2018 International Prostar technical service bulletins
217 technical service bulletins and manufacturer communications cover the 2018 International Prostar.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- This article provides guidance to dealership personnel, Technical Services personnel, Dealer Service...
- The new clusters in the post-2007 models store the mileage in memory
- This article only applies to Models w/ 0016UZL Built Between 06/23/2014 – 05/11/2020 OR Models w/ 0016UZL...
- This article equips technicians with the knowledge and steps needed to efficiently replace and program...
- New CARB Idle Reduction Change Request
- This tool is designed to compare Diamond Logic feature data across multiple vehicle configuration files
- This document provides guidance for assessing the feasibility of implementing a customer-requested change...
- Engine replacements for all International engines will need to follow this procedure.
- This document will guide the user through a step-by-step procedure for detecting water leaks in vehicle...
- This document provides: Steps to take when switch pack programming fails, or when switch pack disappears...
- This document will guide the user through understanding Prop Shaft Codes and understanding the variations...
- In some geographic areas, ambient temperatures reaching below 15°F (-10 °C), including high levels of...
- Title: Service Portal iKNow Feedback Case Types Applies To: All
- Title: Driveline Information Center and Troubleshooting Procedures Applies To: All Vehicles
- Title: A/C Refrigerant and Oil Capacities Applies To: All current models
- Title: Fan belt replacement guidelines for frayed edges Applies To: All Models
- Title: Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition...
- Title: Steering Gear Seal Repair Guidelines Applies To: Steering gears
- Title: How to Request a Horsepower Quote Applies To: All International and Cummins Electronic engines
- This document reminds technicians of the critical relationship between the truck's suspension and the...
- Applies To: All Navistar Powered Trucks Requesting Engine Emission Label Replacement, Certificate of...
- This article addresses chassis lean conditions on all chassis
- This document is to guide users to eliminate brake pedal rattle noise.
- This document covers battery diagnostics, maintenance and storage requirement.
- This document details the procedure that must be followed to ensure proper alternator troubleshooting.
- Suggested alignment target values when performing a vehicle axle alignment.
- Starter Diagnostics and warranty claim procedure; all engines EXCLUDING Cummins ISB engine with Allison...
- J1939 Data Link Source Address Information
- Rebuilding Cylinder Heads on Certain MaxxForce 11/13, N13, and A26 engines; 2010 to present.
- Diagnosis of chassis wander complaints.
- General Wheel Speed Sensor Troubleshooting
- Certain International® N13 engines may be noncompliant to the required On Board Diagnostics (OBD) Monitor,...
- How to request a horsepower quote; all International and Cummins engines
- J1939 Data Link Troubleshooting
- Snap-On torque wrench requirement for all big bore engine connecting rod bolts; A26, MaxxForce 13, N13 engines
- QLS Emergency Calibration Revert Process
- New air compressor incorporates an oil feed dowel O-ring
- Per agreement with EPA and CARB, Cummins, Inc. provided an emergency calibration for Cummins ISB, B6.7,...
- New Air compressor Incorporates an oil feed dowel O-ring; only models built with MaxxForce 11/13, N13, or...
- Cummins Programming guide and fault codes285 & 265; only vehicles built with Cummins B6.7, X15, or L9 engines
- Starter diagnostics and warranty claim procedure for all engines and all chassis EXCLUDING vehicles...
- Rebuilding cylinder heads on certain EPA 2010 MaxxForce 11/13, N13, and A26 Engines
- Rebuilding Cylinder Heads on Certain International MaxxForce 11/13 engines and all International N13 and...
- QLS Emergency ECM Calibration; only models equipped with Cummins B6.7, X15, L9, or International A26 engines
- QLS Emergency Calibration
- J1939 Data link source address information
- Pico Scope CCOS (Crankcase Separator Test)
- PicoScope Test 5V & 12V Intermittent Open and Short circuit diagnostics
- PicoScope Test
- PicoScope Test for Datalink (CAN) Health Shorts & opens
- PicoScope Test Resistance and Ohmmeter
- PicoScope Wheel Speed Sensor Test
- PicoScope Test One Channel RCT
- Cab water leak trouble shooting tips
- Textured surfaces on painted plastic bumpers, chassis side skirts, and fender extendtions
- Primer recommendation for matching textured panels to smooth panels for field repairs
- Cab water leak troubleshooting tips; HX with steel cab only
- High Pressure Fuel Pump external leaks from weep hole
- QLS Emergency Calibration; Models equipped with 2016 and newer Cummins B6.7, X15 and L9 engines or...
- Power Steering Diagnostics Flow / Pressure Specifications For Power Steering Gears and Power Steering Pumps
- QLS Emergency Calibration; Models with 2016 Cummins ISX, A26 and EPA 2017 and newer Cummins X15, L9, or...
