Tl* the contact owns a 2008 jeep commander. The contact stated that the check engine light illuminated on the warning panel. The dealer replaced the spark plugs, fuel injectors and two cell packs. Immediately following the repairs, while driving 55 MPH, the vehicle stalled and all of the warning lights illuminated on the instrument panel. The contact was able to maneuver the vehicle onto the emergency lane and shut off the engine. After restarting the engine, the vehicle would operate normally for the approximately 2 to 5 miles and the failure would persist. The dealer replaced the solenoids, cell packs and the central computer (cpu). When the dealer test drove the vehicle, it stalled again. The vehicle was left in possession of the dealer in an attempt to determine the cause of and remedy for the failure. The failure and current mileages were 30,900. Updated 07/21/10.
2008 Jeep Commander engine complaints
Page 4 of 4: complaints 71 to 73 of 73, newest first, as owners wrote them.
Tl*the contact owns a 2008 jeep commander. While driving between 5-25 MPH, the engine jerked when the gears were shifted. The dealer performed a diagnostic and found multiple failures with the vehicle. The manufacturer will be notified. The contact felt that the vehicle was unsafe to drive because it could cause the vehicle to shut off while driving at a high rate of speed. The VIN was unknown. The current mileage was 16,800 and failure mileage was 16,000.
2008 jeep commander under powered in acceleration. Consumer states that the vehicle would not accelerate fast enough in case of an emergency. Dealer told consumer he would get a call from an engineer she has yet to receive one. *kb the consumer stated the engine was inadequate.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2008 Jeep Commander?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history