2013 International Paystar technical service bulletins
188 technical service bulletins and manufacturer communications cover the 2013 International Paystar.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- This article provides guidance to dealership personnel, Technical Services personnel, Dealer Service...
- There are two ways to program 5000 and 9000 odometer
- New CARB Idle Reduction Change Request
- This tool is designed to compare Diamond Logic feature data across multiple vehicle configuration files
- This document provides guidance for assessing the feasibility of implementing a customer-requested change...
- Engine replacements for all International engines will need to follow this procedure.
- This document will guide the user through a step-by-step procedure for detecting water leaks in vehicle...
- This document will guide the user through understanding Prop Shaft Codes and understanding the variations...
- In some geographic areas, ambient temperatures reaching below 15°F (-10 °C), including high levels of...
- Title: Service Portal iKNow Feedback Case Types Applies To: All
- Title: Driveline Information Center and Troubleshooting Procedures Applies To: All Vehicles
- Title: A/C Refrigerant and Oil Capacities Applies To: All current models
- Title: Fan belt replacement guidelines for frayed edges Applies To: All Models
- Title: Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition...
- Title: Steering Gear Seal Repair Guidelines Applies To: Steering gears
- Title: How to Request a Horsepower Quote Applies To: All International and Cummins Electronic engines
- This document reminds technicians of the critical relationship between the truck's suspension and the...
- Applies To: All Navistar Powered Trucks Requesting Engine Emission Label Replacement, Certificate of...
- This article addresses chassis lean conditions on all chassis
- Suggested alignment target values when performing a vehicle axle alignment.
- Starter Diagnostics and warranty claim procedure; all engines EXCLUDING Cummins ISB engine with Allison...
- J1939 Data Link Source Address Information
- Rebuilding Cylinder Heads on Certain MaxxForce 11/13, N13, and A26 engines; 2010 to present.
- Diagnosis of chassis wander complaints.
- General Wheel Speed Sensor Troubleshooting
- How to request a horsepower quote; all International and Cummins engines
- J1939 Data Link Troubleshooting
- New air compressor incorporates an oil feed dowel O-ring
- Starter diagnostics and warranty claim procedure for all engines and all chassis EXCLUDING vehicles...
- J1939 Data link source address information
- Pico Scope CCOS (Crankcase Separator Test)
- PicoScope Test 5V & 12V Intermittent Open and Short circuit diagnostics
- PicoScope Test
- PicoScope Test for Datalink (CAN) Health Shorts & opens
- PicoScope Test Resistance and Ohmmeter
- PicoScope Wheel Speed Sensor Test
- PicoScope Test One Channel RCT
- Power Steering Diagnostics Flow / Pressure Specifications For Power Steering Gears and Power Steering Pumps
- How to obtain As built parameter list
- Engine Oil Capacities
- Oil leaks at the Bottom of the Oil Filter Module; Only International A26, N13, or 2010 and newer 11 and 13...
- This VER will involve reviewing diagnostic codes, inspection of the EGR valve / EGR System, and may...
- Snap-On torque wrench requirement for all big bore engine connecting rod bolt(s).
- General wheel speed sensor troubleshooting
- Aftertreatment Clamp Corrosion; Single Can Aftertreatment Systems
- Suggested alignment target values when performing a vehicle axle alignment
- Fuel Filters, Winter Additives, and Blending Fuels for Cummins® Engines
- Driveline Information Center and Troubleshooting Procedures
- Repair Procedures for Vehicles Struck by Lightning
- Ambient Air Temperature (AAT) Sensor Faults/Location/Diagnostics
- MaxxForce 15L Engine Oil Leaks; an aid in repairing engine oil leaks on the MaxxForce 15L engine.
- A/C Refrigerant and Oil Capacities
- Cleaning and Disinfecting Trucks and Buses
- Stand Alone Real Time (SART) Module Diagnostics
- NEW Ultrasonic DEF Head Unit; All SCR vehicles
- Oil Capacities; All Electronic International Engines 1994
- Suspension Lean Diagnostics; All models
- NEW Ultrasonic DEF Head Unit available; Only models equipped with SCR Aftertreatment.
