My friend and I just finished having lunch at restaurant. It was snowing really bad, I brushed snow off and I pressed the left passenger button to let window down so that I can see and the window would not come back up. My friend and I got out of the jeep and pushed window up with our hand. But when I drive it falls down, really bad during the summer time. Driving to work one day and the esp, bas and tcs light all come on. Eventually went off but after 4 mins lights came back on.
2006 Jeep Liberty lights complaints
Page 2 of 2: complaints 11 to 19 of 19, newest first, as owners wrote them.
Check engine light on and off
Tl* the contact owns a 2006 jeep liberty 4x4. The contact stated while driving approximately 35 MPH at night, a clicking sound emitted inside of the vehicle and the headlights began to illuminate intermittently. The failure recurred twice a week on average. The vehicle was taken to an authorized dealer where the headlight assembly switch was replaced. The failure continued after the repair was performed. The current failure was not repaired because the service warranty expired. The manufacturer was not made aware of the problem. The approximate failure mileage was 80,000.
Tl* the contact owns a 2006 jeep liberty. The contact stated that while driving 20 MPH, the vehicle emitted a rubber burning smell from the tail lights. The vehicle was taken to the dealer who advised that the cause of the failure was electrical wires from the tail lights. The vehicle was not repaired. Both of the tail lights remained burned. The manufacturer was not notified. The failure mileage was 54,000 and the current mileage was 55,000.
Both taillights melted. The inside cover around the bulb melted onto the bulb. The outside cover melted to be concave in shape. I removed the melted inside pieces and replaced the bulbs. I later cracked the right taillight and replaced it. The outside cover of the new right taillight has melted to be concave but still works. In may of 2011 the left taillight brake light bulb was out. I replaced the bulb but it did not work. I replaced the socket and it still didn't work because it was melted so bad. I finally ended up replacing the taillight. The parts guy said there was a notation that if you were replacing the taillight because it melted this new taillight was much better. So, they know the taillights melt but are unwilling to pay for the replacement.
My rear tail lights and stop lights bulbs keep burniging out. The rear passenger housing has been replaced free by the dealer. Since then I have had to replace the same housing in less than two years. The rear tail lamp and brake lamp bulbs do not burn the filament the light bulbs actually explode inside the housing or melt the housing. The plugs that hold the bulbs are scorched. I have both the rear lamp and plugs to show the defect. I am not the isolated case: most liberty owners and some grand cherokee owners have had the same problems. My second complaint is a fuel leak at the connection of the fuel heating element. The filter head where the fuel filter is attached also has a heating elemnt.. The electic plug connection at the head leaked fuel onto the connection. I observed when the ignition was tuned on, the fuel leaked and vaporize as it was being shorted and heated. I disconnected the electric plug., filled the female receptacle with fuel tank epoxy and rubber plug for good measure. Will be replacing scorched connection and filter head as soon as possible. I will keep all defective parts for your inspecton upon your request thank you.
Left tail light burned out and melted the tail light. It continues to go out and is a safety problem.
I have had multiple problems related to the back lights on my 2006 jeep liberty renegade 4x4 vehicle. I purchased the car new with no miles on it. Recently, the gas pump was leaking and a valve was installed to stop the oil from leaking. The back light rack had to be replaced twice in two months. The back lights have gone out numerous of times.
Dt*: the contact stated after having a dvd player installed in the vehicle by the dealer, leaking occurred between the driver and passenger side seats while parked or in motion consistently after or during a rain storm. The leaking created mold and the vehicle was taken to the dealer on four separate occasions but could not find the source of the problem. The manufacturer was contacted and expressed that the dealership needed to repair the vehicle. The water damage was covered under warranty. The contact received a letter from the manufacturer that stated that there was nothing more the dealer or manufacturer could do. The vehicle was not driven since the incident due to mold infestation. The dealer and manufacture refused to provide additional assistance.*ak 08/29/06 plastic trim piece on dash up by windshield popping up on passenger side. Map light lens coming out and dome light replaced.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2006 Jeep Liberty?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history