1. Front upper and lower control arms are not functioning as they supposed to. If there is a small bump in the road this SUV vihecle got hit strongly. Bolts are out of order too. On motion makes lots of noise and squeezing sounds as well. 2. Internal elecrical wiring has some issues. The front ceiling light gets on and off on its own. The aircontioner LED light as well.
2006 Jeep Liberty electrical complaints
Page 2 of 6: complaints 11 to 40 of 147, newest first, as owners wrote them.
I was on the highway came to a stop at a traffic light the jeep stalled and would not restart (no crank, no start). The traffic light was on a incline of a hill, the jeep was too heavy for one person to push up, and rolling backwards into oncoming 60+MPH traffic was not a option. A group of good citizens helped push the jeep to safety. Battery was fully charged, but security light was on, preventing a restart. In addition when the key is turn to the start position the check engine light does not light up as normal. Plus ECM is not connecting to the scan tool. Scan tool displays connection error. The ECM failed. Before the failure the jeep ran perfect.
Tl* the contact owns a 2006 jeep liberty. The key seized in the ignition happened when the vehicle was parked at home the shifter cable fractured the contact stated that on several occasions after the vehicle was parked with the gear shift lever in the park position, the contact was unable to remove the key. The vehicle was not taken to be diagnosed. Simi valley chrysler dodge jeep ram located at 2350 first st, simi valley, ca 93065, (805) 581-9090 was contacted by phone for an estimate on the cost of the part for the shifter cable. The vehicle was not repaired. The manufactured was contacted and notified of the failure. The approximate failure mileage was 137,000. Piir=y.
2006 jeep liberty. The rod linking between the key side of the ignition and the switch is broken. I have seen enough complaints online of the same year model to know this is a common failure that should be a recall. Also, the rod is not available, only the entire column and it is very expensive.
Tl* the contact owns a 2006 jeep liberty. The contact stated that the ignition switch failed to turn over to start the vehicle. The failure was intermittent and occurred several times. The vehicle was not diagnosed by a dealer. The vehicle was taken to an independent mechanic who replaced the ignition switch, however, the failure continued. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 141,000.
1) front driver window regulator failed. 2) front passenger door armrest detached when closing the door.
3 out of the 4 window regulators in my jeep have mechanically broken inside the door. This needs to be addressed. It's not a cheap fix for me to keep paying for your mistake. I was going to buy another jeep, but not so sure anymore
There is only one window that will come down and it's the front driver side, they all came down and would not come back up. I replaced a regulator in the right back window and it went again so I just had them all pinned up. I've also had to replace the AC compressor twice and just put in 07/06/2018. I had to have a transmission put in 3 years ago. And now the truck is just shutting down when I come to a stop but it will start back up. I had a diagnosis test done and it didn't show any problems, but it's still shutting down and I don't know why. The mechanic said it is probably something electrical or has to do with the computer.
Tl* the contact owns a 2006 jeep liberty. The contact stated that the vehicle failed to start and the key was unable to be removed from the ignition. The contact also mentioned that the gear shifter was able to shift to neutral without starting the vehicle. The contact called tyson chrysler jeep dodge (1 sw frontage rd, shorewood, il 60404, (815) 741-5530) and was informed that the VIN was not included in any recalls. The vehicle was not diagnosed or repaired by the dealer or an independent mechanic. The manufacturer was made aware of the failure and informed the contact that the VIN was not included in any recalls. The failure mileage was 120,000.
Both rear window motors have failed. The windows slide down into the doors stationary, and or driving.
My jeep was part of a recall in 2012. The drivers side rear window wouldn't go up or down. L-27 rear control arms were replaced. 02-l2-71-82 rear control arms and cbfzl270aa arm lower control. The same thing happed recently, but on the passenger side rear. Can you help me get the window fixed as part of the recall in 2012?
Since I brought the car in 2008 at times the interior dash light and head lights flicker also the air bag light all the sudden stays on. I have intermediate no start at this time so I can't really use the car. I believe this might be an electronic issue.
Tl* the contact owns a 2006 jeep liberty. The contact stated that the park safety cable would not allow the key to be removed from the ignition without warning. Also, the contact had to place her finger under the console to push the switch that allowed the key to be released. The contact also mentioned that the gear easily shifted into neutral. The vehicle was taken to a dealer, but was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 40,000. Updated 10/26/16*lj
Yesterday, the rear passenger window slid into door, will not come up. Can hear regulator but window is stuck in door. Vehicle was parked on a residential street, all windows were up, and about 20 minutes later the window had disappeared into the door. I called chrysler but the VIN is not part of chrysler's notice to owner's in 2010 regarding faulty window regulators.
Tl* the contact owns a 2006 jeep liberty. The contact stated that the vehicle experienced a complete loss of power when coming to a stop. The failure occurred without warning. The vehicle was taken to the dealer where it was diagnosed that the intake air control sensor and idle control sensor needed to be replaced. The vehicle was repaired however, the failure recurred. The failure mileage was 45,000. The VIN was not available.
