2018 International MV technical service bulletins
182 technical service bulletins and manufacturer communications cover the 2018 International MV.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- This article provides service part information for replacing a cracked gauge cluster lens
- This article provides guidance to dealership personnel, Technical Services personnel, Dealer Service...
- This article only applies to Models w/ 0016UZL Built Between 06/23/2014 – 05/11/2020 OR Models w/ 0016UZL...
- This document will guide the user through the changes of the dielectric grease/coatings used in certain...
- This article addresses chassis lean conditions on MV with IROS suspension
- This document is to inform dealers, customers, and body builders/TEMs of a known BCM software issue with...
- New CARB Idle Reduction Change Request
- This tool is designed to compare Diamond Logic feature data across multiple vehicle configuration files
- This document provides guidance for assessing the feasibility of implementing a customer-requested change...
- Engine replacements for all International engines will need to follow this procedure.
- This document will guide the user through a step-by-step procedure for detecting water leaks in vehicle...
- This document provides: Steps to take when switch pack programming fails, or when switch pack disappears...
- In some geographic areas, ambient temperatures reaching below 40°F (4°C), including high levels of...
- This document will guide the user through understanding Prop Shaft Codes and understanding the variations...
- In some instances, the driver's or passenger's door pod may become unresponsive, where it will not respond...
- In some geographic areas, ambient temperatures reaching below 15°F (-10 °C), including high levels of...
- This document is to notify the field of an issue with BCM that causes various electrical system concerns...
- Title: Service Portal iKNow Feedback Case Types Applies To: All
- Title: Driveline Information Center and Troubleshooting Procedures Applies To: All Vehicles
- Models involved
- Title: A/C Refrigerant and Oil Capacities Applies To: All current models
- Title: Fan belt replacement guidelines for frayed edges Applies To: All Models
- Title: Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition...
- Title: Erratic BCM and RPM Behavior with Kernel 747-752 Applies To: All MV, HV, HX with RPM modules
- Title: Steering Gear Seal Repair Guidelines Applies To: Steering gears
- Title: How to Request a Horsepower Quote Applies To: All International and Cummins Electronic engines
- This document reminds technicians of the critical relationship between the truck's suspension and the...
- Switch Pack Programming Troubleshooting Information
- Applies To: All Navistar Powered Trucks Requesting Engine Emission Label Replacement, Certificate of...
- Title: Battery Disconnect Switch Replacement
- This article addresses chassis lean conditions on all chassis
- This document will guide a user to replace and reroute Charge Air Cooler (CAC) for vehicles built with the...
- This document will provide the user with cleaning options and procedures for aluminum bright work parts...
- This document is to guide users to eliminate brake pedal rattle noise.
- This document covers battery diagnostics, maintenance and storage requirement.
- This document details the procedure that must be followed to ensure proper alternator troubleshooting.
- Starter Diagnostics and warranty claim procedure; all engines EXCLUDING Cummins ISB engine with Allison...
- Cummins ISB Starting system diagnostics.
- J1939 Data Link Source Address Information
- Tire Pressure Monitoring system; Feature Codes 16VLS, 16VUY, 16VVA, 16VVM, or 16VUZ
- Diagnosis of chassis wander complaints.
- General Wheel Speed Sensor Troubleshooting
- Cummins B6.7 Grid Heater Relay
- How to request a horsepower quote; all International and Cummins engines
- Starter kicks out after 1 second on MV and HV with Cummins L9 Engines
- J1939 Data Link Troubleshooting
- QLS Emergency Calibration Revert Process
- Cummins B6.7 and L9 engines with codes 285 and 286
- Tire Pressure Monitoring systems (TPMS); Only LT, RH, HV, HX, or MV series trucks with feature code 16VLS,...
- Cummins Programming guide and fault codes285 & 265; only vehicles built with Cummins B6.7, X15, or L9 engines
- Telematics installation guidelines
- Starter diagnostics and warranty claim procedure for all engines and all chassis EXCLUDING vehicles...
- QLS Emergency ECM Calibration; only models equipped with Cummins B6.7, X15, L9, or International A26 engines
- QLS Emergency Calibration
- J1939 Data link source address information
- Pico Scope CCOS (Crankcase Separator Test)
- PicoScope Test 5V & 12V Intermittent Open and Short circuit diagnostics
- PicoScope Test
- PicoScope Test for Datalink (CAN) Health Shorts & opens
- PicoScope Test Resistance and Ohmmeter
- PicoScope Wheel Speed Sensor Test
- PicoScope Test One Channel RCT
- Front cab mount bushings/insulators MV, HV, DuraStar, and WorkStar vehicles used in severe vocations
- Cab water leak trouble shooting tips
- 16VLS, 16VUY, 16VVA, and 16VUZ Tire Pressure Monitoring System (TPMS).
- Cab water leak troubleshooting tips; HX with steel cab only
- Water leaks past plastic vapor barrier sheet in the inner cavity of the cab entry door
- QLS Emergency Calibration; Models equipped with 2016 and newer Cummins B6.7, X15 and L9 engines or...
- Power Steering Diagnostics Flow / Pressure Specifications For Power Steering Gears and Power Steering Pumps
- Bendix Stability control
- QLS Emergency Calibration; Models with 2016 Cummins ISX, A26 and EPA 2017 and newer Cummins X15, L9, or...
