Check a VIN

Isuzu Rodeo brake failure problems

110 of the 2,474 owner complaints about the Isuzu Rodeo describe brake failure, most of them for the 1998 model year.

owner complaints
110
worst model year
1998
typical mileage
60,517
Is there a fix? There is 1 recall for this area of the car. See below

By model year

What owners say

Filed Jul 9, 2016 · Brakes · 133,000 miles · AZ · crash

I pulled into a handicap parking spot in front of a supermarket, put it in park, set the emergency brake. Got out out vehicle, locked the doors. Started to walk away and a guy that was sitting at a table in front of store yelled there goes your car. I ran beside the car to try to open the door to no avail. The car crashed backwards into another vehicle. The police were called and was told by them to call insurance company and to leave if both vehicles were okay to drive. I feel the park gear failed and the emergency brake failed. This has happened before just in park a couple of months ago.

Filed Mar 2, 2011 · Brakes, Suspension · 91,800 miles · MA

Tl* the contact owns a 2000 isuzu rodeo. The contact was driving 5 MPH and while applying the brakes, the vehicle would not respond. The vehicle was taken to an independent mechanic where it was discovered that the rear shock brackets were rusted and fractured from the vehicle. When the failure occurred, the brackets struck the brake lines and caused a loss of brake fluid and braking power. The mechanic repaired the brake lines but the rusted shock bracket was not repairable. The contact attempted to call both the dealer and manufacturer but was unsuccessful. The failure mileage was 91,800.

Filed Jan 19, 2010 · Brakes · 105,000 miles · MD

I bought a 1998 2wd isuzu rodeo from a private party six months ago. Since I bought it, I have been experiencing a loss of braking capability in some circumstance (every day, mainly when the engine is cold) that resulted in extended stopping distances and continuous illumination of the ABS warning lamp. My garage mechanic told me this issue is due to the ABS coil integrated module that needs to be replaced and that there is a recall on it for 1998-1999 isuzu rodeo vehicles (campaign no. 02i-002, campaign bulletin sb03-09-s001d, the federal safety agency campaign id number: 02i002000). I called two isuzu dealers but they told me there are no open recalls for my vehicle VIN#. I don't understand why my 1998 isuzu rodeo is not included in this recall.

Filed Feb 3, 2009 · Brakes · 107,000 miles · NY

Tl*the contact owns a 1998 isuzu rodeo. While driving 15 MPH, the ABS indicator illuminated periodically. The brakes failed to stop the vehicle when driving over sand or gravel roads. The failure has occurred on four occasions. An independent mechanic inspected the vehicle, but was unable to determine the cause of the failure. The contact was advised that her VIN was included in a recall; however, the manufacturer stated that the closest dealer was in connecticut. The contact lives in new york. A local isuzu dealer stated that they only repaired trucks and could not assist with the recall repair. The VIN was confirmed as a part the federal safety agency campaign id number: 02i002000. The failure mileage was 107,000.

Filed Apr 18, 2006 · Brakes · AZ · crash · 1 injury

Received recall notice for 98 isuzu rodeo contacted bell isuzu was told the part was not available at the time called back several times,was pulling in driveway brakes went all the way to the floor smashed into bedroom of roommate. Called isuzu they replaced part then said it had nothing to do with my brakes. Said they tested my brake fluid it was contaminated, and that I needed a new master cylinder. The part replaced directly affected the ABS brake system from working properly they believe its not failure from this ABS module, aligortham thank you for your time.

Filed Dec 12, 2005 · Brakes · 90,000 miles · RI · crash · 1 injury

Dt: the contact states there is the federal safety agency recall campaign 021002000 concerning the anti lock brakes. The parts needed to repair the vehicle are not available at the local dealership. She spoken to the manufacturer who confirmed the parts were not available. The contact's son was in an accident due to brake failure. The other driver was injured. A police report was taken at the scene.

Filed Nov 7, 2005 · Brakes · 101,905 miles · TX · crash · 1 injury

Dt: thecontact was driving on the freeway and had blow out. She applied the brakes which were under manufacturer's recal 02i-002. There where no brakes. This resulted in a crash. The contact sustained injuries.

Filed Oct 6, 2005 · Brakes · 96,000 miles · PA · crash

Dt: the consumer complained about an ABS brake problem. The brakes did not hold. The ABS light came on since june of 2005. On july 15, 2005 the brakes failed, causing consumer's vehicle to lightly hit another vehicle. No police report was taken.. When she took vehicle to the dealership , they cleaned the ABS sensor because it was corroded. The ABS light went off, and the brakes worked fine until september 29. 2005, and it almost caused another accident. After she took it to the dealer to be checked again, they said that it was a problem with the ABS.

Filed Sep 6, 2005 · Brakes · 74,264 miles · MO

Driver side front brake pads sheared clear of the clips, jammed the rotor to where it could not be turned by hand, broke the seals on the caliper pistons releasing brake fluid. *jb result was a driver side tire that was locked up almost to the point of skidding and no brakes. The vehicle traveled less than 2 miles from the time the problem was first noticed (a strange sound) to the point at which there were no brakes. Also, no brake warning light was ever seen by the driver. Topped off the brake reservoir, pumped the brakes about 6 times until reservoir was back down to "add" and still no brake warning light visible on the dash.

Filed Jun 22, 2005 · Brakes · 10,000 miles · PA · crash

As I was attempting to merge onto a highway exit ramp, I applied the brakes with what was typical force for such conditions. The road was wet and as I was braking, the vehicle went over an expansion joint in the overpass of the road. The brake pedal went to the floor, the wheels locked up, and the vehicle skidded, using excessive braking distance, thus resulting in a low-speed rear-end accident with the vehicle in front of me. Little damage was done to the other vehicle; however, the front bumper of my vehicle, a 1999 isuzu rodeo was pushed back. I now find out that isuzu has issued a safety recall for the ABS, which is responsible for this accident and the resulting damage to my vehicle. The damage has never been repaired. I would like isuzu, as a part of its recall campaign to repair the damage to the front bumper, free of charge.

Related recalls

Service brakes, hydraulic: brake fluid low warning: lampReported October 10, 2003 · 55 vehicles affected
What is wrong
Certain sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 101, "controls and displays." the brake warning lamp would not illuminate in the event of decreased brake fluid volume.
Remedy
The diodes have been replaced. All vehicles have been repaired.

Recall number 03V390000 · Recall details

Questions about the Isuzu Rodeo brake failure

Which Isuzu Rodeo years have brake failure problems?

The model years with the most reports are 1998 (52 complaints), 1999 (32 complaints) and 2000 (9 complaints).

VIN decoder

See the problems and recalls for an exact car

Buying a used Isuzu Rodeo?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history