- NEW Ultrasonic DEF Head Unit; Only vehicles Equipped with SCR
- NEW Ultrasonic DEF Head Unit; only models equipped with SCR Aftertreatment
- Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition Procedure
- NEW Ultrasonic DEF Head Unit
- ISB Starting System Diagnostics; Only models built with cummins ISB engines
- Hendrickson Assembly Instructions; Transverse Torque Rods
- Dual steering gear air bleed procedure
- Improved Bushings for Hendrickson Torque Rods
- FLR-10
- Steering Noise in Vehicles Equipped with Dual Steer
- Tool Instruction
- Engine Oil Capacities All Electronic International Engines 1994
- Radio Diagnostics and Information
- Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition Procedure;...
- Updating OnCommand Link with Accelerator
- ISX, N13, and N9 / N10 Aftertreatment Private Data Link Troubleshooting
- Winter Front Usage
- Engine Oil Capacities
- OnCommand EZ-Tech
- Using Supplier Software to Check DTCs
- Trailer Auxiliary Switch Lamp Burning Out; Only Vehicles Equipped with Feature Code 0008TTH or 0008THG
- Steering Noise in Vehicles Equipped with Dual Steer; only Severe Service Chassis with the Sheppard Dual...
- NEW Ultrasonic DEF Tank Sending Unit; only models with SCR Aftertreatment system.
- Urea Quality Sensor (UQS) Supplemental Diagnostic and Service Information; only models with SCR...
- HVAC fault 2609-19 with 4th Gen BCM; Only models equipped with 4th generation BCM
- Steering Noise in Vehicles Equipped with Dual Steer; Only models equipped with dual steering gear
- Dealer EZ-Tech and Diagnostic Software Support Resource Center
- CPA Injector Misfire Detection; Only models with 2004 thru 2017 International engines.
- OnCommand EZTech
- SCR Vehicles Setting 3363-16 (FC1713) due to Crossed DEF Tank Coolant Lines or Inverted DEFTHV
- Cylinder Performance Analyzer (CPA) Resource Center; Only models with 2004 thru 2017 International engines.
- OnCommand EZ-Tech Download Center
- Steering Shake, Shimmy, Shudder, or Steering Vibration; only with 14k front weight rated axles and below
- Steering Fluids
- Cooling System Flush Procedure
- The on board diagnostic (OBD) data stored for purposes of defining required maintenance or repair may be...
- Radiator internal restriction and flush procedure
- Performing relative compression test and misfire test with cpa tool
- Misfire diagnostics ibb; SPN132(X)
- EGR slow response diagnostics; 2659
- Davco fuel pro 382 technical manual, installation, diagnostics, and service
- Exhaust manifold service procedures
- Service parts damaged new turbocharger oil supply tube
- Retrofiting a Horton VMaster(Stratis) fan drive to Horton 2spd air operated fan drive on N13 or MaxxForce...
- ISX Setting 3556-18 (FC3167), 5298-18 (FC1691), or 3482-2 (FC1925) Caused by Missing AFI Poppet
- Change in Seat Belt Manufacturer
- Standard to Heavy Duty Brake Chamber Replacement
- Mirror Repair Procedures and Replacement Parts Availability
- Retrofiting a Horton VMaster(Stratis) fan drive to Horton 2spd air operated fan drive on MaxxForce 13 and...
- N13, MaxxForce 11, 13 engine Two Cylinder Air Compressor Testing
- Models with APADS; Air Conditioning APADS codes
- ESPAR AirTronic Low Run Time.
- DPF Snap Accel Test
- Fuel Filters, Winter Additives, and Blending Fuels for Cummins ISX Engines
- 04SPL, mcac 476
- Mirror repair procedures and replacement parts availability
- Low power no MIL diagnostics
- Cluster Software Update Instructions
- MaxxForce 15 ECM recalibration to improve exhaust aftertreatment, Exhaust Gas Recirculation (EGR) valve,...
- Shifter may disengage
- Geotab with wye cable installation
- High or spiking voltage only with leece-neville alternator using remote voltage sense
- Cluster Issues
- International: there are issues of missing complete engine air supply line and also missing t fitting with...
- Aftertreatment Purge Air Valve Air Supply Line Routing for both Cummins ISX SCR and N13 SCR Engines
- New Synthetic Oil for Eaton and Spicer Transmissions; only with Eaton or Spicer transmissions
- Circuit and Installation Diagrams For 5000; Only Models With the Allison Gen 4 HD Transmission...