- How to obtain As built parameter list
- New or replacement body control Module (BC,BCM) not detected; Gen 4 BCM
- QLS Emergency Calibration
- Engine Oil Capacities
- Cab water leak troubleshooting tips
- General wheel speed sensor troubleshooting
- Lane Departure Warning Alert Active with Turn Signals On; Only models equipped with Lane Departure Warning
- Aftertreatment Clamp Corrosion; Single Can Aftertreatment Systems
- Day cab roof air deflector causing loud vibration noise at highway speed
- Frame Rail Straightness Inspection Procedure
- Programming Procedure for Center Panel Switch Packs
- Fuel Filters, Winter Additives, and Blending Fuels for Cummins® Engines
- Cab Lean Concern
- Dielectric Grease Change
- Driveline Information Center and Troubleshooting Procedures
- Repair Procedures for Vehicles Struck by Lightning
- Ambient Air Temperature (AAT) Sensor Faults/Location/Diagnostics
- Programming procedures for the center panel switch packs has changed.
- A/C Refrigerant and Oil Capacities
- Radio Diagnostics and Information
- Horizon Cab Door Field Replacement and the Side Window Air Deflectors
- Chrome Plated C-Loop Mirror Flat Glass Cracks
- Cleaning and Disinfecting Trucks and Buses
- Multi Module Programming Information for In-Cab Modules
- Reduced ISB Engine Exhaust Brake Efficiency; Only vehicles with Allison 1000/2000 series transmissions
- Winter Fuel Or Additive Use Required Pop-Up Message
- Auxiliary Engine Speed Control Cannot Hold Engine Speed When Using Steering Wheel Switches
- Day Cab Roof Air Deflector Vibrates against Cab Roof; only models with P/N 4067947C92 Roof Air Deflector
- Windshield Replacement on trucks equipped with Lane Departure Cameras; Only RH, LT, and Medium duty with...
- Incorrect Turn Signal Cancellation Feature
- Isb 6.7
- Wind noise at upper side of cab door due to door out of alignment
- Water Leaks Past Plastic Vapor Barrier Sheet in the Inner Cavity of the Cab Entry Door
- NEW Ultrasonic DEF Head Unit; All SCR vehicles
- Identifying the Source of Oil Seen at the Lower Flywheel Housing Area
- Cab Door Latch Stuck, Door will not open
- Cummins ISB Fan Drive Belt Chirp; Cummins ISB and Cummins B6.7
- Oil Capacities; All Electronic International Engines 1994
- Lt rh HV mv
- Air Powered (SAAR) Park Brake Troubleshooting (Service "P" Light Coming on)
- Suspension Lean Diagnostics; All models
- SCR Vehicles Setting DEF Quality Faults due to Crossed DEF Tank Coolant Lines or Inverted DEFTHV
- This document will guide the user through repair direction to configure Transmission Control Module (TCM)...
- Suggested alignment target values when performing a vehicle axle alignment
- NEW Ultrasonic DEF Head Unit available; Only models equipped with SCR Aftertreatment.
- Voltage gauge drops on cold engine start-up; Only models built with Cummins ISB, B6.7, ISL, or L9 engines
- International; HV, HX, LT, MV, RH, LS, ProStar, TranStar, WorkStar; It is possible for an internal clutch...
- NEW Ultrasonic DEF Head Unit; Only vehicles Equipped with SCR
- The First Check to make when Troubleshooting any Body Controller or ESC Issue
- Cab Water Leak Troubleshooting Tips; Excluding 9000i, PayStar(HX), CityStar, or LoadStar
- NEW Ultrasonic DEF Head Unit; only models equipped with SCR Aftertreatment
- Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition Procedure
- Power Take Off (PTO) Programming on Models with the Eaton Procision Transmission; Only with feature codes...
- Power Take Off (PTO) Programming on Models with the Eaton Procision Transmission; Only with feature code...
- Wire Terminal Information
- ECA Clutch Departure
- Heavy Duty Clutch May Not Acheive Full Departure
- Brake pedal not returning and sticking slightly in the applied position
- NEW Ultrasonic DEF Head Unit
- ISB Starting System Diagnostics; Only models built with cummins ISB engines
- Certain MV Series and DuraStar models may have been built with an incorrect spacer for the left-side front...
- Heated Mirror Timer Programmable Parameter; only models with feature code 0597006 and built prior to...
- Eaton Bulletin for their ECA Clutch issue referenced from IK1100033 and IK1100034
- Eaton eca
- Eaton eca
- Body Builder Accessories Backfeeding Ignition Voltage
- Cummins ECM Programming Procedure; Only models with EPA 2017 Cummins engines
- Vehicle Speed ( VSS ) Output for Bodybuilders
- Cummins X15, B6.7, L9 engine ECM Programming Procedure; only models built prior to June 4, 2018
- Air Pressure Gauges and A/C Pressure Transducer Troubleshooting
- FLR-10
- Body Controller Updates for 500k Baud data link
- Tool Instruction
- City Horn Difficult to Active
- Body Controller Updates for 500k Baud Data link
- Wabco OnGuard Software Update; Only 500k baud rate Units with Wabco OnGuard with Cummins Engines built...
- Trucks equipped with a sound package that has Bluetooth capability may have been built without front speakers.
- Engine Oil Capacities All Electronic International Engines 1994
- Telematics Installation Guidelines; only Units with 500K Data Link
- Identifying customer HVAC performance concerns / Evaporator Freeze up
- Hood Gap and Alignment Tolerances
- Cummins L9 EPA 17 Supplemental Fuel System Diagnostics
- Cummins ECM Programming Procedure; only models equipped with Cummins engines
- Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition Procedure;...
- Starter power connection cleaning
- Cummins ECM Programming Procedure; Only units equipped with Cummins engines
- An internal component within the clutch assembly may fail, which in special circumstances could inhibit...
- Urea Quality Sensor (UQS) Boot Order
VIN decoder
See the problems and recalls for an exact car
Buying a used 2018 International MV?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history