- How to obtain As built parameter list
- New or replacement body control Module (BC,BCM) not detected; Gen 4 BCM
- QLS Emergency Calibration
- Engine Oil Capacities
- Oil leaks at the Bottom of the Oil Filter Module; Only International A26, N13, or 2010 and newer 11 and 13...
- Snap-On torque wrench requirement for all big bore engine connecting rod bolt(s).
- Cab water leak troubleshooting tips
- General wheel speed sensor troubleshooting
- Aftertreatment Clamp Corrosion; Single Can Aftertreatment Systems
- Day cab roof air deflector causing loud vibration noise at highway speed
- Steering Shake, Shimmy, Shudder, Wobble, Steering Vibration; only models built with 14K weight rated axles...
- Suggested alignment target values when performing a vehicle axle alignment
- A26, N13, and 2010 EPA MaxxForce 11 and 13 engine Auxiliary Programable Parameters
- 7095496C3 EGR
- Fuel Filters, Winter Additives, and Blending Fuels for Cummins® Engines
- Cab Lean Concern
- Driveline Information Center and Troubleshooting Procedures
- Repair Procedures for Vehicles Struck by Lightning
- Ambient Air Temperature (AAT) Sensor Faults/Location/Diagnostics
- This document will guide the user through the proper use of the A26 Misfire Detection Session to determine...
- A/C Refrigerant and Oil Capacities
- Radio Diagnostics and Information
- Cleaning and Disinfecting Trucks and Buses
- Bendix EC80 Blank Module Replacement Program;
- MaxxPower No Idle Battery-Powered A/C System Diagnostic Guide; Only sleeper cab models with feature code 16UZL
- Day Cab Roof Air Deflector Vibrates against Cab Roof; only models with P/N 4067947C92 Roof Air Deflector
- Steering Shake, Shimmy, Shudder, Steering Vibration; Only ProStar / LoneStar and LT / RH with 14k front...
- LT / ProStar Fuel Tank Unable to Fill; only sleeper models
- Wind noise at upper side of cab door due to door out of alignment
- The vehicles in this FSC were involved in Safety Recall 18518 which has been completed on these vehicles
- NEW Ultrasonic DEF Head Unit; All SCR vehicles
- Driver Information Display (VIS/DID) screen fails to boot up.
- Steering Shake, Shimmy, Shudder, Steering Vibration
- Oil Capacities; All Electronic International Engines 1994
- Suspension Lean Diagnostics; All models
- SCR Vehicles Setting DEF Quality Faults due to Crossed DEF Tank Coolant Lines or Inverted DEFTHV
- Steering intermittently goes into a shimmy after hitting a bump.
- NEW Ultrasonic DEF Head Unit available; Only models equipped with SCR Aftertreatment.
- Only models built with Cummins X15; Fault Code 7125
- International; HV, HX, LT, MV, RH, LS, ProStar, TranStar, WorkStar; It is possible for an internal clutch...
- NEW Ultrasonic DEF Head Unit; Only vehicles Equipped with SCR
- The First Check to make when Troubleshooting any Body Controller or ESC Issue
- The rear exhaust hanger bracket may crack and over time, may
- Steering Shake, Shimmy, Shudder, or Steering Vibration; only with 14k front weight rated axles and below
- Cab Water Leak Troubleshooting Tips; Excluding 9000i, PayStar(HX), CityStar, or LoadStar
- NEW Ultrasonic DEF Head Unit; only models equipped with SCR Aftertreatment
- Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition Procedure
- ProStar Electrical System Load Shed Feature 08XEV
- Wind noise at upper side of cab door
- Fuller Advantage Series Transmission Power and Ground; only models with A26 or Cummins X15 engines
- Wabco OnGuard Software Update; Only models with 500k baud and Wabco OnGuard with Cummins Engines built...
- Engine software On Board Diagnostic (OBD) issues will be corrected which will aid in engine malfunction...
- Steering Shake, Shimmy, Shudder, Steering Vibration; only models with 14k front weight rated axles and below
- ECA Clutch Departure
- Heavy Duty Clutch May Not Acheive Full Departure
- Brake pedal not returning and sticking slightly in the applied position
- NEW Ultrasonic DEF Head Unit
- ISB Starting System Diagnostics; Only models built with cummins ISB engines
- Brake Lights Staying On
- Programing New Key Fobs
- Eaton Bulletin for their ECA Clutch issue referenced from IK1100033 and IK1100034
- Eaton eca
- Eaton eca
- Body Builder Accessories Backfeeding Ignition Voltage
- Hendrickson Assembly Instructions; Transverse Torque Rods
- Xantrex 1200W Power Inverter Information; only models with feature code 0008XLD
- Cooper Bussmann Inverter Information/Diagnostics; only models with feature code 0008XDM or 0008XDN and...