- LUK/Ixetic Power Steering Pump Fittings; only Vehicles equipped with Maxxforce 11, 13 engines
- The S-Cam tube bracket assemblies on steer axles may exhibit fractures between the wing bracket and the...
- ZF Sachs Twin XTend clutch; only Vehicles with heavy-duty ZF Sachs Twin XTend Clutch
- Ordering SCR Aftertreatment Parts for Vehicles With Navistar Engines
- Ordering SCR Aftertreatment Parts for Vehicles Powered by Cummins Engines
- Navistar: some vehicles are experiencing headlight condensation or frost in the vehicles
- Water In Fuel (WIF) Message Blinking in Dash Message Center at Key On; only models with International Engines
- Exhaust Bellows Damage; only models equipped with bellows exhaust pipe.
- Ethylene Glycol Coolant Color Change to be Phased-In Approximately April 1, 2004
- Fan Blade Failures
- Phosphate Conditioner Required When Replacing Radiators; only models with EPA 2009.5, 2009.75 and 2010...
- DEF Tank Slow to Fill; only models with 2013 Cummins ISX 15L
- MIL Light on with fault code 286 in Cummins ECM; only models with with Cummins ISX 15L with SCR
- Aftertreatment Purge Air Valve Air Supply Line Routing; only models with ISX Cummins SCR, N13 SCR engines
- Bluetooth Stereo Adapter Infromation; only Bluetooth Equipped models
- Mirror Repair Procedures and Replacement Parts Availability; only models with Lang Mekra Mirrors
- International (navistar): the adhesive patch, used on one piece sunshade, fails, and the sunshade mounting...
- Ordering Parts for Selective Catalyst Reduction (SCR) Exhaust Systems; Only 2013 models and forward with SCR
- Deaeration Tank Hose Re-Route Engine Parameter Download Instructions; Only models marked with AFC12917
- SCR Fluid Filter Replacement; only models equipped with Cummins ISX or Navistar N13 Diesel Exhaust Fluid...
- Aftertreatment Fuel Injector (AFTFI) Removal and Installation; onlt models equipped with MaxxForce 13...
- Deaeration Hoses, Upper Manifold Sub-Assembly, and Coolant Control Valve (CCV) Removal and Installation;...
- Ordering Parts for Selective Catalyst Reduction (SCR) Exhaust Systems; only models Equipped with SCR...
- Deaeration Tank Hose Re-Route Engine Parameter Download Instructions
- Meritor Front Brake Return Spring Install
- Certain 2010, 2011, and 2012 model year MaxxForce® 11 engines do not meet EPA emissions requirements.
- Remote Engine Speed Control Module (RESCM) Troubleshooting; Only trucks equipped with RESCM
- Of a new chassis with a frame bow; only chassis equipped with "dogbone" style crossmembers
- Updated Emission Control Information and CARB Clean Idle Label; Only models with MaxxForce 11, 13, 15 engines.
- DEF Tank Slow to Fill; Only models built with Cummins ISX 15L engine.
- Navistar: emissions recall on certain trucks that do not meet emissions requirements and need installed an...
- Clutch Service Information; only models with Hydraulic Clutch Systems
- International: due to gauge needle swinging and ultrashift transmission is ordered, the gauges or cluster...
- Voltage gauge and or all cluster gauges freeze
- The Doser tube coolant return hose assemblies and coolant hoses have been found to leak.
- First Check to make when Troubleshooting any Body Controller or ESC Issue
- Turn Signal Troubleshooting
- Brake Lights Staying On
- ECM Recalibration to provide engine protection against an increase in engine RPM while vehicle is idling...
- Air Pressure Gauges and A/C Pressure Transducer Troubleshooting on Post-2007 HPV and ProStar
- Headlight Operation and Troubleshooting; only Post 2007 Vehicles Built with a Body Controller
- Exhaust Gas Recirculation (EGR) Valve Replacement; Only models equipped with MaxxForce 11 or 13 engines
- Aftertreatment Resource Center; All models equipped with EPA 2007 and newer engines
- Navistar: the titanx charge air cooler (CAC) hose may fail prematurely during vehicle operation on certain...
- Navistar: HVAC front inside module drain repair and grease application for exhaust gas recirculation (EGR)...
- Navistar: maxxforce 11, 13, and 15 recalibration to adress frequent warning lights
VIN decoder
See the problems and recalls for an exact car
Buying a used 2013 International Paystar?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history