Tank Coolant Lines or Inverted DEFTHV
- Cylinder Performance Analyzer (CPA) Resource Center; Only models with 2004 thru 2017 International engines.
- OnCommand EZ-Tech Download Center
- Steering Shake, Shimmy, Shudder, or Steering Vibration; only with 14k front weight rated axles and below
- Steering Fluids
- Cooling System Flush Procedure
- Radiator internal restriction and flush procedure
- Davco fuel pro 382 technical manual, installation, diagnostics, and service
- Change in Seat Belt Manufacturer
- Standard to Heavy Duty Brake Chamber Replacement
- Models with APADS; Air Conditioning APADS codes
- ESPAR AirTronic Low Run Time.
- DPF Snap Accel Test
- Fuel Filters, Winter Additives, and Blending Fuels for Cummins ISX Engines
- Trailer ABS In-Dash Lamp Stays On After A Trailer Has Been Disconnected; only with An In-Dash Trailer ABS...
- Cluster Software Update Instructions
- MaxxForce 15 ECM recalibration to improve exhaust aftertreatment, Exhaust Gas Recirculation (EGR) valve,...
- Shifter may disengage
- Geotab with wye cable installation
- High or spiking voltage only with leece-neville alternator using remote voltage sense
- Wind noise
- Cluster Issues
- International: there are issues of missing complete engine air supply line and also missing t fitting with...
- Aftertreatment Purge Air Valve Air Supply Line Routing for both Cummins ISX SCR and N13 SCR Engines
- Cummins ISX 15L with Multiple ECM Faults; SCR engines only
- New Synthetic Oil for Eaton and Spicer Transmissions; only with Eaton or Spicer transmissions
- Transmission Keeps Shifting and Display Keeps Flashing After Ignition is Turned Off; only with Freedom...
- The S-Cam tube bracket assemblies on steer axles may exhibit fractures between the wing bracket and the...
- ZF Sachs Twin XTend clutch; only Vehicles with heavy-duty ZF Sachs Twin XTend Clutch
- 9900i Dash Guages inop
- Fan Troubleshooting; Only with Cummins engine
- Water In Fuel (WIF) Message Blinking in Dash Message Center at Key On; only models with International Engines
- Disable Cummins Icon; Only models equipped with Cummins engine and with Icon installed.
- Ethylene Glycol Coolant Color Change to be Phased-In Approximately April 1, 2004
- Phosphate Conditioner Required When Replacing Radiators; only models with EPA 2009.5, 2009.75 and 2010...
- MIL Light on with fault code 286 in Cummins ECM; only models with with Cummins ISX 15L with SCR
- Aftertreatment Purge Air Valve Air Supply Line Routing; only models with ISX Cummins SCR, N13 SCR engines
- Poor hood fit
- International (navistar): the adhesive patch, used on one piece sunshade, fails, and the sunshade mounting...
- Ordering Parts for Selective Catalyst Reduction (SCR) Exhaust Systems; Only 2013 models and forward with SCR
- Poor hood fit; Only models built with Cummins ISX engines on 6/11/2013 through 7/21/2013.
- Navistar: due to back panel not being drilled prior to assembly, on some trucks, the grab handle was not...
- Ordering Parts for Selective Catalyst Reduction (SCR) Exhaust Systems; only models Equipped with SCR...
- Of a new chassis with a frame bow; only chassis equipped with "dogbone" style crossmembers
- Electrical Chassis Harnesses
- Front ABS Harness
- Voltage gauge and or all cluster gauges freeze
- The Doser tube coolant return hose assemblies and coolant hoses have been found to leak.
- Engine Gear Train Inspection; only models equipped with MaxxForce 15 engines
- Aftertreatment Resource Center; All models equipped with EPA 2007 and newer engines
VIN decoder
See the problems and recalls for an exact car
Buying a used 2013 International 9900?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history