Clutch overheated and cause an immense amount of smoke during drive with no warning indication from hud. Dealer stated that clutch has gotten well passed 390°c Heat from clutch has also caused front driver caliper to lock up and damage rotors.
2020 Jeep Gladiator brakes problems
18 complaints (4% of all complaints for this car). Typical mileage when it fails: 4,000. 6 crashes reported.
- owner complaints
- 18
- of this car's complaints
- 4%
- typical mileage
- 4,000
- crashes
- 6
- recalls
- 0
Which part fails
- Disc: caliper1
At what mileage
Complaints by mileage at the time of the problem.
Jeep Gladiator brakes problems in other years
Specific symptoms reported on the 2020 Jeep Gladiator brakes
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
No recalls on record for this model year.
What 2020 Jeep Gladiator owners say
Most recent owner complaints, unedited.
My Jeep Gladiator has recently been having multiple random error messages popping up. ABS warning, service 4WD, service shifter, traction control and others. Dealership charged $200 to diag a bad ABS module and charged $1400 to replace the module and controller. Less than 24 hrs later same issue occurred . Doing my own research this seems to be a common issue not just with Gladiators but other Jeeps as well. Many forums are saying it’s bad wire connectors or broken wires from improper initial installation. Causes issues with speed control, braking, and power steering.
Driver side rear wheel speed sensor. This is a known issue national back order on the part, mechanic installed new part system does not reset and clear. In the current state, abs offline four-wheel drive system service required traction control service required. What is the true fix for this?
The contact owns a 2020 Jeep Gladiator. The contact stated that while driving at approximately 40 MPH, the vehicle had suddenly started to vibrate and shake. The contact stated that the vehicle was maintaining its lane but was lurching from left to right. No warnings illuminated. The contact stated that she pulled off to the side of the road; however, when she turned the vehicle on, it would start shaking again. The contact stated that she would keep driving while the vehicle was shaking, and the shaking would eventually stop. The contact stated that the shaking was occurring at any speed and was also triggered when she would drive over any small bumps or dips in the road. The contact stated recently, while she was driving in traffic at approximately 10 MPH, the vehicle started to shake again, however, this time violently. The contact stated that at the time, it was raining. The contact stated that it felt like the vehicle had lifted up, and then she crashed into the guard rail on the driver's side front bumper. The contact stated that the bumper and an LED light bar attached to the front grill had made contact and were slightly damaged, and the driver's side headlight stopped functioning. The police were not called, and the contact was not injured. The contact reported that the driver's side front air bag had deployed but had not inflated and was draped on her lap. The contact had not taken the vehicle to a local dealer or independent mechanic. The vehicle was not diagnosed and was not repaired. The contact reported that after the crash, she observed the check oil and check brake warnings illuminated. The contact stated that she needed to depress the brake pedal with more force in order to stop. The manufacturer was not informed of the failure. The failure mileage was approximately 109,000.
During normal driving, dash would display multiple warning lights. There would be traction control, ABS inactive, and transmission errors displayed on the screen. Twice, there was a loss of power steering while driving. All signs pointed to a CAN buss issue, but dealer could not/ would not find it. Doing research, I found that the CAN buss connector located behind the glove compartment was known in the Jeep community to fail and cause these symptoms. The only replacement is offered by Mopar/Stellantis. Multiple models and makes under Stellantis company use this same connector that has bad solder connections inside. It causes increased resistance inside the connector, and causes CAN buss communication errors, and setting any one of hundreds of possible DTC. In every occasion, there was a loss of stability control, ABS, and multiple occasions of vehicle being locked in Park. In two occasions, the electric assist power steering was disabled.
Loss speedometer and all dash gauges. Known problem on Forums; however NO TSB or Recall to fix issue. Plethora of CEL codes to include causing speed to not display on digital or analog indicators.
While driving several warnings lights illuminate: traction control, ABS, air bad, service 4 wd, and brake. When this happens power steering is lost making it extremely hard to steer the car. The brakes are automatically engaged and occasionally the windshield wiper turns on. This causes a risk not only to myself and passengers but anyone driving near me as I can no longer steer with ease and the brakes lock up. My Gladiator has been at the Jeep dealer for 10 weeks while they try to solve the problem. They replaced the ABS module but that didn't solve the issue. I'm told that its electrical and whatever it is will harm several systems. My wife's 2018 Jeep Wrangler JL has the exact same issues. She has a very hard time controlling it due to no power steering.
I was driving at about 5 MPH and about to go onto the Freeway on ramp in Riverside, California, when the sensor in my car went off and locked the brakes, causing the person behind me to rear-end me. This is not the first time this has happened with this vehicle. Luckily, I was not injured, however, this could have been a serious injury if I was traveling at a higher speed or under many other circumstances.
The contact owns a 2020 Jeep Gladiator. The contact stated while driving 30 MPH, he heard a scraping sound inside the vehicle. The contact then stated that while he pulled into a service station, the brake pad and caliper bracket assembly detached and got caught in the rear passenger’s side wheel, causing the tire to be punctured. There was no warning light illuminated. The vehicle was towed to the dealer but was not diagnosed or repaired. The manufacturer was notified of the failure and the contact was provided a case number, but no further assistance was provided. The failure mileage was approximately 33,000.
Center rear brake light failed. Detected 18 months after purchase.
Questions about the 2020 Jeep Gladiator brakes
Does the 2020 Jeep Gladiator have brakes problems?
Owners have filed 18 complaints about the brakes of the 2020 Jeep Gladiator, 4% of all its complaints.
At what mileage do 2020 Jeep Gladiator brakes problems start?
The typical (median) mileage in owner complaints is 4,000 miles.
Was there a recall on the 2020 Jeep Gladiator brakes?
There is no recall for this problem on this model year.
What year does the Jeep Gladiator have bad brakes?
The Jeep Gladiator model years with the most brakes complaints are 2020 (18 complaints) and 2021 (17 complaints).
Other 2020 Jeep Gladiator problems
Electrical 183Steering 182Transmission 55Engine 46Suspension 32Visibility 23Acceleration 11Body 11Lights 11Driver assistance 10Fuel system 9Airbags 3Seat belts 3Wheels 2
VIN decoder
See the problems and recalls for an exact car
Buying a used 2020 Jeep Gladiator?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history