2016 Jeep Wrangler transmission complaints

Filed May 17, 2016 · Engine, Transmission · NY

2016 jeep wrangler. Consumer writes in regards to engine warning light on dashboard, engine noises and no acceleration when gas pedal is depressed issues. *smd the consumer stated when her husband drove the vehicle, the engine light did not illuminate. However he did have to push the accelerator pedal more than usual. Two weeks later, while driving at a speed of 40-45 MPH, the consumer heard a loud noise and noticed the RPM was at 5,000 and going to 6,000. The vehicle was shaking and the engine was making loud grinding noises. The consumer took the vehicle to the dealer. They stated there was nothing wrong with the vehicle. Two weeks later, as before, the engine became loud, the RPM went to 5,000 and for the second time, the number 1 surrounded by a square lit up on the dash board after the letter d. The vehicle only reached a speed of 10-15 MPH.

Filed May 2, 2016 · Transmission · 725 miles · IN

Tl* the contact owns a 2016 jeep wrangler. The contact stated that while attempting to accelerate at 15 MPH, the vehicle became stuck in low gear without warning. The vehicle was taken to a dealer however, the failure was undetermined. The vehicle was not repaired. The contact mentioned that the failure recurred three times. The manufacturer was notified of the failure. The failure mileage was 725.

Filed Mar 16, 2016 · Engine, Transmission · 20,000 miles · TN

I have a 2016 jeep wrangler unlimited with 20,000 miles., today I was going up a hill stopped at a mailbox then started to take off and the motor stalled while in drive. It cased me to roll back about 3' befor I could hit the brake almost caused a accident. I then restarted the jeep placed it back in drive and it wouldn't move! It acted like it was in neutral. I also tried reverse still wouldn't do nothing. So I rolled to a flat spot in the road check the trans fluid, it was good then turned it of checked the oil, it was good to. Then started it back up and put it in drive and it was working fine again!

Filed Mar 16, 2016 · Engine, Fuel system · TN

I have a 2016 jeep wrangler unlimited with 20,000 miles., today I was going up a hill stopped at a mailbox then started to take off and the motor stalled while in drive. It cased me to roll back about 3' befor I could hit the brake almost caused a accident. I then restarted the jeep placed it back in drive and it wouldn't move! It acted like it was in neutral. I also tried reverse still wouldn't do nothing. So I rolled to a flat spot in the road check the trans fluid, it was good then turned it of checked the oil, it was good to. Then started it back up and put it in drive and it was working fine again!