- Air Pressure Gauges and A/C Pressure Transducer Troubleshooting
- Build to VIN Wiring Harnesses
- Improved Bushings for Hendrickson Torque Rods
- FLR-10
- Body Controller Updates for 500k Baud data link
- Tool Instruction
- The height control valve lower bracket may fail due to fatigue and may result in incorrect ride height and...
- Body Controller Updates for 500k Baud Data link
- Certain LT Series and ProStar trucks equipped with feature codes 0016VKW and 08TSJ (Auto Start / Stop and...
- Wabco OnGuard Software Update; Only 500k baud rate Units with Wabco OnGuard with Cummins Engines built...
- Engine Oil Capacities All Electronic International Engines 1994
- Transmission Stuck In Gear (mis-shift) During 8
- Telematics Installation Guidelines; only Units with 500K Data Link
- Espar Airtronic Heater Diagnostic Guide; only models with Feature code 16VTV
- Fifth Wheel Jaw Unlock; only models with Feature 595BAW or 597017
- Hood Gap and Alignment Tolerances
- Cummins L9 EPA 17 Supplemental Fuel System Diagnostics
- Build to VIN Wiring Harnesses; Axle Configuration: 6x4
- Engine Emission Label Replacement, Certificate of Conformance and Clean Idle Sticker Addition Procedure;...
- SCR Aftertreatment Harness Replacement
- Telematics Installation Guidelines; Only units built with 500K baud rate data link
- Information Display won't boot up
- Heater Hose Chafing; Only models built with N13 engine
- The seat belt assemblies may not satisfy the requirements of FMVSS 210 / CMVSS 213
- Battery Access Door Magnetic Latch Update
- Hadley Smart Valve Troubleshooting Guide
- Auto Start Stop Troubleshooting; only ProStar with feature code 0008TSJ
- Cab Water Leak Troubleshooting Tips; primarily for Sleeper cab models and some aspects may also apply to...
- The fire extinguishers may become clogged or require excessive force to activate
- Updating OnCommand Link with Accelerator
- ISX, N13, and N9 / N10 Aftertreatment Private Data Link Troubleshooting
- Winter Front Usage
- Engine Oil Capacities
- An internal component within the clutch assembly may fail, which in special circumstances could inhibit...
- OnCommand EZ-Tech
- Using Supplier Software to Check DTCs
- Telematic Installation Guidelines; only Units with 500K Data Link
- Trailer Auxiliary Switch Lamp Burning Out; Only Vehicles Equipped with Feature Code 0008TTH or 0008THG
- Exhaust Stack Heat Shield Crack; only models with feature code 07BER
- Fan hub bracket bolts loose or missing; only with fan drive feature code 12THT or 12TKY
- The recalibration will remove engine aftertreatment system faults during reset while ensuring required...
- NEW Ultrasonic DEF Tank Sending Unit; only models with SCR Aftertreatment system.
- During certain geographic conditions the Predictive Cruise Control may revert back to the standard cruise...
- Urea Quality Sensor (UQS) Supplemental Diagnostic and Service Information; only models with SCR...
- HVAC fault 2609-19 with 4th Gen BCM; Only models equipped with 4th generation BCM
- Loose or Missing Glass in the Hood Mounted Mirror
- Auto Start Stop Troubleshooting; only LT and ProStar with feature code 0008TSJ
- Fuel Tank Unable to Fill; only sleeper models
- LT Hydraulic Clutch Diagnostic & Service Information; only models Equipped with a Manual Transmission and...
- Dealer EZ-Tech and Diagnostic Software Support Resource Center
- CPA Injector Misfire Detection; Only models with 2004 thru 2017 International engines.
- OnCommand EZTech
- SCR Vehicles Setting 3363-16 (FC1713) due to Crossed DEF Tank Coolant Lines or Inverted DEFTHV
- Controller Updates for 500k Baud; only vehicles with 500k baud data link
- Urea Quality Sensor (UQS) Boot Order
- Cylinder Performance Analyzer (CPA) Resource Center; Only models with 2004 thru 2017 International engines.
- OnCommand EZ-Tech Download Center
- The transmission TCM may have been programmed incorrectly during vehicle assembly.
- Steering Fluids
- Cooling System Flush Procedure
- Tech Tip to aid technicians in the efficient removal and installation of a TC10 transmission
VIN decoder
See the problems and recalls for an exact car
Buying a used 2018 International Prostar?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history