Went to start smoke came out from dash was parked in gargage truck is still in shop ins told me only reason they woul d cover is because is was a long coustomer thy only gave me 883 to repair there are at least 14 codes due to this don't know if they will reset if not I have to pay for repairs I do have fire protection on truck this is allstate I will send paper work if needed at a later date I have none also waiting for check told for me to pay repair shop
My 2006 jeep liberty will not start or crank. The computer does not show any codes. The battery had power, the relays are fine and the starter is fine. When you are in the jeep and try to start it, it does nothing. Its like you forgot and left it out of park and tried to start it. The jeep does not click or even attempt to start. No one seems to know what's wrong with it. I love my jeep and it had been well taken care of. I have had numerous issues, and recalls. I still love my little liberty. If you could just help with a diagnosis, I would be forever grateful!
2006 jeep liberty clockspring malfunction. Contact with dealership yielded info that no replacement part is available, yet the car is rendered unsafe without the replacement of malfunctioning part. Owners have to decide whether to drive unsafely or park it until the part is available, which most people cannot afford to do. This is a widespread problem that chrysler is not addressing.
Ignition, key fell out of ignition as I was driving down the road, I put key back in ignition and had no response to shutting vehicle off, key just went back & forth sloppy couldn't shut engine of! I actually had to take battery cables off to shut off engine? Jeep ran and drove fine but had no ignition control on stopping or starting? Cost me a new steering column to fix the problem! Didn't even make 1 payment on truck when this happened.
Tl* the contact owns a 2006 jeep liberty. While driving 65 MPH, the rear driver side window independently rolled downwards and failed to roll back up. In addition, the rear passenger side window rolled down independently and failed to roll back up. The vehicle was taken to a dealer where it was diagnosed that the actuators needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 82,000.
Jeep would not start -had lights, radio, horn etc. But it would not turn over at all. Towed to dealer. Tech performed diagnosis and found the problem - steering column had to be replaced. Total cost $798.00. I was told that the steering column and ignition switch were problem issues in this make and model but no recall was in place to repair. Ignition switch recall replace in 2006 jeep liberty manual transmission but not in automatic transmission
Tl* the contact owns a 2006 jeep liberty. After rolling the power window down and attempting to roll it back up, the power window switch failed. The contact mentioned that the failure recurred several times. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was 30,506.
Abs system goes out which in turn makes the cruise control go out. Then when you use the vehicle again the ABS is on so is the cruise control but the brakes don't work well and grab. Then when you are using the lights at night it dims for no reason inside and out. Still waiting on the fix for the rear end fuel tank issue
Tl* the contact owns a 2006 jeep liberty. The contact received notification of the federal safety agency campaign number: 14v438000 (electrical system); however, the part to do the repair was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The contact stated that the vehicle stalled numerous times while driving. The failure mileage was unknown.
Tl* the contact owns a 2006 jeep liberty. The contact stated that upon entering the vehicle, the contact noticed that the rear windows were open and would not close when prompted. The contact mentioned that he had to replace the motors on all four windows twice. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 22,022.
My car was parked in my driveway, not moved or in use and the back left windows mechanism fail to work window wouldn't go up or down window did not stay up while driving keep falling down. Replaced the part. Parked car in my garage started to use the car again after bringing it in to dealer for two recalls to be done spending over 500 dollars changing all the fluids buying a brad new battery drove car every day since august 21,2015 car has 358 miles at this date august 28 2015 the back right windows mechanism doesn't work just like the previeus time. Car its like brand new and the two rear windows have stopped working. Can you let me know if other people had this problem. Thanks
Tl* the contact owns a 2006 jeep liberty. When the key was removed from the ignition, the engine continued to run. The contact placed the key in the ignition to the on position and then back to off to finally shut off the engine. The failure recurred multiple times. The vehicle was not diagnosed or repaired. The contact stated that when the key was placed in the ignition to the on position, the engine failed to turn over, however, all the electrical functions continued to run. The contact removed the battery to shut down the electrical functions. The manufacturer was made aware of the failure. The approximate failure mileage was 65,000.
Tl* the contact owns a 2006 jeep liberty. While driving at an unknown speed, the brake, check engine, and anti skid warning lights illuminated. In addition, the cruise control feature was activated, but failed to function. The vehicle was taken to a dealer where it was diagnosed that the clock spring needed to be replaced. The vehicle was not repaired due to the part not being available. The manufacturer was not notified of the failure. The failure mileage was 125,000. Updated 09/21/15*lj updated 12/12/2017
Tl* the contact owns a 2006 jeep liberty. While driving at 5 MPH, the driver side window failed to roll up and remained in the down position. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was 124,564.
1) as spring arrived I rolled down the windows and there is a noise which sounds like card board flapping as wheel turns. 2) during the winter while driving slow over speed bumps it sounded like rusty springs. 3) another on/off problem - when I park; and turn key to off it pass off position to acc position.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2006 Jeep Liberty?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history