The contact owns a 2016 Jeep Patriot. The contact stated that while driving at slow speeds through an intersection, the steering and brakes became inoperable. The accelerator pedal was depressed, but the vehicle failed to respond. The contact was able to pull into a parking lot. The vehicle was restarted. The vehicle was towed to an independent mechanic who determined that the vehicle was operating as designed. Upon research, the contact located similar failures related to the vehicle going into LIMP Mode and electrical issues. The contact was concerned about driving the vehicle. The local dealer was contacted, and the failure was acknowledged. The dealer informed the contact that a diagnostic test was needed; however, the vehicle was not diagnosed or repaired. The manufacturer was contacted and suggested that the vehicle be towed to the dealer. The manufacturer confirmed that the VIN was not under recall. The failure mileage was approximately 68,000.
Jeep Patriot won't shift problems
42 of the 2,793 owner complaints about the Jeep Patriot describe stuck in gear or won't shift, most of them for the 2015 model year.
- owner complaints
- 42
- worst model year
- 2015
- typical mileage
- 68,000
By model year
Often reported together
Check engine light 12Stalling 6Transmission failure 3Overheating 3Loss of power 2Jerking 2CVT failure 2Wipers 1
Trouble codes mentioned
U0401 1P2173 1P0777 1P0741 1P0730 1P0339 1
What owners say
I am submitting this complaint regarding the CVT (Continuously Variable Transmission) failure in our Jeep vehicle. We have experienced intermittent transmission issues throughout our entire period of ownership. The CVT has now completely failed—the vehicle will not shift out of low gear. The RPMs surge rapidly, and although the vehicle will move at very low speeds if you ease off the accelerator, it will not reach normal driving speeds, making it unsafe and unusable for daily travel. The check engine light is on, and diagnostic codes confirm a CVT-related issue. The vehicle originally came with a lifetime powertrain warranty. We complied with the required inspection and maintenance schedule, except for the most recent inspection, which we missed due to a personal hardship. Jeep initially sent reminders for these inspections but eventually stopped, and we received no notice of the upcoming deadline. The vehicle has been regularly maintained by a trusted local repair shop. Despite this, it is now undriveable. From both our personal experience and broader consumer reports, it’s clear that these types of CVT failures are common among Jeep vehicles. Jeep has refused to honor the warranty, stating it could only be reinstated if we paid for the repairs ourselves within a specific timeframe—which has now passed. This policy places an unreasonable burden on the consumer, especially for a known and recurring mechanical issue. We believe Jeep is failing to take responsibility for a serious safety and performance defect. I respectfully ask the federal safety agency to investigate this matter further and evaluate whether broader action—such as a recall—is warranted.
On several different occasions my car has stalled in traffic and idled down for I couldn't drive had to pull over and turn it off and turn it back on to go again the check engine light then stability light will come on. Camshaft code I have fixed the cam and crankshaft sensors first time then it failed again so I changed them a second time now it's failed again .I almost got rear-ended a couple times very dangerous. Now my step button on the steering wheel and the horn quit working all of a sudden. I found out on the site of mopar that it is the electrical connector and terminal both cam sensors and crank sensors on certain vin numbers,all 2016 jeep patriots should have been included as others are having the same issues. I cannot afford to keep on putting money into this problem. This can be confirmed by my mechanic which replaced it twice. The dates this has happened are April 2023 worked for awhile then February 2024 happened again changed cam and crank sensors again. April 16 started failing again, limp mode have to pull over turn engine off turn it back on to go again. Every week at first now every few days. Engine light then traction stability light can't go over 10 miles per hour, pull over turn engine off turn it back on stability light goes off but engine light stays on for a day goes off the next day. I do not feel safe driving long distance anywhere and this can wear down your engine and vehicle life. I bought this car paid a lot of money for it for the comfort of knowing I would have something Dependable in my old age and can not keep on putting money into a problem that should have been on the recall list also. It only has 115,000 miles on it. I'm going to the Jeep dealer next week to see if Mopar can resolve this and pay for this issue. Also this happens if you're going 1 to 55 miles per hour reverse or forward doesn't matter.
While driving the vehicle will randomly, without warning or any dash notification icons alerted, turn off engine- radio, lights, a/c everything else is still on but engine is off. This occurred 4 times in less than a 2 mile distance without any check engine or notification lights on the dash before, during, or after the event. This issue originally started about a week ago, when the check engine and throttle system notification icons came on, followed immediately by the car going into what seemed to be limp mode. Car was towed to the jeep dealership, they said issue was the battery and that an oil change was needed. Had issues addressed took the car how two days later, same issue occurred again. While driving same two icons suddenly came on then car went immediately into limp mode and was not driveable. Took the car back to the jeep dealer, they took a few days to drive it and stated it was the fuel throttle body that needed to be replaced. Had the part replaced and the car drove as normal, no icons on dash after the repair, next morning same issue occurred again while driving, icons come on dash, immediately car goes into limp mode. Circling back to the biggest concern, is I’ve found large amounts of owners having the exact same if not oddly similar issues with varying years of the jeep patriots. Many are reporting my reason for this report in that suddenly after Jeep dealers require all these repairs they’re experiencing the engine completely shutting off WHILE DRIVING. This is incredibly dangerous and I’m concerned as to why there A. Isn’t a repair for this common issue in these models, and B. Why a recall hasn’t been submitted for the most dangerous scenario where many owners are having their cars engines shut down while driving, and some at high speeds. This is incredibly dangerous and frustrating that our safety has not been addressed when online there are years worth of forums for these issues without resolution.
Driving normal when i lost control of the throttle jeep went into limp mode, the ETC , traction control, and check engine lights came on, got a uo4o1 code, if i was on the interstate could have been bad when it went into limp mode, the electronic throttle control was bad
Lightning bolt symbol, check engine light and traction control lights came on and vehicle went into limp mode while taking my 3 yr old to pre school. Scans say vacuum leak/throttle body. This is a recurrent problem with these cars and has had recalls on certain ones. Almost didnt make it where i was going. . . Needs to be addresses on this model too. My car only has 76,721 miles.
Over the past year, the car has had 4 crank position sensors, new pig tails/connectors on the wire harness, a new throttle body, and a new MCM. The Jeep will randomly shut off without warning either at stoplights/traffic or on the highway at speed. While at speed, the car will "restart" itself, but if it stalls while stagnant a manual restart is necessary. When the stalling occurs, warning lights do not appear on the dash. Lately, however; the crank position code P0339 has come up with the check engine light. I recently experienced a crank position sensor code followed by a cylinder 3 misfire which caused the car to go into limp mode. Once I replaced the MCM, the misfire went away. Most recently (today) the car stalled in the middle of an intersection while making a left turn; my [XXX] son was in the car with me. Since it was a stop light, the car was able to be restarted in time, but had it been a stop sign/non-stop oncoming traffic, the situation could have been much worse. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
For the last 3-4 months my Jeep has been going into limp mode while in motion, sometimes at high speeds. There seems to be no pattern anymore and I’ve replaced the parts mechanics have suggested.
On 5 occasions at various speeds and types of roads, my vehicle suddenly goes into limp mode, the engine shuts off and power steering goes out. I have very limited time and control to move off the road before the car behind me slams into me. The majority of the instances this has happened, the orange anti-skid light comes on though road conditions were fine. I found a recall of 2016 Jeep Patriots (s89/the federal safety agency 16-v-907 Crankshaft/Camshaft Sensor Wire Harness) and many complaints I've found experiencing the same thing I experienced were included in this recall. Mechanic ran my Jeep's code and it showed a number of things were triggered but he couldn't pinpoint what exactly could be the cause based on the code errors. I have a young child in a car seat in the back of my car and feel extremely unsafe taking her anywhere, let alone when it's just me in the car. Please consider adding the 2015 Patriot to this recall.
The throttle body goes out every few months. The vehicle will suddenly go into limp mode while driving. This is dangerous as it rapidly decelerates in traffic!
Related recalls
Power train: automatic transmission: control module (TCM/PCM/tecm)
- What is wrong
- Chrysler is recalling 712 my 2009 sebring, dodge caliber, avenger, journey, jeep patriot, and compass vehicles. A new adhesive used in the power train control module (PCM) manufacturing process can cause the printed circuit board to break.
- Risk
- This can cause the engine to stall and cause a crash without warning.
- Remedy
- Dealers will replace the PCM free of charge. The recall began on november 10, 2008. Owners may contact chrysler at 1‑800‑853‑1403.
Recall number 08V528000 · Recall details
Questions about the Jeep Patriot won't shift
Which Jeep Patriot years have stuck in gear or won't shift problems?
The model years with the most reports are 2015 (10 complaints), 2014 (9 complaints) and 2016 (9 complaints).
VIN decoder
See the problems and recalls for an exact car
Buying a used Jeep Patriot?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history